Searched refs:operate (Results 1 – 25 of 224) sorted by relevance
123456789
| /linux-6.6.21/Documentation/arch/mips/ |
| D | ingenic-tcu.rst | 29 operate.
35 - On the oldest SoCs (up to JZ4740), all of the eight channels operate in
37 - On JZ4725B, channel 5 operates as TCU2, the others operate as TCU1.
38 - On newest SoCs (JZ4750 and above), channels 1-2 operate as TCU2, the
39 others operate as TCU1.
|
| /linux-6.6.21/Documentation/devicetree/bindings/phy/ |
| D | microchip,sparx5-serdes.yaml | 31 The SERDES6G is a high-speed SERDES interface, which can operate at
41 The SERDES10G is a high-speed SERDES interface, which can operate at
54 The SERDES25G is a high-speed SERDES interface, which can operate at
|
| /linux-6.6.21/Documentation/devicetree/bindings/power/supply/ |
| D | qcom,pm8941-charger.yaml | 54 Battery voltage limit in uV above which fast charging may operate; Defaults to 3.2V
55 Below this value linear or switch-mode auto-trickle-charging will operate.
62 Battery voltage limit in uV below which fast charging may operate; Defaults to 4.2V
98 Input voltage level in uV above which charging may operate. Defaults to 4.3V.
|
| /linux-6.6.21/drivers/firmware/arm_scmi/ |
| D | Kconfig | 55 operate normally, thing which could make an SCMI test suite using the
120 If you want the SCMI SMC based transport to operate in atomic
124 transport to optionally ask for atomic SCMI transactions and operate
160 If you want the SCMI VirtIO based transport to operate in atomic
165 transport to optionally ask for atomic SCMI transactions and operate
|
| /linux-6.6.21/Documentation/devicetree/bindings/mtd/ |
| D | microchip,mchp23k256.txt | 8 - spi-max-frequency : Maximum frequency of the SPI bus the chip can operate at
|
| /linux-6.6.21/Documentation/arch/sh/ |
| D | booting.rst | 9 inter-operate with old bootloaders must either use a builtin DTB or
|
| /linux-6.6.21/Documentation/scsi/ |
| D | bnx2fc.rst | 13 depend on the state of the network interfaces to operate. As such, the network
28 2. Configure the interfaces on which bnx2fc driver has to operate on.
|
| /linux-6.6.21/Documentation/devicetree/bindings/ipmi/ |
| D | aspeed,ast2400-ibt-bmc.txt | 19 interrupt, the driver will operate in poll mode.
|
| /linux-6.6.21/drivers/pci/endpoint/ |
| D | Kconfig | 14 controller that can operate in endpoint mode.
|
| /linux-6.6.21/Documentation/devicetree/bindings/serial/ |
| D | nxp,sc16is7xx.txt | 25 should operate in IrDA mode.
84 should operate in IrDA mode.
|
| /linux-6.6.21/drivers/usb/dwc2/ |
| D | Kconfig | 35 driver to operate in Host-only mode.
45 driver to operate in Peripheral-only mode. This option requires
|
| /linux-6.6.21/Documentation/devicetree/bindings/timer/ |
| D | ti,keystone-timer.txt | 6 timers, each half can operate in conjunction (chain mode) or independently
|
| D | ti,davinci-timer.txt | 6 timers, each half can operate in conjunction (chain mode) or independently
|
| D | renesas,ostm.yaml | 15 can operate in either interval count down timer or free-running compare match
|
| /linux-6.6.21/Documentation/driver-api/ |
| D | mailbox.rst | 43 The client might want to operate in blocking mode (synchronously
106 dc_sync->cl.tx_done = NULL; /* operate in blocking mode */
|
| /linux-6.6.21/fs/sysfs/ |
| D | Kconfig | 16 Some system agents rely on the information in sysfs to operate.
|
| /linux-6.6.21/Documentation/devicetree/bindings/net/can/ |
| D | tcan4x5x.txt | 15 operate at should be less than or equal to 18 MHz.
|
| /linux-6.6.21/arch/arm64/boot/dts/qcom/ |
| D | ipq9574-rdp449.dts | 57 * corner parts to operate at 800MHz
|
| D | ipq9574-rdp453.dts | 57 * corner parts to operate at 800MHz
|
| D | ipq9574-rdp454.dts | 57 * corner parts to operate at 800MHz
|
| /linux-6.6.21/Documentation/mm/damon/ |
| D | index.rst | 18 Using this framework, therefore, the kernel can operate system in an
|
| /linux-6.6.21/Documentation/arch/x86/ |
| D | shstk.rst | 59 are only supported in 64 bit user applications. These operate on the features
65 Enable a single feature specified in 'feature'. Can only operate on
69 Disable a single feature specified in 'feature'. Can only operate on
|
| /linux-6.6.21/Documentation/devicetree/bindings/iio/temperature/ |
| D | melexis,mlx90632.yaml | 20 operate and measure ambient temperature in range of -20 to 85 degrees
|
| /linux-6.6.21/Documentation/devicetree/bindings/cpufreq/ |
| D | cpufreq-st.txt | 7 the DT and operate in the usual way.
|
| /linux-6.6.21/Documentation/devicetree/bindings/sound/ |
| D | starfive,jh7110-tdm.yaml | 12 audio over a serial interface. The TDM controller can operate both
|
123456789