Searched refs:resistors (Results 1 – 17 of 17) sorted by relevance
406 char *resistors = ""; in ds1305_proc() local422 resistors = "2k Ohm"; in ds1305_proc()425 resistors = "4k Ohm"; in ds1305_proc()428 resistors = "8k Ohm"; in ds1305_proc()439 diodes, resistors); in ds1305_proc()
20 of external resistors, so the user cannot change it. Values seen so
38 registers. If a set of voltage divider resistors is installed, calculate the
75 external scaling resistors. This external scaling needs to be compensated for80 The board level scaling resistors according to VIA's recommendation are as
43 rely on the sense resistors listed in Table 2: "Sense Resistor Values".
18 range using external resistors. Since the values of these resistors131 Actual voltage depends on the scaling resistors on the137 do scale, because of internal resistors built into a chip.
59 The voltage inputs have internal scaling resistors so that the following60 voltage can be measured without external resistors:
57 need external resistors. An exception is in0, which is used to monitor
142 well as the values of the resistors used for division is left to the
102 monitored efficiently with internal scaling resistors.
69 scaling resistors. The values returned by the driver therefore reflect true
184 resistors fitted so that the card detects for193 resistors fitted so that the card detects for
154 pull-up resistors enabled. This can be configured by the following
240 resistors on each of the direction and button signals, like this:
136 some analog joysticks, that either do not use linear resistors, or if you
452 (When a circuit needs 5 kOhm, on-chip 100 kOhm resistors won't do.)
106 with four BNC connectors containing four 47 Ohm resistors:110 -R-+-R- R 47 Ohm resistors