Searched refs:DSL (Results 1 – 25 of 26) sorted by relevance
12
| /linux-6.1.9/drivers/usb/atm/ |
| D | Kconfig | 3 # USB/ATM DSL configuration
7 tristate "USB DSL modem support"
11 Say Y here if you want to connect a USB Digital Subscriber Line (DSL)
45 tristate "ADI 930 and eagle USB DSL modem"
57 tristate "Other USB DSL modem support"
59 Say Y here if you have a DSL USB modem not explicitly supported by
60 another USB DSL drivers. In order to use your modem you will need to
|
| /linux-6.1.9/Documentation/devicetree/bindings/arm/bcm/ |
| D | brcm,bcm63138.txt | 1 Broadcom BCM63138 DSL System-on-a-Chip device tree bindings
4 Boards compatible with the BCM63138 DSL System-on-a-Chip should have the
|
| D | brcm,bcmbca.yaml | 10 Broadcom Broadband SoCs include family of high performance DSL/PON/Wireless
|
| /linux-6.1.9/drivers/clk/bcm/ |
| D | Kconfig | 29 Enable common clock framework support for Broadcom BCM63xx DSL SoCs
37 Enable common clock framework support for Broadcom BCM63xx DSL SoCs
|
| /linux-6.1.9/arch/arm/mach-bcm/ |
| D | Kconfig | 213 including the DSL, PON and Wireless family of chips.
226 including various DSL, PON and Wireless family of chips.
242 only DSL chip BCM63138.
252 only DSL chip BCM63148.
|
| /linux-6.1.9/drivers/isdn/ |
| D | Kconfig | 16 (though still much slower than with DSL) or to make and accept
|
| /linux-6.1.9/Documentation/devicetree/bindings/sound/ |
| D | brcm,bcm63xx-audio.txt | 1 Broadcom DSL/PON BCM63xx Audio I2S controller
|
| /linux-6.1.9/sound/soc/bcm/ |
| D | Kconfig | 26 DSL/PON chips (bcm63158, bcm63178)
|
| /linux-6.1.9/drivers/mtd/nand/raw/brcmnand/ |
| D | Kconfig | 17 on Broadcom BCM63xx MIPS-based DSL platforms.
|
| /linux-6.1.9/Documentation/devicetree/bindings/gpio/ |
| D | gpio-stp-xway.yaml | 12 3 groups of 8 bits can be driven. The hardware is able to allow the DSL modem
|
| /linux-6.1.9/net/atm/ |
| D | Kconfig | 66 This is sometimes used over DSL lines. If in doubt, say N.
|
| /linux-6.1.9/arch/arm/boot/dts/ |
| D | bcm63138.dtsi | 3 * Broadcom BCM63138 DSL SoCs Device Tree
|
| D | kirkwood-l-50.dts | 75 * 1: DSL module reset (active low)
|
| /linux-6.1.9/Documentation/devicetree/bindings/mips/brcm/ |
| D | soc.txt | 1 * Broadcom cable/DSL/settop platforms
|
| /linux-6.1.9/drivers/net/ethernet/dec/tulip/ |
| D | de2104x.c | 83 #define DSL 0 macro
85 #define DSL CONFIG_DE2104X_DSL macro
159 DescSkipLen = (DSL << 2),
274 #if DSL
275 __le32 skip[DSL];
|
| /linux-6.1.9/sound/pci/emu10k1/ |
| D | emu10k1_callback.c | 399 snd_emu10k1_ptr_write(hw, DSL, ch, temp); in start_voice()
|
| D | emu10k1_main.c | 69 snd_emu10k1_ptr_write(emu, DSL, ch, 0x10); in snd_emu10k1_voice_init()
2001 CPF, PTRX, CVCF, VTFT, Z1, Z2, PSST, DSL, CCCA, CCR, CLP,
|
| D | emupcm.c | 349 snd_emu10k1_ptr_write(emu, DSL, voice, end_addr | (send_amount[3] << 24)); in snd_emu10k1_pcm_init_voice()
|
| /linux-6.1.9/arch/arm64/ |
| D | Kconfig.platforms | 71 including the DSL, PON and Wireless family of chips.
|
| /linux-6.1.9/include/sound/ |
| D | emu10k1.h | 396 #define DSL 0x07 /* Send D amount and loop start address register */ macro
|
| /linux-6.1.9/drivers/atm/ |
| D | Kconfig | 38 have the code to drive the on-board Alcatel DSL chipset (yet).
|
| /linux-6.1.9/drivers/i2c/busses/ |
| D | Kconfig | 490 tristate "BRCM Settop/DSL I2C controller"
496 I2C interface on the Broadcom Settop/DSL SoCs.
|
| /linux-6.1.9/drivers/gpio/ |
| D | Kconfig | 619 Some of the GPIOs/LEDs can be auto updated by the SoC with DSL and
|
| /linux-6.1.9/drivers/tty/serial/ |
| D | Kconfig | 1079 BCM63xx/BCM63xxx (DSL)
|
| /linux-6.1.9/arch/mips/ |
| D | Kconfig | 299 BCM33xx cable modem chips, BCM63xx DSL chips, and BCM7xxx set-top
|
12