1 /*
2 * Comtrol SV11 card driver
3 *
4 * This is a slightly odd Z85230 synchronous driver. All you need to
5 * know basically is
6 *
7 * Its a genuine Z85230
8 *
9 * It supports DMA using two DMA channels in SYNC mode. The driver doesn't
10 * use these facilities
11 *
12 * The control port is at io+1, the data at io+3 and turning off the DMA
13 * is done by writing 0 to io+4
14 *
15 * The hardware does the bus handling to avoid the need for delays between
16 * touching control registers.
17 *
18 * Port B isn't wired (why - beats me)
19 *
20 * Generic HDLC port Copyright (C) 2008 Krzysztof Halasa <khc@pm.waw.pl>
21 */
22
23 #define pr_fmt(fmt) KBUILD_MODNAME ": " fmt
24
25 #include <linux/module.h>
26 #include <linux/kernel.h>
27 #include <linux/mm.h>
28 #include <linux/net.h>
29 #include <linux/skbuff.h>
30 #include <linux/netdevice.h>
31 #include <linux/if_arp.h>
32 #include <linux/delay.h>
33 #include <linux/hdlc.h>
34 #include <linux/ioport.h>
35 #include <linux/slab.h>
36 #include <net/arp.h>
37
38 #include <asm/irq.h>
39 #include <asm/io.h>
40 #include <asm/dma.h>
41 #include <asm/byteorder.h>
42 #include "z85230.h"
43
44 static int dma;
45
46 /*
47 * Network driver support routines
48 */
49
dev_to_sv(struct net_device * dev)50 static inline struct z8530_dev* dev_to_sv(struct net_device *dev)
51 {
52 return (struct z8530_dev *)dev_to_hdlc(dev)->priv;
53 }
54
55 /*
56 * Frame receive. Simple for our card as we do HDLC and there
57 * is no funny garbage involved
58 */
59
hostess_input(struct z8530_channel * c,struct sk_buff * skb)60 static void hostess_input(struct z8530_channel *c, struct sk_buff *skb)
61 {
62 /* Drop the CRC - it's not a good idea to try and negotiate it ;) */
63 skb_trim(skb, skb->len - 2);
64 skb->protocol = hdlc_type_trans(skb, c->netdevice);
65 skb_reset_mac_header(skb);
66 skb->dev = c->netdevice;
67 /*
68 * Send it to the PPP layer. We don't have time to process
69 * it right now.
70 */
71 netif_rx(skb);
72 }
73
74 /*
75 * We've been placed in the UP state
76 */
77
hostess_open(struct net_device * d)78 static int hostess_open(struct net_device *d)
79 {
80 struct z8530_dev *sv11 = dev_to_sv(d);
81 int err = -1;
82
83 /*
84 * Link layer up
85 */
86 switch (dma) {
87 case 0:
88 err = z8530_sync_open(d, &sv11->chanA);
89 break;
90 case 1:
91 err = z8530_sync_dma_open(d, &sv11->chanA);
92 break;
93 case 2:
94 err = z8530_sync_txdma_open(d, &sv11->chanA);
95 break;
96 }
97
98 if (err)
99 return err;
100
101 err = hdlc_open(d);
102 if (err) {
103 switch (dma) {
104 case 0:
105 z8530_sync_close(d, &sv11->chanA);
106 break;
107 case 1:
108 z8530_sync_dma_close(d, &sv11->chanA);
109 break;
110 case 2:
111 z8530_sync_txdma_close(d, &sv11->chanA);
112 break;
113 }
114 return err;
115 }
116 sv11->chanA.rx_function = hostess_input;
117
118 /*
119 * Go go go
120 */
121
122 netif_start_queue(d);
123 return 0;
124 }
125
hostess_close(struct net_device * d)126 static int hostess_close(struct net_device *d)
127 {
128 struct z8530_dev *sv11 = dev_to_sv(d);
129 /*
130 * Discard new frames
131 */
132 sv11->chanA.rx_function = z8530_null_rx;
133
134 hdlc_close(d);
135 netif_stop_queue(d);
136
137 switch (dma) {
138 case 0:
139 z8530_sync_close(d, &sv11->chanA);
140 break;
141 case 1:
142 z8530_sync_dma_close(d, &sv11->chanA);
143 break;
144 case 2:
145 z8530_sync_txdma_close(d, &sv11->chanA);
146 break;
147 }
148 return 0;
149 }
150
hostess_ioctl(struct net_device * d,struct ifreq * ifr,int cmd)151 static int hostess_ioctl(struct net_device *d, struct ifreq *ifr, int cmd)
152 {
153 /* struct z8530_dev *sv11=dev_to_sv(d);
154 z8530_ioctl(d,&sv11->chanA,ifr,cmd) */
155 return hdlc_ioctl(d, ifr, cmd);
156 }
157
158 /*
159 * Passed network frames, fire them downwind.
