Home
last modified time | relevance | path

Searched refs:IDE (Results 1 – 25 of 97) sorted by relevance

1234

/linux-2.6.39/arch/h8300/
DKconfig.ide1 # uClinux H8/300 Target Board Selection Menu (IDE)
4 menu "IDE Extra configuration"
7 hex "IDE register base address"
8 depends on IDE
11 IDE registers base address
14 hex "IDE register alternate address"
15 depends on IDE
18 IDE alternate registers address
21 int "IDE IRQ no"
22 depends on IDE
[all …]
/linux-2.6.39/drivers/ide/
DKconfig2 # IDE ATA ATAPI Block device driver configuration
5 # Select HAVE_IDE if IDE is supported
9 menuconfig IDE config
14 If you say Y here, your kernel will be able to manage ATA/(E)IDE and
15 ATAPI units. The most common cases are IDE hard drives and ATAPI
30 if IDE
32 comment "Please see Documentation/ide/ide.txt for help/info on IDE drives"
58 The IDE driver (which you are currently configuring) supports
62 this config option enables the IDE driver's SATA support.
64 supports SATA controllers, and this (IDE) driver supports
[all …]
/linux-2.6.39/Documentation/m68k/
DREADME.buddha2 The Amiga Buddha and Catweasel IDE Driver (part of ide.c) was written by
7 Register map of the Buddha IDE controller and the
44 $800-$8ff IDE-Select 0 (Port 0, Register set 0)
46 $900-$9ff IDE-Select 1 (Port 0, Register set 1)
48 $a00-$aff IDE-Select 2 (Port 1, Register set 0)
50 $b00-$bff IDE-Select 3 (Port 1, Register set 1)
52 $c00-$cff IDE-Select 4 (Port 2, Register set 0,
55 $d00-$dff IDE-Select 5 (Port 3, Register set 1,
63 level of the IRQ-line of IDE port 0.
68 level of the IRQ-line of IDE port 1.
[all …]
/linux-2.6.39/Documentation/ide/
Dide.txt2 Information regarding the Enhanced IDE drive in Linux 2.6
7 The hdparm utility can be used to control various IDE features on a
13 *** IMPORTANT NOTICES: BUGGY IDE CHIPSETS CAN CORRUPT DATA!!
40 - 40-conductor IDE cables are capable of transferring data in DMA modes up to
54 This is the multiple IDE interface driver, as evolved from hd.c.
56 It supports up to 9 IDE interfaces per default, on one or more IRQs (usually
70 This driver automatically probes for most IDE interfaces (including all PCI
76 The IDE driver automatically detects and handles this. However, this may
106 Note that when only one IDE device is attached to an interface, it should be
125 interface (/dev/hda) and an IDE cdrom drive on the secondary interface
[all …]
Dide-tape.txt1 IDE ATAPI streaming tape driver.
15 ht0 major 37, minor 0 first IDE tape, rewind on close.
16 ht1 major 37, minor 1 second IDE tape, rewind on close.
18 nht0 major 37, minor 128 first IDE tape, no rewind on close.
19 nht1 major 37, minor 129 second IDE tape, no rewind on close.
38 Testing was done with a 2 GB CONNER CTMA 4000 IDE ATAPI Streaming Tape Drive.
59 same purpose - efficient use of the IDE bus, but is interrupt
D00-INDEX10 - info on the IDE ATAPI streaming tape driver
12 - important info for users of ATA devices (IDE/EIDE disks and CD-ROMS).
DChangeLog.ide-tape.1995-200219 * 1. An IDE ATAPI TAPE shares the same interface
20 * and irq with an IDE ATAPI CDROM.
21 * 2. An IDE ATAPI TAPE shares the same interface
22 * and irq with a normal IDE disk.
25 * recommended to give the IDE TAPE its own interface
94 * typically results in better IDE bus efficiency and
117 * now sometimes be used with IDE tape drives as well.
