1
2What:		/sys/bus/iio/devices/device[n]/range
3KernelVersion:	2.6.37
4Contact:	linux-iio@vger.kernel.org
5Description:
6		Hardware dependent ADC Full Scale Range used for some ambient
7		light sensors in calculating lux.
8
9What:		/sys/bus/iio/devices/device[n]/range_available
10KernelVersion:	2.6.37
11Contact:	linux-iio@vger.kernel.org
12Description:
13		Hardware dependent supported vales for ADC Full Scale Range.
14
15What:		/sys/bus/iio/devices/device[n]/adc_resolution
16KernelVersion:	2.6.37
17Contact:	linux-iio@vger.kernel.org
18Description:
19		Hardware dependent ADC resolution of the ambient light sensor
20		used in calculating the lux.
21
22What:		/sys/bus/iio/devices/device[n]/adc_resolution_available
23KernelVersion:	2.6.37
24Contact:	linux-iio@vger.kernel.org
25Description:
26		Hardware dependent list of possible values supported for the
27		adc_resolution of the given sensor.
28
29What:		/sys/bus/iio/devices/device[n]/illuminance0[_input|_raw]
30KernelVersion:	2.6.35
31Contact:	linux-iio@vger.kernel.org
32Description:
33		This should return the calculated lux from the light sensor. If
34		it comes back in SI units, it should also include _input else it
35		should include _raw to signify it is not in SI units.
36
37What:		/sys/.../device[n]/proximity_on_chip_ambient_infrared_supression
38KernelVersion:	2.6.37
39Contact:	linux-iio@vger.kernel.org
40Description:
41		Hardware dependent mode for an ALS device to calculate the value
42		in proximity mode. When this is enabled, then the device should
43		use a infrared sensor reading to remove infrared noise from the
44		proximity reading. If this is not enabled, the driver can still
45		do this calculation manually by reading the infrared sensor
46		value and doing the negation in sw.
47
48What:		/sys/bus/iio/devices/device[n]/proximity[_input|_raw]
49KernelVersion:	2.6.37
50Contact:	linux-iio@vger.kernel.org
51Description:
52		This property is supported by proximity sensors and should be
53		used to return the value of a reading by the sensor. If this
54		value is returned in SI units, it should also include _input
55		but if it is not, then it should include _raw.
56
57What:		/sys/bus/iio/devices/device[n]/intensity_infrared[_input|_raw]
58KernelVersion:	2.6.37
59Contact:	linux-iio@vger.kernel.org
60Description:
61		This property is supported by sensors that have an infrared
62		sensing mode. This value should be the output from a reading
63		and if expressed in SI units, should include _input. If this
64		value is not in SI units, then it should include _raw.
65