160 */
161
hostess_queue_xmit(struct sk_buff * skb,struct net_device * d)162 static netdev_tx_t hostess_queue_xmit(struct sk_buff *skb,
163 struct net_device *d)
164 {
165 return z8530_queue_xmit(&dev_to_sv(d)->chanA, skb);
166 }
167
hostess_attach(struct net_device * dev,unsigned short encoding,unsigned short parity)168 static int hostess_attach(struct net_device *dev, unsigned short encoding,
169 unsigned short parity)
170 {
171 if (encoding == ENCODING_NRZ && parity == PARITY_CRC16_PR1_CCITT)
172 return 0;
173 return -EINVAL;
174 }
175
176 /*
177 * Description block for a Comtrol Hostess SV11 card
178 */
179
180 static const struct net_device_ops hostess_ops = {
181 .ndo_open = hostess_open,
182 .ndo_stop = hostess_close,
183 .ndo_change_mtu = hdlc_change_mtu,
184 .ndo_start_xmit = hdlc_start_xmit,
185 .ndo_do_ioctl = hostess_ioctl,
186 };
187
sv11_init(int iobase,int irq)188 static struct z8530_dev *sv11_init(int iobase, int irq)
189 {
190 struct z8530_dev *sv;
191 struct net_device *netdev;
192 /*
193 * Get the needed I/O space
194 */
195
196 if (!request_region(iobase, 8, "Comtrol SV11")) {
197 pr_warn("I/O 0x%X already in use\n", iobase);
198 return NULL;
199 }
200
201 sv = kzalloc(sizeof(struct z8530_dev), GFP_KERNEL);
202 if (!sv)
203 goto err_kzalloc;
204
205 /*
206 * Stuff in the I/O addressing
207 */
208
209 sv->active = 0;
210
211 sv->chanA.ctrlio = iobase + 1;
212 sv->chanA.dataio = iobase + 3;
213 sv->chanB.ctrlio = -1;
214 sv->chanB.dataio = -1;
215 sv->chanA.irqs = &z8530_nop;
216 sv->chanB.irqs = &z8530_nop;
217
218 outb(0, iobase + 4); /* DMA off */
219
220 /* We want a fast IRQ for this device. Actually we'd like an even faster
221 IRQ ;) - This is one driver RtLinux is made for */
222
223 if (request_irq(irq, z8530_interrupt, IRQF_DISABLED,
224 "Hostess SV11", sv) < 0) {
225 pr_warn("IRQ %d already in use\n", irq);
226 goto err_irq;
227 }
228
229 sv->irq = irq;
230 sv->chanA.private = sv;
231 sv->chanA.dev = sv;
232 sv->chanB.dev = sv;
233
234 if (dma) {
235 /*
236 * You can have DMA off or 1 and 3 thats the lot
237 * on the Comtrol.
