1#
2# 1-wire slaves configuration
3#
4
5menu "1-wire Slaves"
6
7config W1_SLAVE_THERM
8	tristate "Thermal family implementation"
9	help
10	  Say Y here if you want to connect 1-wire thermal sensors to your
11	  wire.
12
13config W1_SLAVE_SMEM
14	tristate "Simple 64bit memory family implementation"
15	help
16	  Say Y here if you want to connect 1-wire
17	  simple 64bit memory rom(ds2401/ds2411/ds1990*) to your wire.
18
19config W1_SLAVE_DS2423
20	tristate "Counter 1-wire device (DS2423)"
21	select CRC16
22	help
23	  If you enable this you can read the counter values available
24	  in the DS2423 chipset from the w1_slave file under the
25	  sys file system.
26
27	  Say Y here if you want to use a 1-wire
28	  counter family device (DS2423).
29
30config W1_SLAVE_DS2431
31	tristate "1kb EEPROM family support (DS2431)"
32	help
33	  Say Y here if you want to use a 1-wire
34	  1kb EEPROM family device (DS2431)
35
36config W1_SLAVE_DS2433
37	tristate "4kb EEPROM family support (DS2433)"
38	help
39	  Say Y here if you want to use a 1-wire
40	  4kb EEPROM family device (DS2433).
41
42config W1_SLAVE_DS2433_CRC
43	bool "Protect DS2433 data with a CRC16"
44	depends on W1_SLAVE_DS2433
45	select CRC16
46	help
47	  Say Y here to protect DS2433 data with a CRC16.
48	  Each block has 30 bytes of data and a two byte CRC16.
49	  Full block writes are only allowed if the CRC is valid.
50
51config W1_SLAVE_DS2760
52	tristate "Dallas 2760 battery monitor chip (HP iPAQ & others)"
53	depends on W1
54	help
55	  If you enable this you will have the DS2760 battery monitor
56	  chip support.
57
58	  The battery monitor chip is used in many batteries/devices
59	  as the one who is responsible for charging/discharging/monitoring
60	  Li+ batteries.
61
62	  If you are unsure, say N.
63
64config W1_SLAVE_BQ27000
65	tristate "BQ27000 slave support"
66	depends on W1
67	help
68	  Say Y here if you want to use a hdq
69	  bq27000 slave support.
70
71endmenu
72