/linux-6.6.21/drivers/bus/ |
D | ts-nbus.c | 35 struct gpio_desc *rdy; member 76 ts_nbus->rdy = devm_gpiod_get(&pdev->dev, "ts,rdy", GPIOD_IN); in ts_nbus_init_pdata() 77 if (IS_ERR(ts_nbus->rdy)) { in ts_nbus_init_pdata() 79 return PTR_ERR(ts_nbus->rdy); in ts_nbus_init_pdata() 227 ret = gpiod_get_value_cansleep(ts_nbus->rdy); in ts_nbus_read() 262 while (gpiod_get_value_cansleep(ts_nbus->rdy) != 0) { in ts_nbus_write()
|
/linux-6.6.21/drivers/mtd/nand/raw/ |
D | gpio.c | 39 struct gpio_desc *rdy; member 124 if (!gpiomtd->rdy) in gpio_nand_exec_instr() 127 return nand_gpio_waitrdy(chip, gpiomtd->rdy, in gpio_nand_exec_instr() 342 gpiomtd->rdy = devm_gpiod_get_optional(dev, "rdy", GPIOD_IN); in gpio_nand_probe() 343 if (IS_ERR(gpiomtd->rdy)) { in gpio_nand_probe() 344 ret = PTR_ERR(gpiomtd->rdy); in gpio_nand_probe()
|
D | lpc32xx_slc.c | 298 int rdy = 0; in lpc32xx_nand_device_ready() local 301 rdy = 1; in lpc32xx_nand_device_ready() 303 return rdy; in lpc32xx_nand_device_ready()
|
/linux-6.6.21/Documentation/devicetree/bindings/bus/ |
D | ts-nbus.txt | 16 - ts,rdy-gpios : The GPIO pin connected to the rdy line on the FPGA 43 ts,rdy-gpios = <&gpio0 21 GPIO_ACTIVE_HIGH>;
|
D | nvidia,tegra20-gmi.txt | 45 - nvidia,snor-rdy-active-before-data: Assert RDY signal one cycle before data. 47 - nvidia,snor-rdy-active-high: RDY signal is active high
|
/linux-6.6.21/drivers/scsi/aic7xxx/ |
D | aic7xxx_93cx6.c | 95 #define CLOCK_PULSE(sd, rdy) \ argument 96 while ((SEEPROM_STATUS_INB(sd) & rdy) == 0) { \
|
/linux-6.6.21/drivers/input/touchscreen/ |
D | wacom_w8001.c | 60 u8 rdy; member 111 coord->rdy = data[0] & 0x20; in parse_pen_data() 256 input_report_key(dev, w8001->type, coord->rdy); in report_pen_events() 259 if (!coord->rdy) in report_pen_events()
|
/linux-6.6.21/Documentation/devicetree/bindings/phy/ |
D | phy-miphy28lp.txt | 34 - st,osc-rdy : to check the MIPHY0_OSC_RDY status in the glue-logic. This 65 st,osc-rdy;
|
/linux-6.6.21/Documentation/devicetree/bindings/pinctrl/ |
D | lantiq,pinctrl-xway.txt | 67 ebu cs1, ebu wait, nand ale, nand cs1, nand cle, nand rdy, nand rd, 79 ebu cs1, ebu wait, nand ale, nand cs1, nand cle, nand rdy, nand rd, 94 nand rdy, nand rd, nand_d0, nand_d1, nand_d2, nand_d3, nand_d4, nand_d5,
|
/linux-6.6.21/arch/mips/boot/dts/ni/ |
D | 169445.dts | 67 gpios = <&gpio2 0 0>, /* rdy */
|
/linux-6.6.21/arch/arm/boot/dts/st/ |
D | stih418-b2199.dts | 43 st,osc-rdy;
|
D | stih418-b2264.dts | 121 st,osc-rdy;
|
D | stihxxx-b2120.dtsi | 77 st,osc-rdy;
|
/linux-6.6.21/drivers/crypto/amcc/ |
D | crypto4xx_reg_def.h | 231 u32 rdy:1; member
|
D | crypto4xx_core.c | 893 sd->ctl.rdy = 1; in crypto4xx_build_pd() 904 sd->ctl.rdy = 1; in crypto4xx_build_pd()
|
/linux-6.6.21/Documentation/devicetree/bindings/spi/ |
D | fsl-imx-cspi.yaml | 75 fsl,spi-rdy-drctl:
|
/linux-6.6.21/Documentation/devicetree/bindings/mtd/ |
D | atmel-nand.txt | 181 gpios = <&pioC 13 0 /* rdy */ 208 gpios = <&pioD 5 0 /* rdy */
|
/linux-6.6.21/sound/pci/ |
D | sis7019.c | 895 u16 rdy; in sis_ac97_rw() local 903 rdy = codec_ready[codec]; in sis_ac97_rw() 923 if ((status & rdy) && !(status & SIS_AC97_STATUS_BUSY)) in sis_ac97_rw()
|
/linux-6.6.21/drivers/scsi/be2iscsi/ |
D | be_cmds.c | 1617 u32 loop, post, rdy = 0; in beiscsi_check_fw_rdy() local 1625 rdy = 1; in beiscsi_check_fw_rdy() 1631 if (!rdy) { in beiscsi_check_fw_rdy() 1636 return rdy; in beiscsi_check_fw_rdy()
|
/linux-6.6.21/drivers/scsi/hisi_sas/ |
D | hisi_sas.h | 654 extern void hisi_sas_phy_down(struct hisi_hba *hisi_hba, int phy_no, int rdy,
|
D | hisi_sas_main.c | 2036 void hisi_sas_phy_down(struct hisi_hba *hisi_hba, int phy_no, int rdy, in hisi_sas_phy_down() argument 2043 if (rdy) { in hisi_sas_phy_down()
|
/linux-6.6.21/arch/arm/boot/dts/rockchip/ |
D | rk3036.dtsi | 756 flash_rdy: flash-rdy {
|
D | rk3128.dtsi | 715 flash_rdy: flash-rdy {
|
/linux-6.6.21/drivers/net/wireless/cisco/ |
D | airo.c | 1007 unsigned int rdy: 1; member 2603 ai->rxfids[i].rx_desc.rdy = 0; in mpi_map_card() 3665 if (rxd.rdy && rxd.valid == 0) { in mpi_receive_802_3() 3718 rxd.rdy = 0; in mpi_receive_802_3() 3804 rxd.rdy = 0; in mpi_receive_802_11()
|
/linux-6.6.21/drivers/hid/ |
D | wacom_wac.c | 3145 bool range, prox, rdy; in wacom_bpt_pen() local 3152 rdy = (data[1] & 0x20) == 0x20; in wacom_bpt_pen() 3158 if (rdy) { in wacom_bpt_pen()
|