1# SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
2%YAML 1.2
3---
4$id: http://devicetree.org/schemas/mfd/rohm,bd71837-pmic.yaml#
5$schema: http://devicetree.org/meta-schemas/core.yaml#
6
7title: ROHM BD71837 Power Management Integrated Circuit bindings
8
9maintainers:
10  - Matti Vaittinen <matti.vaittinen@fi.rohmeurope.com>
11
12description: |
13  BD71837MWV is programmable Power Management ICs for powering single-core,
14  dual-core, and quad-core SoCs such as NXP-i.MX 8M. It is optimized for low
15  BOM cost and compact solution footprint. BD71837MWV  integrates 8 Buck
16  regulators and 7 LDOs.
17  Datasheet for BD71837 is available at
18  https://www.rohm.com/products/power-management/power-management-ic-for-system/industrial-consumer-applications/nxp-imx/bd71837amwv-product
19
20properties:
21  compatible:
22    const: rohm,bd71837
23
24  reg:
25    description:
26      I2C slave address.
27    maxItems: 1
28
29  interrupts:
30    maxItems: 1
31
32  clocks:
33    maxItems: 1
34
35  clock-names:
36    const: osc
37
38  "#clock-cells":
39    const: 0
40
41  clock-output-names:
42    const: pmic_clk
43
44# The BD718x7 supports two different HW states as reset target states. States
45# are called as SNVS and READY. At READY state all the PMIC power outputs go
46# down and OTP is reload. At the SNVS state all other logic and external
47# devices apart from the SNVS power domain are shut off. Please refer to NXP
48# i.MX8 documentation for further information regarding SNVS state. When a
49# reset is done via SNVS state the PMIC OTP data is not reload. This causes
50# power outputs that have been under SW control to stay down when reset has
51# switched power state to SNVS. If reset is done via READY state the power
52# outputs will be returned to HW control by OTP loading. Thus the reset
53# target state is set to READY by default. If SNVS state is used the boot
54# crucial regulators must have the regulator-always-on and regulator-boot-on
55# properties set in regulator node.
56
57  rohm,reset-snvs-powered:
58    description: |
59      Transfer PMIC to SNVS state at reset
60    type: boolean
61
62# Configure the "short press" and "long press" timers for the power button.
63# Values are rounded to what hardware supports
64# Short-press:
65#   Shortest being 10ms, next 500ms and then multiple of 500ms up to 7,5s
66# Long-press:
67#   Shortest being 10ms, next 1000ms and then multiple of 1000ms up to 15s
68# If these properties are not present the existing configuration (from
69# bootloader or OTP) is not touched.
70
71  rohm,short-press-ms:
72    description:
73      Short press duration in milliseconds
74    enum:
75      - 10
76      - 500
77      - 1000
78      - 1500
79      - 2000
80      - 2500
81      - 3000
82      - 3500
83      - 4000
84      - 4500
85      - 5000
86      - 5500
87      - 6000
88      - 6500
89      - 7000
90
91  rohm,long-press-ms:
92    description:
93      Long press duration in milliseconds
94    enum:
95      - 10
96      - 1000
97      - 2000
98      - 3000
99      - 4000
100      - 5000
101      - 6000
102      - 7000
103      - 8000
104      - 9000
105      - 10000
106      - 11000
107      - 12000
108      - 13000
109      - 14000
110
111  regulators:
112    $ref: ../regulator/rohm,bd71837-regulator.yaml
113    description:
