1 // SPDX-License-Identifier: GPL-2.0+
2 /*
3 * ehci-omap.c - driver for USBHOST on OMAP3/4 processors
4 *
5 * Bus Glue for the EHCI controllers in OMAP3/4
6 * Tested on several OMAP3 boards, and OMAP4 Pandaboard
7 *
8 * Copyright (C) 2007-2013 Texas Instruments, Inc.
9 * Author: Vikram Pandita <vikram.pandita@ti.com>
10 * Author: Anand Gadiyar <gadiyar@ti.com>
11 * Author: Keshava Munegowda <keshava_mgowda@ti.com>
12 * Author: Roger Quadros <rogerq@ti.com>
13 *
14 * Copyright (C) 2009 Nokia Corporation
15 * Contact: Felipe Balbi <felipe.balbi@nokia.com>
16 *
17 * Based on "ehci-fsl.c" and "ehci-au1xxx.c" ehci glue layers
18 */
19
20 #include <linux/kernel.h>
21 #include <linux/module.h>
22 #include <linux/io.h>
23 #include <linux/platform_device.h>
24 #include <linux/slab.h>
25 #include <linux/usb/ulpi.h>
26 #include <linux/pm_runtime.h>
27 #include <linux/clk.h>
28 #include <linux/usb.h>
29 #include <linux/usb/hcd.h>
30 #include <linux/of.h>
31 #include <linux/dma-mapping.h>
32
33 #include "ehci.h"
34
35 #include <linux/platform_data/usb-omap.h>
36
37 /* EHCI Register Set */
38 #define EHCI_INSNREG04 (0xA0)
39 #define EHCI_INSNREG04_DISABLE_UNSUSPEND (1 << 5)
40 #define EHCI_INSNREG05_ULPI (0xA4)
41 #define EHCI_INSNREG05_ULPI_CONTROL_SHIFT 31
42 #define EHCI_INSNREG05_ULPI_PORTSEL_SHIFT 24
43 #define EHCI_INSNREG05_ULPI_OPSEL_SHIFT 22
44 #define EHCI_INSNREG05_ULPI_REGADD_SHIFT 16
45 #define EHCI_INSNREG05_ULPI_EXTREGADD_SHIFT 8
46 #define EHCI_INSNREG05_ULPI_WRDATA_SHIFT 0
47
48 #define DRIVER_DESC "OMAP-EHCI Host Controller driver"
49
50 static const char hcd_name[] = "ehci-omap";
51
52 /*-------------------------------------------------------------------------*/
53
54 struct omap_hcd {
55 struct usb_phy *phy[OMAP3_HS_USB_PORTS]; /* one PHY for each port */
56 int nports;
57 };
58
ehci_write(void __iomem * base,u32 reg,u32 val)59 static inline void ehci_write(void __iomem *base, u32 reg, u32 val)
60 {
61 __raw_writel(val, base + reg);
62 }
63
64 /* configure so an HC device and id are always provided */
65 /* always called with process context; sleeping is OK */
66
67 static struct hc_driver __read_mostly ehci_omap_hc_driver;
68
69 static const struct ehci_driver_overrides ehci_omap_overrides __initconst = {
70 .extra_priv_size = sizeof(struct omap_hcd),
71 };
72
73 /**
74 * ehci_hcd_omap_probe - initialize TI-based HCDs
75 * @pdev: Pointer to this platform device's information
76 *
77 * Allocates basic resources for this USB host controller, and
78 * then invokes the start() method for the HCD associated with it
79 * through the hotplug entry's driver_data.
