1What:		/sys/bus/iio/devices/iio:deviceX/in_proximity<id>_setup
2Date:		November 2021
3KernelVersion:	5.17
4Contact:	Gwendal Grignou <gwendal@chromium.org>
5Description:
6		SX9324 has 3 inputs, CS0, CS1 and CS2. Hardware layout
7		defines if the input is
8
9		+ not connected (HZ),
10		+ grounded (GD),
11		+ connected to an antenna where it can act as a base
12		  (DS - data shield), or measured input (MI).
13
14		The sensor rotates measurement across 4 phases
15		(PH0, PH1, PH2, PH3), where the inputs are configured
16		and then measured.
17
18		By default,  during the first phase, [PH0], CS0 is measured,
19		while CS1 and CS2 are used as shields.
20		`cat in_proximity0_setup` returns "MI,DS,DS".
21		[PH1], CS1 is measured, CS0 and CS2 are shield:
22		`cat in_proximity1_setup` returns "DS,MI,DS".
23		[PH2], CS2 is measured, CS0 and CS1 are shield:
24		`cat in_proximity1_setup` returns "DS,DS,MI".
25		[PH3], CS1 and CS2 are measured (combo mode):
26		`cat in_proximity1_setup` returns "DS,MI,MI".
27
28		Note, these are the chip default. Hardware layout will most
29		likely dictate different output. The entry is read-only.
30