114      List of child nodes that specify the regulators.
115
116required:
117  - compatible
118  - reg
119  - interrupts
120  - clocks
121  - "#clock-cells"
122  - regulators
123
124additionalProperties: false
125
126examples:
127  - |
128    #include <dt-bindings/interrupt-controller/irq.h>
129    #include <dt-bindings/leds/common.h>
130
131    i2c {
132        #address-cells = <1>;
133        #size-cells = <0>;
134        pmic: pmic@4b {
135            compatible = "rohm,bd71837";
136            reg = <0x4b>;
137            interrupt-parent = <&gpio1>;
138            interrupts = <29 IRQ_TYPE_LEVEL_LOW>;
139            #clock-cells = <0>;
140            clocks = <&osc 0>;
141            rohm,reset-snvs-powered;
142            rohm,short-press-ms = <10>;
143            rohm,long-press-ms = <2000>;
144
145            regulators {
146                buck1: BUCK1 {
147                    regulator-name = "buck1";
148                    regulator-min-microvolt = <700000>;
149                    regulator-max-microvolt = <1300000>;
150                    regulator-boot-on;
151                    regulator-always-on;
152                    regulator-ramp-delay = <1250>;
153                    rohm,dvs-run-voltage = <900000>;
154                    rohm,dvs-idle-voltage = <850000>;
155                    rohm,dvs-suspend-voltage = <800000>;
156                };
157                buck2: BUCK2 {
158                    regulator-name = "buck2";
159                    regulator-min-microvolt = <700000>;
160                    regulator-max-microvolt = <1300000>;
161                    regulator-boot-on;
162                    regulator-always-on;
163                    regulator-ramp-delay = <1250>;
164                    rohm,dvs-run-voltage = <1000000>;
165                    rohm,dvs-idle-voltage = <900000>;
166                };
167                buck3: BUCK3 {
168                    regulator-name = "buck3";
169                    regulator-min-microvolt = <700000>;
170                    regulator-max-microvolt = <1300000>;
171                    regulator-boot-on;
172                    rohm,dvs-run-voltage = <1000000>;
173                };
174                buck4: BUCK4 {
175                    regulator-name = "buck4";
176                    regulator-min-microvolt = <700000>;
177                    regulator-max-microvolt = <1300000>;
178                    regulator-boot-on;
179                    rohm,dvs-run-voltage = <1000000>;
180                };
181                buck5: BUCK5 {
182                    regulator-name = "buck5";
183                    regulator-min-microvolt = <700000>;
184                    regulator-max-microvolt = <1350000>;
185                    regulator-boot-on;
186                };
187                buck6: BUCK6 {
188                    regulator-name = "buck6";
189                    regulator-min-microvolt = <3000000>;
190                    regulator-max-microvolt = <3300000>;
191                    regulator-boot-on;
192                };
193                buck7: BUCK7 {
194                    regulator-name = "buck7";
195                    regulator-min-microvolt = <1605000>;
196                    regulator-max-microvolt = <1995000>;
197                    regulator-boot-on;
198                };
199                buck8: BUCK8 {
200                    regulator-name = "buck8";
201                    regulator-min-microvolt = <800000>;
202                    regulator-max-microvolt = <1400000>;
203                };
204
205                ldo1: LDO1 {
206                    regulator-name = "ldo1";
207                    regulator-min-microvolt = <3000000>;
208                    regulator-max-microvolt = <3300000>;
209                    regulator-boot-on;
210                };
211                ldo2: LDO2 {
212                    regulator-name = "ldo2";
213                    regulator-min-microvolt = <900000>;
214                    regulator-max-microvolt = <900000>;
215                    regulator-boot-on;
216                };
217                ldo3: LDO3 {
218                    regulator-name = "ldo3";
219                    regulator-min-microvolt = <1800000>;
220                    regulator-max-microvolt = <3300000>;
221                };
222                ldo4: LDO4 {
223                    regulator-name = "ldo4";
224                    regulator-min-microvolt = <900000>;
225                    regulator-max-microvolt = <1800000>;
226                };
227                ldo5: LDO5 {
228                    regulator-name = "ldo5";
229                    regulator-min-microvolt = <1800000>;
230                    regulator-max-microvolt = <3300000>;
231                };
232                ldo6: LDO6 {
233                    regulator-name = "ldo6";
234                    regulator-min-microvolt = <900000>;
235                    regulator-max-microvolt = <1800000>;
236                };
237                ldo7_reg: LDO7 {
238                    regulator-name = "ldo7";
239                    regulator-min-microvolt = <1800000>;
240                    regulator-max-microvolt = <3300000>;
241                };
242            };
243        };
244    };
245