238 */
239 sv->chanA.txdma = 3;
240 sv->chanA.rxdma = 1;
241 outb(0x03 | 0x08, iobase + 4); /* DMA on */
242 if (request_dma(sv->chanA.txdma, "Hostess SV/11 (TX)"))
243 goto err_txdma;
244
245 if (dma == 1)
246 if (request_dma(sv->chanA.rxdma, "Hostess SV/11 (RX)"))
247 goto err_rxdma;
248 }
249
250 /* Kill our private IRQ line the hostess can end up chattering
251 until the configuration is set */
252 disable_irq(irq);
253
254 /*
255 * Begin normal initialise
256 */
257
258 if (z8530_init(sv)) {
259 pr_err("Z8530 series device not found\n");
260 enable_irq(irq);
261 goto free_dma;
262 }
263 z8530_channel_load(&sv->chanB, z8530_dead_port);
264 if (sv->type == Z85C30)
265 z8530_channel_load(&sv->chanA, z8530_hdlc_kilostream);
266 else
267 z8530_channel_load(&sv->chanA, z8530_hdlc_kilostream_85230);
268
269 enable_irq(irq);
270
271 /*
272 * Now we can take the IRQ
273 */
274
275 sv->chanA.netdevice = netdev = alloc_hdlcdev(sv);
276 if (!netdev)
277 goto free_dma;
278
279 dev_to_hdlc(netdev)->attach = hostess_attach;
280 dev_to_hdlc(netdev)->xmit = hostess_queue_xmit;
281 netdev->netdev_ops = &hostess_ops;
282 netdev->base_addr = iobase;
283 netdev->irq = irq;
284
285 if (register_hdlc_device(netdev)) {
286 pr_err("unable to register HDLC device\n");
287 free_netdev(netdev);
288 goto free_dma;
289 }
290
291 z8530_describe(sv, "I/O", iobase);
292 sv->active = 1;
293 return sv;
294
295 free_dma:
296 if (dma == 1)
297 free_dma(sv->chanA.rxdma);
298 err_rxdma:
299 if (dma)
300 free_dma(sv->chanA.txdma);
301 err_txdma:
302 free_irq(irq, sv);
303 err_irq:
304 kfree(sv);
305 err_kzalloc:
306 release_region(iobase, 8);
307 return NULL;
308 }
309
sv11_shutdown(struct z8530_dev * dev)310 static void sv11_shutdown(struct z8530_dev *dev)
311 {
312 unregister_hdlc_device(dev->chanA.netdevice);
313 z8530_shutdown(dev);
314 free_irq(dev->irq, dev);
315 if (dma) {
316 if (dma == 1)
317 free_dma(dev->chanA.rxdma);
318 free_dma(dev->chanA.txdma);
319 }
320 release_region(dev->chanA.ctrlio - 1, 8);
321 free_netdev(dev->chanA.netdevice);
322 kfree(dev);
323 }
324
325 static int io = 0x200;
326 static int irq = 9;
327
328 module_param(io, int, 0);
329 MODULE_PARM_DESC(io, "The I/O base of the Comtrol Hostess SV11 card");
330 module_param(dma, int, 0);
331 MODULE_PARM_DESC(dma, "Set this to 1 to use DMA1/DMA3 for TX/RX");
332 module_param(irq, int, 0);
333 MODULE_PARM_DESC(irq, "The interrupt line setting for the Comtrol Hostess SV11 card");
334
335 MODULE_AUTHOR("Alan Cox");
336 MODULE_LICENSE("GPL");
337 MODULE_DESCRIPTION("Modular driver for the Comtrol Hostess SV11");
338
339 static struct z8530_dev *sv11_unit;
340
init_module(void)341 int init_module(void)
342 {
343 if ((sv11_unit = sv11_init(io, irq)) == NULL)
344 return -ENODEV;
345 return 0;
346 }
347
cleanup_module(void)348 void cleanup_module(void)
349 {
350 if (sv11_unit)
351 sv11_shutdown(sv11_unit);
352 }
353