1 // SPDX-License-Identifier: GPL-2.0-or-later
2 /*
3 * IDE tuning and bus mastering support for the CS5510/CS5520
4 * chipsets
5 *
6 * The CS5510/CS5520 are slightly unusual devices. Unlike the
7 * typical IDE controllers they do bus mastering with the drive in
8 * PIO mode and smarter silicon.
9 *
10 * The practical upshot of this is that we must always tune the
11 * drive for the right PIO mode. We must also ignore all the blacklists
12 * and the drive bus mastering DMA information. Also to confuse matters
13 * further we can do DMA on PIO only drives.
14 *
15 * DMA on the 5510 also requires we disable_hlt() during DMA on early
16 * revisions.
17 *
18 * *** This driver is strictly experimental ***
19 *
20 * (c) Copyright Red Hat Inc 2002
21 *
22 * Documentation:
23 * Not publicly available.
24 */
25 #include <linux/kernel.h>
26 #include <linux/module.h>
27 #include <linux/pci.h>
28 #include <linux/blkdev.h>
29 #include <linux/delay.h>
30 #include <scsi/scsi_host.h>
31 #include <linux/libata.h>
32
33 #define DRV_NAME "pata_cs5520"
34 #define DRV_VERSION "0.6.6"
35
36 struct pio_clocks
37 {
38 int address;
39 int assert;
40 int recovery;
41 };
42
43 static const struct pio_clocks cs5520_pio_clocks[]={
44 {3, 6, 11},
45 {2, 5, 6},
46 {1, 4, 3},
47 {1, 3, 2},
48 {1, 2, 1}
49 };
50
51 /**
52 * cs5520_set_timings - program PIO timings
53 * @ap: ATA port
54 * @adev: ATA device
55 * @pio: PIO ID
56 *
57 * Program the PIO mode timings for the controller according to the pio
58 * clocking table.
59 */
60
cs5520_set_timings(struct ata_port * ap,struct ata_device * adev,int pio)61 static void cs5520_set_timings(struct ata_port *ap, struct ata_device *adev, int pio)
62 {
63 struct pci_dev *pdev = to_pci_dev(ap->host->dev);
64 int slave = adev->devno;
65
66 pio -= XFER_PIO_0;
67
68 /* Channel command timing */
69 pci_write_config_byte(pdev, 0x62 + ap->port_no,
70 (cs5520_pio_clocks[pio].recovery << 4) |
71 (cs5520_pio_clocks[pio].assert));
72 /* FIXME: should these use address ? */
73 /* Read command timing */
74 pci_write_config_byte(pdev, 0x64 + 4*ap->port_no + slave,
75 (cs5520_pio_clocks[pio].recovery << 4) |
76 (cs5520_pio_clocks[pio].assert));
77 /* Write command timing */
78 pci_write_config_byte(pdev, 0x66 + 4*ap->port_no + slave,
79 (cs5520_pio_clocks[pio].recovery << 4) |
80 (cs5520_pio_clocks[pio].assert));
81 }
82
83 /**
84 * cs5520_set_piomode - program PIO timings
85 * @ap: ATA port
86 * @adev: ATA device
87 *
88 * Program the PIO mode timings for the controller according to the pio
89 * clocking table.