80 */
ehci_hcd_omap_probe(struct platform_device * pdev)81 static int ehci_hcd_omap_probe(struct platform_device *pdev)
82 {
83 struct device *dev = &pdev->dev;
84 struct usbhs_omap_platform_data *pdata = dev_get_platdata(dev);
85 struct resource *res;
86 struct usb_hcd *hcd;
87 void __iomem *regs;
88 int ret;
89 int irq;
90 int i;
91 struct omap_hcd *omap;
92
93 if (usb_disabled())
94 return -ENODEV;
95
96 if (!dev->parent) {
97 dev_err(dev, "Missing parent device\n");
98 return -ENODEV;
99 }
100
101 /* For DT boot, get platform data from parent. i.e. usbhshost */
102 if (dev->of_node) {
103 pdata = dev_get_platdata(dev->parent);
104 dev->platform_data = pdata;
105 }
106
107 if (!pdata) {
108 dev_err(dev, "Missing platform data\n");
109 return -ENODEV;
110 }
111
112 irq = platform_get_irq(pdev, 0);
113 if (irq < 0)
114 return irq;
115
116 res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
117 regs = devm_ioremap_resource(dev, res);
118 if (IS_ERR(regs))
119 return PTR_ERR(regs);
120
121 /*
122 * Right now device-tree probed devices don't get dma_mask set.
123 * Since shared usb code relies on it, set it here for now.
124 * Once we have dma capability bindings this can go away.
125 */
126 ret = dma_coerce_mask_and_coherent(dev, DMA_BIT_MASK(32));
127 if (ret)
128 return ret;
129
130 ret = -ENODEV;
131 hcd = usb_create_hcd(&ehci_omap_hc_driver, dev,
132 dev_name(dev));
133 if (!hcd) {
134 dev_err(dev, "Failed to create HCD\n");
135 return -ENOMEM;
136 }
137
138 hcd->rsrc_start = res->start;
139 hcd->rsrc_len = resource_size(res);
140 hcd->regs = regs;
141 hcd_to_ehci(hcd)->caps = regs;
142
143 omap = (struct omap_hcd *)hcd_to_ehci(hcd)->priv;
144 omap->nports = pdata->nports;
145
146 platform_set_drvdata(pdev, hcd);
147
148 /* get the PHY devices if needed */
149 for (i = 0 ; i < omap->nports ; i++) {
150 struct usb_phy *phy;
151
152 /* get the PHY device */
153 phy = devm_usb_get_phy_by_phandle(dev, "phys", i);
154 if (IS_ERR(phy)) {
155 ret = PTR_ERR(phy);
156 if (ret == -ENODEV) { /* no PHY */
157 phy = NULL;
158 continue;
159 }
160
161 if (ret != -EPROBE_DEFER)
162 dev_err(dev, "Can't get PHY for port %d: %d\n",
163 i, ret);
164 goto err_phy;
165 }
166
167 omap->phy[i] = phy;
168
169 if (pdata->port_mode[i] == OMAP_EHCI_PORT_MODE_PHY) {
170 usb_phy_init(omap->phy[i]);
171 /* bring PHY out of suspend */
172 usb_phy_set_suspend(omap->phy[i], 0);
173 }
174 }
175
176 pm_runtime_enable(dev);
177 pm_runtime_get_sync(dev);
178
179 /*
180 * An undocumented "feature" in the OMAP3 EHCI controller,
181 * causes suspended ports to be taken out of suspend when
182 * the USBCMD.Run/Stop bit is cleared (for example when
183 * we do ehci_bus_suspend).
184 * This breaks suspend-resume if the root-hub is allowed
185 * to suspend. Writing 1 to this undocumented register bit
186 * disables this feature and restores normal behavior.
187 */
188 ehci_write(regs, EHCI_INSNREG04,
189 EHCI_INSNREG04_DISABLE_UNSUSPEND);
190
191 ret = usb_add_hcd(hcd, irq, IRQF_SHARED);
192 if (ret) {
193 dev_err(dev, "failed to add hcd with err %d\n", ret);
194 goto err_pm_runtime;
195 }
196 device_wakeup_enable(hcd->self.controller);
197
198 /*
199 * Bring PHYs out of reset for non PHY modes.