/linux-2.6.39/drivers/ata/
Data_piix.c124 IDE = -1, /* IDE */ enumerator
389 { P0, P1, IDE, IDE }, /* 100b */
390 { P1, P0, IDE, IDE }, /* 101b */
391 { IDE, IDE, P0, P1 }, /* 110b */
392 { IDE, IDE, P1, P0 }, /* 111b */
402 { IDE, IDE, P1, P3 }, /* 01b */
403 { P0, P2, IDE, IDE }, /* 10b */
419 { IDE, IDE, P1, P3 }, /* 01b */
420 { P0, P2, IDE, IDE }, /* 10b */
432 { P0, P2, IDE, IDE }, /* 10b (IDE mode) */
[all …]
DKconfig124 SFF is the legacy IDE interface that has been around since
414 IDE controller found on some older machines.
493 Enable support for the JMicron IDE controller, via the new
499 tristate "Apple PowerMac/PowerBook internal 'MacIO' IDE"
502 Most IDE capable PowerMacs have IDE busses driven by a variant
519 tristate "Freescale MPC52xx SoC internal IDE"
523 This option enables support for integrated IDE controller
551 NS87415 PCI-IDE controller.
619 tristate "Toshiba's Cell Reference Set IDE support"
622 This option enables support for the built-in IDE controller on
[all …]
/linux-2.6.39/drivers/zorro/
Dzorro.ids135 0800 Impact 3001 [IDE Interface]
152 0d00 Impact 3001 [IDE Interface]
190 0600 Tandem AT-2008/508 [IDE Interface]
217 0300 Advantage [IDE Interface]
238 0600 Tandem AT-2008/508 [IDE Interface]
311 0400 MasterCard MC702 [SCSI Host Adapter and IDE Interface]
314 0100 [IDE Interface]
342 0100 AT500 [IDE Interface]
348 2400 Viper Mk V/E-Matrix 530 [SCSI Host Adapter and IDE Interface]
365 0800 FastATA 1200 [IDE Interface]
[all …]
/linux-2.6.39/Documentation/mips/
DAU1xxx_IDE.README1 README for MIPS AU1XXX IDE driver - Released 2005-07-15
38 Note: for more information, please refer "AMD Alchemy Au1200/Au1550 IDE
53 contains the functionality of the AU1XXX IDE driver
63 SUPPORTED IDE MODES
66 The AU1XXX IDE driver supported all PIO modes - PIO mode 0/1/2/3/4 - and all
95 high IDE to USB throughput.
116 IDE driver from AMD.
D00-INDEX4 - README for MIPS AU1XXX IDE driver.
/linux-2.6.39/drivers/block/paride/
DKconfig8 comment "Parallel IDE high-level drivers"
12 tristate "Parallel port IDE disks"
15 This option enables the high-level driver for IDE-type disk devices
18 parallel port IDE driver, otherwise you should answer M to build
92 comment "Parallel IDE protocol modules"
99 This option enables support for the ATEN EH-100 parallel port IDE
113 parallel port Series 5 IDE protocol. (Most BACKPACK drives made
131 parallel port Series 6 IDE protocol. (Most BACKPACK drives made
149 This option enables support for the Commuter parallel port IDE
160 This option enables support for the EP-2000 parallel port IDE
[all …]
/linux-2.6.39/drivers/staging/phison/
DKconfig2 tristate "PCIE ATA PS5000 IDE support"
5 This is an experimental driver for PS5000 IDE driver.
/linux-2.6.39/arch/arm/mach-tegra/
Dpinmux-t2-tables.c102 …PINGROUP(ATA, NAND, IDE, NAND, GMI, RSVD, IDE, 0x14, 0, 0x80, …
103 …PINGROUP(ATB, NAND, IDE, NAND, GMI, SDIO4, IDE, 0x14, 1, 0x80, …
104 …PINGROUP(ATC, NAND, IDE, NAND, GMI, SDIO4, IDE, 0x14, 2, 0x80, …
105 …PINGROUP(ATD, NAND, IDE, NAND, GMI, SDIO4, IDE, 0x14, 3, 0x80, …
106 …PINGROUP(ATE, NAND, IDE, NAND, GMI, RSVD, IDE, 0x18, 25, 0x80, …
123 …PINGROUP(GMB, NAND, IDE, NAND, GMI, GMI_INT, GMI, 0x18, 29, 0x88, …
/linux-2.6.39/Documentation/arm/SA1100/
DPangolin5 PCMCIA/IDE card and TFT-LCD card.
