1 /* 2 * linux/arch/alpha/kernel/pci_impl.h 3 * 4 * This file contains declarations and inline functions for interfacing 5 * with the PCI initialization routines. 6 */ 7 8 struct pci_dev; 9 struct pci_controller; 10 struct pci_iommu_arena; 11 12 /* 13 * We can't just blindly use 64K for machines with EISA busses; they 14 * may also have PCI-PCI bridges present, and then we'd configure the 15 * bridge incorrectly. 16 * 17 * Also, we start at 0x8000 or 0x9000, in hopes to get all devices' 18 * IO space areas allocated *before* 0xC000; this is because certain 19 * BIOSes (Millennium for one) use PCI Config space "mechanism #2" 20 * accesses to probe the bus. If a device's registers appear at 0xC000, 21 * it may see an INx/OUTx at that address during BIOS emulation of the 22 * VGA BIOS, and some cards, notably Adaptec 2940UW, take mortal offense. 23 */ 24 25 #define EISA_DEFAULT_IO_BASE 0x9000 /* start above 8th slot */ 26 #define DEFAULT_IO_BASE 0x8000 /* start at 8th slot */ 27 28 /* 29 * We try to make the DEFAULT_MEM_BASE addresses *always* have more than 30 * a single bit set. This is so that devices like the broken Myrinet card 31 * will always have a PCI memory address that will never match a IDSEL 32 * address in PCI Config space, which can cause problems with early rev cards. 33 */ 34 35 /* 36 * An XL is AVANTI (APECS) family, *but* it has only 27 bits of ISA address 37 * that get passed through the PCI<->ISA bridge chip. Although this causes 38 * us to set the PCI->Mem window bases lower than normal, we still allocate 39 * PCI bus devices' memory addresses *below* the low DMA mapping window, 40 * and hope they fit below 64Mb (to avoid conflicts), and so that they can 41 * be accessed via SPARSE space. 42 * 43 * We accept the risk that a broken Myrinet card will be put into a true XL 44 * and thus can more easily run into the problem described below. 45 */ 46 #define XL_DEFAULT_MEM_BASE ((16+2)*1024*1024) /* 16M to 64M-1 is avail */ 47 48 /* 49 * APECS and LCA have only 34 bits for physical addresses, thus limiting PCI 50 * bus memory addresses for SPARSE access to be less than 128Mb. 51 */ 52 #define APECS_AND_LCA_DEFAULT_MEM_BASE ((16+2)*1024*1024) 53 54 /* 55 * Because MCPCIA and T2 core logic support more bits for 56 * physical addresses, they should allow an expanded range of SPARSE 57 * memory addresses. However, we do not use them all, in order to 58 * avoid the HAE manipulation that would be needed. 59 */ 60 #define MCPCIA_DEFAULT_MEM_BASE ((32+2)*1024*1024) 61 #define T2_DEFAULT_MEM_BASE ((16+1)*1024*1024) 62 63 /* 64 * Because CIA and PYXIS have more bits for physical addresses, 65 * they support an expanded range of SPARSE memory addresses. 66 */ 67 #define DEFAULT_MEM_BASE ((128+16)*1024*1024) 68 69 /* ??? Experimenting with no HAE for CIA. */ 70 #define CIA_DEFAULT_MEM_BASE ((32+2)*1024*1024) 71 72 #define IRONGATE_DEFAULT_MEM_BASE ((256*8-16)*1024*1024) 73 74 #define DEFAULT_AGP_APER_SIZE (64*1024*1024) 75 76 /* 77 * A small note about bridges and interrupts. The DECchip 21050 (and 78 * later) adheres to the PCI-PCI bridge specification. This says that 79 * the interrupts on the other side of a bridge are swizzled in the 80 * following manner: 81 * 82 * Dev Interrupt Interrupt 83 * Pin on Pin on 84 * Device Connector 85 * 86 * 4 A A 87 * B B 88 * C C 89 * D D 90 * 91 * 5 A B 92 * B C 93 * C D 94 * D A 95 * 96 * 6 A C 97 * B D 98 * C A 99 * D B 100 * 101 * 7 A D 102 * B A 103 * C B 104 * D C 105 * 106 * Where A = pin 1, B = pin 2 and so on and pin=0 = default = A. 107 * Thus, each swizzle is ((pin-1) + (device#-4)) % 4 108 * 109 * pci_swizzle_interrupt_pin() swizzles for exactly one bridge. The routine 110 * pci_common_swizzle() handles multiple bridges. But there are a 111 * couple boards that do strange things. 