200 * Even though HSIC mode is a PHY-less mode, the reset
201 * line exists between the chips and can be modelled
202 * as a PHY device for reset control.
203 */
204 for (i = 0; i < omap->nports; i++) {
205 if (!omap->phy[i] ||
206 pdata->port_mode[i] == OMAP_EHCI_PORT_MODE_PHY)
207 continue;
208
209 usb_phy_init(omap->phy[i]);
210 /* bring PHY out of suspend */
211 usb_phy_set_suspend(omap->phy[i], 0);
212 }
213
214 return 0;
215
216 err_pm_runtime:
217 pm_runtime_put_sync(dev);
218 pm_runtime_disable(dev);
219
220 err_phy:
221 for (i = 0; i < omap->nports; i++) {
222 if (omap->phy[i])
223 usb_phy_shutdown(omap->phy[i]);
224 }
225
226 usb_put_hcd(hcd);
227
228 return ret;
229 }
230
231
232 /**
233 * ehci_hcd_omap_remove - shutdown processing for EHCI HCDs
234 * @pdev: USB Host Controller being removed
235 *
236 * Reverses the effect of usb_ehci_hcd_omap_probe(), first invoking
237 * the HCD's stop() method. It is always called from a thread
238 * context, normally "rmmod", "apmd", or something similar.
239 */
ehci_hcd_omap_remove(struct platform_device * pdev)240 static int ehci_hcd_omap_remove(struct platform_device *pdev)
241 {
242 struct device *dev = &pdev->dev;
243 struct usb_hcd *hcd = dev_get_drvdata(dev);
244 struct omap_hcd *omap = (struct omap_hcd *)hcd_to_ehci(hcd)->priv;
245 int i;
246
247 usb_remove_hcd(hcd);
248
249 for (i = 0; i < omap->nports; i++) {
250 if (omap->phy[i])
251 usb_phy_shutdown(omap->phy[i]);
252 }
253
254 usb_put_hcd(hcd);
255 pm_runtime_put_sync(dev);
256 pm_runtime_disable(dev);
257
258 return 0;
259 }
260
261 static const struct of_device_id omap_ehci_dt_ids[] = {
262 { .compatible = "ti,ehci-omap" },
263 { }
264 };
265
266 MODULE_DEVICE_TABLE(of, omap_ehci_dt_ids);
267
268 static struct platform_driver ehci_hcd_omap_driver = {
269 .probe = ehci_hcd_omap_probe,
270 .remove = ehci_hcd_omap_remove,
271 .shutdown = usb_hcd_platform_shutdown,
272 /*.suspend = ehci_hcd_omap_suspend, */
273 /*.resume = ehci_hcd_omap_resume, */
274 .driver = {
275 .name = hcd_name,
276 .of_match_table = omap_ehci_dt_ids,
277 }
278 };
279
280 /*-------------------------------------------------------------------------*/
281
ehci_omap_init(void)282 static int __init ehci_omap_init(void)
283 {
284 if (usb_disabled())
285 return -ENODEV;
286
287 pr_info("%s: " DRIVER_DESC "\n", hcd_name);
288
289 ehci_init_driver(&ehci_omap_hc_driver, &ehci_omap_overrides);
290 return platform_driver_register(&ehci_hcd_omap_driver);
291 }
292 module_init(ehci_omap_init);
293
ehci_omap_cleanup(void)294 static void __exit ehci_omap_cleanup(void)
295 {
296 platform_driver_unregister(&ehci_hcd_omap_driver);
297 }
298 module_exit(ehci_omap_cleanup);
299
300 MODULE_ALIAS("platform:ehci-omap");
301 MODULE_AUTHOR("Texas Instruments, Inc.");
302 MODULE_AUTHOR("Felipe Balbi <felipe.balbi@nokia.com>");
303 MODULE_AUTHOR("Roger Quadros <rogerq@ti.com>");
304
305 MODULE_DESCRIPTION(DRIVER_DESC);
306 MODULE_LICENSE("GPL");
307