Home
last modified time | relevance | path

Searched refs:tied (Results 1 – 25 of 60) sorted by relevance

123

/linux-6.6.21/Documentation/security/
Dlandlock.rst55 All access rights are tied to an inode and what can be accessed through it.
62 allowed to be tied to files but only to directories.
67 Access rights are checked and tied to file descriptors at open time. The
112 A domain is a read-only ruleset tied to a set of subjects (i.e. tasks'
115 domain. Indeed, once in a domain, each rule is tied to a layer level. To
/linux-6.6.21/drivers/gpu/drm/nouveau/nvkm/engine/disp/
Dvga.c166 u32 tied = nvkm_rd32(device, 0x001084) & 0x10000000; in nvkm_rdvgaowner() local
167 if (tied == 0) { in nvkm_rdvgaowner()
/linux-6.6.21/Documentation/devicetree/bindings/iio/adc/
Dti,ads8688.yaml26 REFSEL input tied low to enable the internal reference.
Dadi,ad7606.yaml75 this pin is tied to a logic high, the analog input range is ±10V for
76 all channels. If this pin is tied to a logic low, the analog input range
/linux-6.6.21/Documentation/spi/
Dspi-lm70llp.rst66 collector is tied to VCC.
72 hand, the transistor is cut off and the voltage tied to its collector is
/linux-6.6.21/Documentation/driver-api/nvdimm/
Dsecurity.rst93 An key with the current passphrase payload that is tied to the nvdimm should be
101 An key with the current passphrase payload that is tied to the nvdimm should be
115 An encrypted-key with the current user passphrase that is tied to the nvdimm
/linux-6.6.21/security/landlock/
DKconfig12 directory, etc.) tied to a file hierarchy. Such policy can be
/linux-6.6.21/Documentation/devicetree/bindings/mmc/
Dsdhci-atmel.txt22 For instance on SAMA5D2, the pin is usually tied to the GND with a resistor
/linux-6.6.21/Documentation/devicetree/bindings/soc/qcom/
Dqcom,smd.yaml44 # "rpm" subsystem. For the "rpm" subsystem we have a device tied to the
/linux-6.6.21/Documentation/devicetree/bindings/mfd/
Drichtek,rt4831.yaml36 Some usage directly tied this pin to follow VIO 1.8V power on sequence.
/linux-6.6.21/drivers/net/wireless/microchip/wilc1000/
DKconfig37 immediately following reset when pin 9 (SDIO_SPI_CFG) is tied to
/linux-6.6.21/Documentation/userspace-api/media/v4l/
Dmetafmt-intel-ipu3.rst50 Both 3A statistics and pipeline parameters described here are closely tied to
/linux-6.6.21/Documentation/devicetree/bindings/misc/
Dqcom,fastrpc.yaml37 A list of channels tied to this function, used for matching
/linux-6.6.21/arch/powerpc/boot/dts/
Dxpedite5200.dts431 cle-line = <0x8>; /* CLE tied to A3 */
432 ale-line = <0x10>; /* ALE tied to A4 */
Dxpedite5200_xmon.dts435 cle-line = <0x8>; /* CLE tied to A3 */
436 ale-line = <0x10>; /* ALE tied to A4 */
/linux-6.6.21/Documentation/driver-api/media/drivers/
Dcx88-devel.rst66 GPIO 16(I believe) is tied to the IR port (if present).
/linux-6.6.21/arch/arm64/boot/dts/rockchip/
Drk3566-soquartz-cm4.dts62 * the rtc interrupt is tied to PMIC_PWRON,
Drk3566-soquartz-model-a.dts85 * the rtc interrupt is tied to PMIC_PWRON,
/linux-6.6.21/Documentation/devicetree/bindings/remoteproc/
Dqcom,smd-edge.yaml17 In turn, subnodes of the "edges" represent devices tied to SMD channels on
/linux-6.6.21/Documentation/devicetree/bindings/spi/
Dspi-davinci.txt23 lines can be tied to the interrupt controller. Set this
/linux-6.6.21/drivers/clk/samsung/
DKconfig95 status of the certains clocks from SoC, but it could also be tied to
/linux-6.6.21/arch/arm/boot/dts/marvell/
Darmada-388-clearfog.dtsi193 * address pins tied low, which takes addresses 0x50 and 0x51.
/linux-6.6.21/Documentation/fb/
Dep93xx-fb.rst127 the VIDSCRNPAGE (framebuffer physical offset) to be tied low. There is
/linux-6.6.21/Documentation/devicetree/bindings/mtd/
Djedec,spi-nor.yaml84 flash device is not connected or is wrongly tied to GND (that includes internal
/linux-6.6.21/Documentation/networking/device_drivers/ethernet/pensando/
Dionic.rst93 reflects the rx-usecs value as they are tied together on the same interrupt.

123