| /linux-6.6.21/Documentation/scsi/ |
| D | hptiop.rst | 110 All queued requests are handled via inbound/outbound queue port.
115 - Get a free request packet by reading the inbound queue port or
118 The value returned from the inbound queue port is an offset
125 - Post the packet to IOP by writing it to inbound queue. For requests
126 allocated in IOP memory, write the offset to inbound queue port. For
128 to the inbound queue port.
147 Non-queued requests (reset/flush etc) can be sent via inbound message
149 of an inbound message.
155 All queued requests are handled via inbound/outbound list.
165 Fill a free inbound list unit with the physical address and the size of
[all …]
|
| D | arcmsr_spec.rst | 40 offset 0xa00 for inbound message code message_rwbuffer
61 (inbound queue port)
152 ->offset 0xa00 :for inbound message code message_rwbuffer
167 ->offset 0xa00 for inbound message code message_rwbuffer
|
| /linux-6.6.21/Documentation/arch/arm/ |
| D | cluster-pm-race-avoidance.rst | 90 state value into two parts (the "cluster" state and "inbound" state) and
222 as seen by a CPU tearing the cluster down. The "inbound side" is the
237 "inbound" state: The state of the cluster on the inbound side.
266 Transitions ===##> can only be made by the inbound CPU, and only
267 involve changes to the "inbound" state, except where there is no
280 The parallelism of the inbound and outbound CPUs is observed by
296 <cluster state>/<inbound state> (<transitioner>)
299 can occur; either the inbound or the outbound side.
304 CLUSTER_DOWN/INBOUND_COMING_UP (inbound)
317 In this state, an inbound CPU sets up the cluster, including
[all …]
|
| /linux-6.6.21/Documentation/devicetree/bindings/soc/qcom/ |
| D | qcom,smp2p.yaml | 60 Two identifiers of the inbound and outbound smem items used for this edge.
66 Each SMP2P pair contain a set of inbound and outbound entries, these are
73 Marks the entry as inbound; the node should be specified as a two
83 The name of this entry, for inbound entries this will be used to
123 # inbound and one outbound entry.
|
| /linux-6.6.21/drivers/hv/ |
| D | vmbus_drv.c | 389 struct hv_ring_buffer_debug_info inbound; in in_intr_mask_show() local
395 ret = hv_ringbuffer_get_debuginfo(&hv_dev->channel->inbound, &inbound); in in_intr_mask_show()
399 return sprintf(buf, "%d\n", inbound.current_interrupt_mask); in in_intr_mask_show()
407 struct hv_ring_buffer_debug_info inbound; in in_read_index_show() local
413 ret = hv_ringbuffer_get_debuginfo(&hv_dev->channel->inbound, &inbound); in in_read_index_show()
417 return sprintf(buf, "%d\n", inbound.current_read_index); in in_read_index_show()
425 struct hv_ring_buffer_debug_info inbound; in in_write_index_show() local
431 ret = hv_ringbuffer_get_debuginfo(&hv_dev->channel->inbound, &inbound); in in_write_index_show()
435 return sprintf(buf, "%d\n", inbound.current_write_index); in in_write_index_show()
444 struct hv_ring_buffer_debug_info inbound; in in_read_bytes_avail_show() local
[all …]
|
| D | ring_buffer.c | 180 mutex_init(&channel->inbound.ring_buffer_mutex); in hv_ringbuffer_pre_init()
465 struct hv_ring_buffer_info *rbi = &channel->inbound; in hv_pkt_iter_first()
525 struct hv_ring_buffer_info *rbi = &channel->inbound; in __hv_pkt_iter_next()
573 struct hv_ring_buffer_info *rbi = &channel->inbound; in hv_pkt_iter_close()
|
| D | connection.c | 400 if (likely(hv_end_read(&channel->inbound) == 0)) in vmbus_on_event()
403 hv_begin_read(&channel->inbound); in vmbus_on_event()
|
| /linux-6.6.21/drivers/soc/qcom/ |
| D | smp2p.c | 159 struct list_head inbound; member
233 list_for_each_entry(entry, &smp2p->inbound, node) { in qcom_smp2p_notify_in()
244 list_for_each_entry(entry, &smp2p->inbound, node) { in qcom_smp2p_notify_in()
533 INIT_LIST_HEAD(&smp2p->inbound); in qcom_smp2p_probe()
600 list_add(&entry->node, &smp2p->inbound); in qcom_smp2p_probe()
645 list_for_each_entry(entry, &smp2p->inbound, node) in qcom_smp2p_probe()
670 list_for_each_entry(entry, &smp2p->inbound, node) in qcom_smp2p_remove()
|
| /linux-6.6.21/Documentation/devicetree/bindings/pci/ |
| D | mobiveil-pcie.txt | 4 has up to 8 outbound and inbound windows for the address translation.
