Searched refs:connections (Results 1 – 25 of 34) sorted by relevance
12
| /linux-2.4.37.9/Documentation/networking/ |
| D | ip_dynaddr.txt | 3 This stuff allows diald ONESHOT connections to get established by
5 It is implemented for TCP diald-box connections(1) and IP_MASQuerading(2).
16 going up. So, the *same* (local AND masqueraded) connections requests that
|
| D | proc_net_tcp.txt | 4 connections, and are implemented by tcp_get_info() in net/ipv4/tcp_ipv4.c and
8 TCP connections. A typical entry of /proc/net/tcp would look like this (split
|
| D | eql.txt | 177 The general idea is to bring up and keep up as many SLIP connections
233 connections for use with the eql driver the weekend of Feb 25-26 '95
252 28800 and 14400 connections, but when the priorities on the links were
349 to bundle multiple SLIP connections into what appears to be a
359 of SLIP connections run between two Linux systems (1.1.84) using
|
| D | ip-sysctl.txt | 134 Allow to reuse TIME-WAIT sockets for new connections when it is
141 held by system. If this number is exceeded orphaned connections are
152 If listening service is too slow to accept new connections,
156 cannot be tuned to accept connections faster. Enabling this
169 because of overload with legal connections, you should tune
337 This number defines number of active connections, which this
341 2000 connections per second to systems supporting timestamps.
|
| D | wan-router.txt | 15 connections.
39 connections (known as `virtual circuits' in X.25 terminology) over a single
48 to implement on-demand connections in order to minimize network charges. So
57 when troubleshooting WAN connections. Extending the ifconfig utility to suit
148 for async connections.
|
| D | wanpipe.txt | 15 connections.
39 connections (known as `virtual circuits' in X.25 terminology) over a single
48 to implement on-demand connections in order to minimize network charges. So
57 when troubleshooting WAN connections. Extending the ifconfig utility to suit
148 for async connections.
|
| D | e1000.txt | 113 (Supported only on adapters with copper connections)
127 (Supported only on adapters with copper connections)
289 (This parameter is supported only on adapters with copper connections.)
|
| /linux-2.4.37.9/drivers/usb/serial/ |
| D | visor.h | 92 } connections[2]; member
140 } connections[2]; member
|
| D | visor.c | 786 switch (connection_info->connections[i].port_function_id) { in visor_startup()
807 connection_info->connections[i].port, string, serial->minor + i); in visor_startup()
|
| /linux-2.4.37.9/drivers/net/wan/8253x/ |
| D | sab8253xov.txt | 8 connections to asynchronous TTYs with the standard Linux/Unix terminal
10 can also support connections to computers that support standard
18 for synchronous TTY connections. Because one cannot generally purchase
|
| /linux-2.4.37.9/Documentation/isdn/ |
| D | README.x25 | 23 - Monitor your isdn connections while using this software. This should
73 It should however be possible to establish such packet mode connections
99 connections on top of the isdnloop driver and the hisax driver.
103 occurs, all existing X.25 connections on that link will be cleared
166 will cause all x.25 connections to the destination X.25-address
|
| D | README.hfc-pci | 13 This reduces the available channels to 1. There must not be open connections
|
| D | README.concap | 22 The encapsulation protocol used on top of WAN connections or permanent
48 Many Encapsulation protocols used on top of WAN connections will not just
77 When operating over dial-up-connections (e.g. telephone lines via modem,
|
| D | README.syncppp | 35 all devices at once. If you want to use two PPP connections
|
| D | README.avmb1 | 96 ncci-cnt: current number of nccis (connections)
|
| D | README | 383 (neither incoming or outgoing connections are possible). Use
384 this if you want to be sure that no connections will be made.
390 Incoming connections are also possible.
392 In this mode, the interface will never make any connections on its
|
| /linux-2.4.37.9/net/802/ |
| D | TODO | 13 According to IEEE, connections are identified by (remote mac + local mac
|
| /linux-2.4.37.9/drivers/usb/gadget/ |
| D | Config.in | 42 # has exactly one of these upstream connections and only one
|
| /linux-2.4.37.9/drivers/s390/net/ |
| D | netiucv.c | 127 iucv_connection *connections; variable
1329 iucv_connection *conn = connections; in find_netdev_by_ino()
1875 iucv_connection **clist = &connections; in netiucv_new_connection()
1927 iucv_connection **clist = &connections; in netiucv_remove_connection()
2093 while (connections) { in netiucv_exit()
2094 net_device *dev = connections->netdev; in netiucv_exit()
|
| /linux-2.4.37.9/arch/m68k/ifpsp060/ |
| D | TEST.DOC | 172 test all 68060SP connections. For example, they do not test connections
|
| /linux-2.4.37.9/drivers/scsi/ |
| D | README.qlogicfas | 47 if you have reliable hardware and connections it may be more useful to
|
| /linux-2.4.37.9/net/khttpd/ |
| D | README | 220 connections
|
| /linux-2.4.37.9/Documentation/sound/ |
| D | Opti | 135 connections to the mixer. The 3 inputs intended for cd, synth
|
| /linux-2.4.37.9/arch/cris/drivers/lpslave/ |
| D | e100lpslave.S | 38 ;; setup DMA connections and port configuration
|
| /linux-2.4.37.9/drivers/net/ |
| D | defxx.h | 906 PI_CNTR connections[PI_PHY_K_MAX]; member
|
12