23 - IDE driver (experimental)
/linux-2.6.39/Documentation/cdrom/
Dide-cd1 IDE-CD driver documentation
10 CDROM drives which attach to an IDE interface. Note that some CDROM vendors
17 (CyCDROM CR520ie) which attaches to the IDE port but is not ATAPI;
53 entitled "Floppy, IDE, and other block devices", say either `Y'
58 Enhanced IDE/MFM/RLL disk/cdrom/tape/floppy support
59 Include IDE/ATAPI CDROM support
65 Depending on what type of IDE interface you have, you may need to
74 3. The CDROM drive should be connected to the host on an IDE
84 on the primary IDE interface are called `hda' and `hdb',
90 driver, you should make sure your IDE interface uses either the
[all …]
D00-INDEX8 - info on setting up and using ATAPI (aka IDE) CD-ROMs.
/linux-2.6.39/arch/sh/boards/mach-microdev/
Dirq.c61 # error Inconsistancy in defining the IRQ# for secondary IDE!
65 # error Inconsistancy in defining the IRQ# for primary IDE!
/linux-2.6.39/Documentation/arm/Samsung-S3C24XX/
DEB2410ITX.txt45 IDE
48 Both onboard IDE ports are supported, however there is no support for
/linux-2.6.39/Documentation/blockdev/
Dparide.txt2 Linux and parallel port IDE devices
18 The adapter chip reproduces a small ISA or IDE bus in the external device
26 IDE type devices, which require no intermediate controller. If one
30 IDE cable. It is usually possible to exchange the CD-ROM device with
31 any other device using the IDE interface.
33 The document describes the support in Linux for parallel port IDE
36 parallel port IDE subsystem, including:
52 To support such a wide range of devices, PARIDE, the parallel port IDE
58 pd IDE disk
68 for each of the parallel port IDE adapter chips. Thanks to the interest
[all …]
Dmflash.txt16 driver and currently works well under standard IDE subsystem. Actually it's
18 IDE interface.
/linux-2.6.39/Documentation/
Ddevices.txt200 3 block First MFM, RLL and IDE hard disk/CD-ROM interface
288 Partitions are handled in the same way as for IDE
497 13 block 8-bit MFM/RLL/IDE controller
501 Partitions are handled in the same way as IDE disks
593 Partitions are handled the same way as for IDE disks
600 22 block Second IDE hard disk/CD-ROM interface
712 Partitions are handled in the same way as for IDE
796 33 block Third IDE hard disk/CD-ROM interface
814 34 block Fourth IDE hard disk/CD-ROM interface
851 Partitions are handled in the same way as IDE disks
[all …]
Dsgi-ioc4.txt5 IDE controller, a serial controller, a PS/2 keyboard/mouse controller,
35 This is the IDE driver for IOC4. Its name isn't very descriptive
/linux-2.6.39/Documentation/ioctl/
Dhdio.txt9 the HD/IDE layer. These are by-and-large implemented (as of Linux 2.6)
19 HDIO_GET_MULTCOUNT get current IDE blockmode setting
28 HDIO_GET_IDENTITY get IDE identification info
42 HDIO_SET_MULTCOUNT change IDE blockmode
166 HDIO_GET_MULTCOUNT get current IDE blockmode setting
176 The value of the current IDE block mode setting. This
182 HDIO_SET_MULTCOUNT change IDE blockmode
190 New value for IDE block mode setting. This controls how many
234 HDIO_GET_IDENTITY get IDE identification info
365 bandwidth to other devices sharing the same IDE bus.
[all …]

1234