90 */
91
cs5520_set_piomode(struct ata_port * ap,struct ata_device * adev)92 static void cs5520_set_piomode(struct ata_port *ap, struct ata_device *adev)
93 {
94 cs5520_set_timings(ap, adev, adev->pio_mode);
95 }
96
97 static const struct scsi_host_template cs5520_sht = {
98 ATA_BASE_SHT(DRV_NAME),
99 .sg_tablesize = LIBATA_DUMB_MAX_PRD,
100 .dma_boundary = ATA_DMA_BOUNDARY,
101 };
102
103 static struct ata_port_operations cs5520_port_ops = {
104 .inherits = &ata_bmdma_port_ops,
105 .qc_prep = ata_bmdma_dumb_qc_prep,
106 .cable_detect = ata_cable_40wire,
107 .set_piomode = cs5520_set_piomode,
108 };
109
cs5520_init_one(struct pci_dev * pdev,const struct pci_device_id * id)110 static int cs5520_init_one(struct pci_dev *pdev, const struct pci_device_id *id)
111 {
112 static const unsigned int cmd_port[] = { 0x1F0, 0x170 };
113 static const unsigned int ctl_port[] = { 0x3F6, 0x376 };
114 struct ata_port_info pi = {
115 .flags = ATA_FLAG_SLAVE_POSS,
116 .pio_mask = ATA_PIO4,
117 .port_ops = &cs5520_port_ops,
118 };
119 const struct ata_port_info *ppi[2];
120 u8 pcicfg;
121 void __iomem *iomap[5];
122 struct ata_host *host;
123 struct ata_ioports *ioaddr;
124 int i, rc;
125
126 rc = pcim_enable_device(pdev);
127 if (rc)
128 return rc;
129
130 /* IDE port enable bits */
131 pci_read_config_byte(pdev, 0x60, &pcicfg);
132
133 /* Check if the ATA ports are enabled */
134 if ((pcicfg & 3) == 0)
135 return -ENODEV;
136
137 ppi[0] = ppi[1] = &ata_dummy_port_info;
138 if (pcicfg & 1)
139 ppi[0] = π
140 if (pcicfg & 2)
141 ppi[1] = π
142
143 if ((pcicfg & 0x40) == 0) {
144 dev_warn(&pdev->dev, "DMA mode disabled. Enabling.\n");
145 pci_write_config_byte(pdev, 0x60, pcicfg | 0x40);
146 }
147
148 pi.mwdma_mask = id->driver_data;
149
150 host = ata_host_alloc_pinfo(&pdev->dev, ppi, 2);
151 if (!host)
152 return -ENOMEM;
153
154 /* Perform set up for DMA */
155 if (pci_enable_device_io(pdev)) {
156 dev_err(&pdev->dev, "unable to configure BAR2.\n");
157 return -ENODEV;
158 }
159
160 if (dma_set_mask_and_coherent(&pdev->dev, DMA_BIT_MASK(32))) {
161 dev_err(&pdev->dev, "unable to configure DMA mask.\n");
162 return -ENODEV;
163 }
164
165 /* Map IO ports and initialize host accordingly */
166 iomap[0] = devm_ioport_map(&pdev->dev, cmd_port[0], 8);
167 iomap[1] = devm_ioport_map(&pdev->dev, ctl_port[0], 1);
168 iomap[2] = devm_ioport_map(&pdev->dev, cmd_port[1], 8);
169 iomap[3] = devm_ioport_map(&pdev->dev, ctl_port[1], 1);
170 iomap[4] = pcim_iomap(pdev, 2, 0);
171
172 if (!iomap[0] || !iomap[1] || !iomap[2] || !iomap[3] || !iomap[4])
173 return -ENOMEM;
174
175 ioaddr = &host->ports[0]->ioaddr;
176 ioaddr->cmd_addr = iomap[0];
177 ioaddr->ctl_addr = iomap[1];
178 ioaddr->altstatus_addr = iomap[1];
179 ioaddr->bmdma_addr = iomap[4];
180 ata_sff_std_ports(ioaddr);
181
182 ata_port_desc(host->ports[0],
183 "cmd 0x%x ctl 0x%x", cmd_port[0], ctl_port[0]);
184 ata_port_pbar_desc(host->ports[0], 4, 0, "bmdma");
185
186 ioaddr = &host->ports[1]->ioaddr;
187 ioaddr->cmd_addr = iomap[2];
188 ioaddr->ctl_addr = iomap[3];
