1Documentation for the AD1816(A) sound driver
2============================================
3
4Installation:
5-------------
6
7To get your AD1816(A) based sound card work, you'll have to enable support for
8experimental code ("Prompt for development and/or incomplete code/drivers")
9and isapnp ("Plug and Play support", "ISA Plug and Play support"). Enable
10"Sound card support", "OSS modules support" and "Support for AD1816(A) based
11cards (EXPERIMENTAL)" in the sound configuration menu, too. Now build, install
12and reboot the new kernel as usual.
13
14Features:
15---------
16
17List of features supported by this driver:
18- full-duplex support
19- supported audio formats: unsigned 8bit, signed 16bit little endian,
20                           signed 16bit big endian, �-law, A-law
21- supported channels: mono and stereo
22- supported recording sources: Master, CD, Line, Line1, Line2, Mic
23- supports phat 3d stereo circuit (Line 3)
24
25
26Supported cards:
27----------------
28
29The following cards are known to work with this driver:
30- Terratec Base 1
31- Terratec Base 64
32- HP Kayak
33- Acer FX-3D
34- SY-1816
35- Highscreen Sound-Boostar 32 Wave 3D
36- Highscreen Sound-Boostar 16
37- AVM Apex Pro card
38- (Aztech SC-16 3D)
39- (Newcom SC-16 3D)
40- (Terratec EWS64S)
41
42Cards listed in brackets are not supported reliable. If you have such a card
43you should add the extra parameter:
44  options=1
45when loading the ad1816 module via modprobe.
46
47
48Troubleshooting:
49----------------
50
51First of all you should check, if the driver has been loaded
52properly.
53
54If loading of the driver succeeds, but playback/capture fails, check
55if you used the correct values for irq, dma and dma2 when loading the module.
56If one of them is wrong you usually get the following error message:
57
58Nov  6 17:06:13 tek01 kernel: Sound: DMA (output) timed out - IRQ/DRQ config error?
59
60If playback/capture is too fast or to slow, you should have a look at
61the clock chip of your sound card. The AD1816 was designed for a 33MHz
62oscillator, however most sound card manufacturer use slightly
63different oscillators as they are cheaper than 33MHz oscillators. If
64you have such a card you have to adjust the ad1816_clockfreq parameter
65above. For example: For a card using a 32.875MHz oscillator use
66ad1816_clockfreq=32875 instead of ad1816_clockfreq=33000.
67
68
69Updates, bugfixes and bugreports:
70--------------------------------
71
72As the driver is still experimental and under development, you should
73watch out for updates.  Updates of the driver are available on the
74Internet from one of my home pages:
75  http://www.student.informatik.tu-darmstadt.de/~tek/projects/linux.html
76or:
77  http://www.tu-darmstadt.de/~tek01/projects/linux.html
78
79Bugreports, bugfixes and related questions should be sent via E-Mail to:
80  tek@rbg.informatik.tu-darmstadt.de
81
82Thorsten Knabe <tek@rbg.informatik.tu-darmstadt.de>
83Christoph Hellwig <hch@infradead.org>
84	Last modified: 2000/09/20
85