1Kernel driver scx200_acb
2
3Author: Christer Weinigel <wingel@nano-system.com>
4
5The driver supersedes the older, never merged driver named i2c-nscacb.
6
7Module Parameters
8-----------------
9
10* base: up to 4 ints
11  Base addresses for the ACCESS.bus controllers on SCx200 and SC1100 devices
12
13  By default the driver uses two base addresses 0x820 and 0x840.
14  If you want only one base address, specify the second as 0 so as to
15  override this default.
16
17Description
18-----------
19
20Enable the use of the ACCESS.bus controller on the Geode SCx200 and
21SC1100 processors and the CS5535 and CS5536 Geode companion devices.
22
23Device-specific notes
24---------------------
25
26The SC1100 WRAP boards are known to use base addresses 0x810 and 0x820.
27If the scx200_acb driver is built into the kernel, add the following
28parameter to your boot command line:
29  scx200_acb.base=0x810,0x820
30If the scx200_acb driver is built as a module, add the following line to
31the file /etc/modprobe.conf instead:
32  options scx200_acb base=0x810,0x820
33