112 */ 113 114 115 /* The following macro is used to implement the table-based irq mapping 116 function for all single-bus Alphas. */ 117 118 #define COMMON_TABLE_LOOKUP \ 119 ({ long _ctl_ = -1; \ 120 if (slot >= min_idsel && slot <= max_idsel && pin < irqs_per_slot) \ 121 _ctl_ = irq_tab[slot - min_idsel][pin]; \ 122 _ctl_; }) 123 124 125 /* A PCI IOMMU allocation arena. There are typically two of these 126 regions per bus. */ 127 /* ??? The 8400 has a 32-byte pte entry, and the entire table apparently 128 lives directly on the host bridge (no tlb?). We don't support this 129 machine, but if we ever did, we'd need to parameterize all this quite 130 a bit further. Probably with per-bus operation tables. */ 131 132 struct pci_iommu_arena 133 { 134 spinlock_t lock; 135 struct pci_controller *hose; 136 #define IOMMU_INVALID_PTE 0x2 /* 32:63 bits MBZ */ 137 #define IOMMU_RESERVED_PTE 0xface 138 unsigned long *ptes; 139 dma_addr_t dma_base; 140 unsigned int size; 141 unsigned int next_entry; 142 unsigned int align_entry; 143 }; 144 145 #if defined(CONFIG_ALPHA_SRM) && \ 146 (defined(CONFIG_ALPHA_CIA) || defined(CONFIG_ALPHA_LCA)) 147 # define NEED_SRM_SAVE_RESTORE 148 #else 149 # undef NEED_SRM_SAVE_RESTORE 150 #endif 151 152 #if defined(CONFIG_ALPHA_GENERIC) || defined(NEED_SRM_SAVE_RESTORE) 153 # define ALPHA_RESTORE_SRM_SETUP 154 #else 155 # undef ALPHA_RESTORE_SRM_SETUP 156 #endif 157 158 #ifdef ALPHA_RESTORE_SRM_SETUP 159 /* Store PCI device configuration left by SRM here. */ 160 struct pdev_srm_saved_conf 161 { 162 struct pdev_srm_saved_conf *next; 163 struct pci_dev *dev; 164 }; 165 166 extern void pci_restore_srm_config(void); 167 #else 168 #define pdev_save_srm_config(dev) do {} while (0) 169 #define pci_restore_srm_config() do {} while (0) 170 #endif 171 172 /* The hose list. */ 173 extern struct pci_controller *hose_head, **hose_tail; 174 extern struct pci_controller *pci_isa_hose; 175 176 /* Indicate that we trust the console to configure things properly. */ 177 extern int pci_probe_only; 178 179 extern unsigned long alpha_agpgart_size; 180 181 extern void common_init_pci(void); 182 #define common_swizzle pci_common_swizzle 183 extern struct pci_controller *alloc_pci_controller(void); 184 extern struct resource *alloc_resource(void); 185 186 extern struct pci_iommu_arena *iommu_arena_new_node(int, 187 struct pci_controller *, 188 dma_addr_t, unsigned long, 189 unsigned long); 190 extern struct pci_iommu_arena *iommu_arena_new(struct pci_controller *, 191 dma_addr_t, unsigned long, 192 unsigned long); 193 extern const char *const pci_io_names[]; 194 extern const char *const pci_mem_names[]; 195 extern const char pci_hae0_name[]; 196 197 extern unsigned long size_for_memory(unsigned long max); 198 199 extern int iommu_reserve(struct pci_iommu_arena *, long, long); 200 extern int iommu_release(struct pci_iommu_arena *, long, long); 201 extern int iommu_bind(struct pci_iommu_arena *, long, long, struct page **); 202 extern int iommu_unbind(struct pci_iommu_arena *, long, long); 203 204 205