25 - ppio-wins : number of requested ppio inbound windows
26 default 1 inbound memory window is configured.
|
| D | cdns-pcie-host.yaml | 28 significant bits kept during inbound (PCIe -> AXI) address translations
|
| D | xgene-pci.txt | 15 - dma-ranges: ranges for the inbound memory regions.
|
| /linux-6.6.21/drivers/uio/ |
| D | uio_hv_generic.c | 84 dev->channel->inbound.ring_buffer->interrupt_mask = !irq_state; in hv_uio_irqcontrol()
99 chan->inbound.ring_buffer->interrupt_mask = 1; in hv_uio_channel_cb()
168 new_sc->inbound.ring_buffer->interrupt_mask = 1; in hv_uio_new_channel()
211 dev->channel->inbound.ring_buffer->interrupt_mask = 1; in hv_uio_open()
|
| /linux-6.6.21/Documentation/trace/ |
| D | hisi-ptt.rst | 99 type. Rx means the inbound while Tx means outbound. The packets will
132 direction of inbound and traced data format of 8DW.
177 You can specify multiple types when tracing inbound TLP headers, but can only
185 This is optional and the default parameter is inbound. The parameter value
189 - 4'b0000: inbound TLPs (P, NP, CPL)
191 - 4'b0010: outbound TLPs (P, NP, CPL) and inbound TLPs (P, NP, CPL B)
192 - 4'b0011: outbound TLPs (P, NP, CPL) and inbound TLPs (CPL A)
199 - 4'b0010: inbound TLPs (P, NP, CPL B)
200 - 4'b0011: inbound TLPs (CPL A)
|
| /linux-6.6.21/drivers/net/ppp/ |
| D | ppp_async.c | 107 int len, int inbound);
944 int len, int inbound) in async_lcp_peek() argument
960 if (code == (inbound? CONFACK: CONFREQ)) { in async_lcp_peek()
969 if (!inbound) { in async_lcp_peek()
980 } else if (inbound) in async_lcp_peek()
991 if (inbound) in async_lcp_peek()
998 if (inbound) in async_lcp_peek()
|
| /linux-6.6.21/arch/arm/common/ |
| D | mcpm_entry.c | 92 sync_cache_r(&c->inbound); in __mcpm_outbound_enter_critical()
93 if (c->inbound == INBOUND_COMING_UP) in __mcpm_outbound_enter_critical()
437 mcpm_sync.clusters[i].inbound = INBOUND_NOT_COMING_UP; in mcpm_sync_init()
|
| /linux-6.6.21/Documentation/ABI/testing/ |
| D | sysfs-bus-rpmsg | 23 inbound messages arrive to this address, the rpmsg core
41 inbound messages arrive to this address, the rpmsg core
49 and it is listening for inbound messages that may be sent
|
| /linux-6.6.21/Documentation/driver-api/rapidio/ |
| D | tsi721.rst | 9 It supports maintenance read and write operations, inbound and outbound RapidIO
10 doorbells, inbound maintenance port-writes and RapidIO messaging.
17 For inbound messages this driver uses destination ID matching to forward messages
|
| /linux-6.6.21/drivers/pci/controller/mobiveil/ |
| D | Kconfig | 31 Soft IP. It has up to 8 outbound and inbound windows
|
| /linux-6.6.21/arch/arm/include/asm/ |
| D | mcpm.h | 294 s8 inbound __aligned(__CACHE_WRITEBACK_GRANULE);
|
| /linux-6.6.21/Documentation/networking/ |
| D | secid.rst | 19 If this is an inbound flow, the label is derived from the IPSec security
|
| D | xfrm_proc.rst | 33 i.e. Either inbound SPI, address, or IPsec protocol at SA is wrong
|
| /linux-6.6.21/Documentation/ABI/stable/ |
| D | firewire-cdev | 42 link layers, reception of inbound requests to such
44 to inbound requests
|
| /linux-6.6.21/include/net/sctp/ |
| D | ulpevent.h | 79 __u16 inbound,
|
| /linux-6.6.21/Documentation/staging/ |
| D | rpmsg.rst | 60 a unique rpmsg local address (a 32-bit integer). This way when inbound messages
63 with the payload of the inbound message).
200 inbound messages arrive, they are dispatched by the rpmsg bus using the
214 relevant inbound messages arrive (i.e. messages which their dst address
|
| /linux-6.6.21/include/linux/netfilter/ |
| D | nf_conntrack_pptp.h | 309 int (*inbound)(struct sk_buff *skb, member
|