189 ioaddr->altstatus_addr = iomap[3];
190 ioaddr->bmdma_addr = iomap[4] + 8;
191 ata_sff_std_ports(ioaddr);
192
193 ata_port_desc(host->ports[1],
194 "cmd 0x%x ctl 0x%x", cmd_port[1], ctl_port[1]);
195 ata_port_pbar_desc(host->ports[1], 4, 8, "bmdma");
196
197 /* activate the host */
198 pci_set_master(pdev);
199 rc = ata_host_start(host);
200 if (rc)
201 return rc;
202
203 for (i = 0; i < 2; i++) {
204 static const int irq[] = { 14, 15 };
205 struct ata_port *ap = host->ports[i];
206
207 if (ata_port_is_dummy(ap))
208 continue;
209
210 rc = devm_request_irq(&pdev->dev, irq[ap->port_no],
211 ata_bmdma_interrupt, 0, DRV_NAME, host);
212 if (rc)
213 return rc;
214
215 ata_port_desc(ap, "irq %d", irq[i]);
216 }
217
218 return ata_host_register(host, &cs5520_sht);
219 }
220
221 #ifdef CONFIG_PM_SLEEP
222 /**
223 * cs5520_reinit_one - device resume
224 * @pdev: PCI device
225 *
226 * Do any reconfiguration work needed by a resume from RAM. We need
227 * to restore DMA mode support on BIOSen which disabled it
228 */
229
cs5520_reinit_one(struct pci_dev * pdev)230 static int cs5520_reinit_one(struct pci_dev *pdev)
231 {
232 struct ata_host *host = pci_get_drvdata(pdev);
233 u8 pcicfg;
234 int rc;
235
236 rc = ata_pci_device_do_resume(pdev);
237 if (rc)
238 return rc;
239
240 pci_read_config_byte(pdev, 0x60, &pcicfg);
241 if ((pcicfg & 0x40) == 0)
242 pci_write_config_byte(pdev, 0x60, pcicfg | 0x40);
243
244 ata_host_resume(host);
245 return 0;
246 }
247
248 /**
249 * cs5520_pci_device_suspend - device suspend
250 * @pdev: PCI device
251 * @mesg: PM event message
252 *
253 * We have to cut and waste bits from the standard method because
254 * the 5520 is a bit odd and not just a pure ATA device. As a result
255 * we must not disable it. The needed code is short and this avoids
256 * chip specific mess in the core code.
257 */
258
cs5520_pci_device_suspend(struct pci_dev * pdev,pm_message_t mesg)259 static int cs5520_pci_device_suspend(struct pci_dev *pdev, pm_message_t mesg)
260 {
261 struct ata_host *host = pci_get_drvdata(pdev);
262
263 ata_host_suspend(host, mesg);
264
265 pci_save_state(pdev);
266 return 0;
267 }
268 #endif /* CONFIG_PM_SLEEP */
269
270 /* For now keep DMA off. We can set it for all but A rev CS5510 once the
271 core ATA code can handle it */
272
273 static const struct pci_device_id pata_cs5520[] = {
274 { PCI_VDEVICE(CYRIX, PCI_DEVICE_ID_CYRIX_5510), },
275 { PCI_VDEVICE(CYRIX, PCI_DEVICE_ID_CYRIX_5520), },
276
277 { },
278 };
279
280 static struct pci_driver cs5520_pci_driver = {
281 .name = DRV_NAME,
282 .id_table = pata_cs5520,
283 .probe = cs5520_init_one,
284 .remove = ata_pci_remove_one,
285 #ifdef CONFIG_PM_SLEEP
286 .suspend = cs5520_pci_device_suspend,
287 .resume = cs5520_reinit_one,
288 #endif
289 };
290
291 module_pci_driver(cs5520_pci_driver);
292
293 MODULE_AUTHOR("Alan Cox");
294 MODULE_DESCRIPTION("low-level driver for Cyrix CS5510/5520");
295 MODULE_LICENSE("GPL");
296 MODULE_DEVICE_TABLE(pci, pata_cs5520);
297 MODULE_VERSION(DRV_VERSION);
298