Searched refs:drives (Results 1 – 25 of 138) sorted by relevance
123456
| /linux-6.6.21/Documentation/hwmon/ |
| D | drivetemp.rst | 24 drives with temperature sensors.
36 Reading the drive temperature may reset the spin down timer on some drives.
37 This has been observed with WD120EFAX drives, but may be seen with other
38 drives as well. The same behavior is observed if the 'hdtemp' or 'smartd'
44 drives experience similar behavior.
46 A known workaround for WD120EFAX drives is to read the drive temperature at
47 intervals larger than twice the spin-down time. Otherwise affected drives
|
| /linux-6.6.21/Documentation/admin-guide/blockdev/ |
| D | paride.rst | 13 CD-ROM, LS-120 and tape drives use the parallel port to connect to their
19 (The Iomega PPA-3 adapter used in the ZIP drives is an example of this
26 drives use the ISA replicator to interface a floppy disk controller,
38 drives or scanners. Many different devices are supported by the
43 - MicroSolutions backpack hard-drives
45 - SyQuest EZ-135, EZ-230 & SparQ drives
50 - Hewlett-Packard 5GB and 8GB tape drives
51 - Hewlett-Packard 7100 and 7200 CD-RW drives
191 3.3 Some drives need a printer reset
194 There appear to be a number of "noname" external drives on the market
[all …]
|
| D | floppy.rst | 145 you have more than two floppy drives (only two can be
160 (Note: there are two valid types for ED drives. This is because 5 was
161 initially chosen to represent floppy *tapes*, and 6 for ED drives.
162 AMI ignored this, and used 5 for ED drives. That's why the floppy
183 problems. However, some older drives, and also some laptops
|
| /linux-6.6.21/fs/adfs/ |
| D | Kconfig | 10 here, Linux will be able to read from ADFS partitions on hard drives
15 /dev/[hs]d?1) on each of your drives. Please read the file
28 hard drives and ADFS-formatted floppy disks. This is experimental
|
| /linux-6.6.21/drivers/ata/pata_parport/ |
| D | Kconfig | 19 parallel port Series 5 IDE protocol. (Most BACKPACK drives made
20 before 1999 were Series 5) Series 5 drives will NOT always have the
31 parallel port Series 6 IDE protocol. (Most BACKPACK drives made
32 after 1999 were Series 6) Series 6 drives will have the Series noted
59 (low speed) adapter that is used in some portable hard drives.
125 used in some 2.5" portable hard drives.
|
| /linux-6.6.21/Documentation/devicetree/bindings/spi/ |
| D | sqi-pic32.txt | 7 - clocks: Should contain phandle of two clocks in sequence, one that drives
8 clock on SPI bus and other that drives SQI controller.
|
| /linux-6.6.21/Documentation/scsi/ |
| D | hpsa.rst | 11 driver (for logical drives) AND a SCSI driver (for tape drives). This
57 (e.g. hot-plugged tape drives, or newly configured or deleted logical drives,
62 tape drives, or entire storage boxes containing pre-configured logical drives.
|
| D | st.rst | 33 QIC-drives). The result is that any tape can be read, writing can be
123 The tape driver currently supports up to 2^17 drives if 4 modes for
167 The st driver maintains statistics for tape drives inside the sysfs filesystem.
290 this read command. Should be disabled for those drives that don't like
435 for SCSI-1 drives and SCSI-2 seek for SCSI-2 drives. The file and
453 SCSI mode page 15. Note that some drives other methods for
454 control of compression. Some drives (like the Exabytes) use
455 density codes for compression control. Some drives use another
457 driver. Some drives without compression capability will accept
471 drives and several early drives this is the physically first
[all …]
|
| D | dc395x.rst | 9 The driver has been tested with CD-R and CD-R/W drives. These should
79 0 0x01 1 Support more than two drives. (Not used)
|
| /linux-6.6.21/drivers/md/ |
| D | Kconfig | 101 A RAID-1 set consists of several disk drives which are exact copies
105 kernel. In a set with N drives, the available space is the capacity
107 drives.
148 A RAID-5 set of N drives with a capacity of C MB per drive provides
150 of a single drive. For a given sector (row) number, (N - 1) drives
153 while a RAID-5 set distributes the parity across the drives in one
156 A RAID-6 set of N drives with a capacity of C MB per drive
158 against a failure of any two drives. For a given sector
159 (row) number, (N - 2) drives contain data sectors, and two
160 drives contains two independent redundancy syndromes. Like
[all …]
|
| /linux-6.6.21/Documentation/admin-guide/device-mapper/ |
| D | dm-raid.rst | 124 2 drives 3 drives 4 drives
142 2 drives 3 drives 4 drives
158 2 drives 3 drives 4 drives
225 given for both the metadata and data drives for a given position.
233 # RAID4 - 4 data drives, 1 parity (no metadata devices)
242 # RAID4 - 4 data drives, 1 parity (with metadata devices)
|
| /linux-6.6.21/Documentation/devicetree/bindings/display/panel/ |
| D | sharp,lq101r1sx01.yaml | 14 - left-right: each channel drives the left or right half of the screen
15 - even-odd: each channel drives the even or odd lines of the screen
|
| /linux-6.6.21/Documentation/devicetree/bindings/watchdog/ |
| D | moxa,moxart-watchdog.txt | 7 - clocks : Should contain phandle for the clock that drives the counter
|
| D | digicolor-wdt.txt | 12 - clocks : phandle; specifies the clock that drives the timer
|
| /linux-6.6.21/fs/zonefs/ |
| D | Kconfig | 9 device (e.g. host-managed or host-aware SMR disk drives) as files.
|
| /linux-6.6.21/Documentation/cdrom/ |
| D | cdrom-standard.rst | 50 adapted their drives to one or more of the already existing electrical
57 drives are either IDE/ATAPI or SCSI, and it is very unlikely that any
58 manufacturer will create a new interface. Even finding drives for the
71 ejection. Undoubtedly, the capabilities of the different drives vary,
72 but even when two drives have the same capability their drivers'
93 Driver is simply to give people writing application programs for CD-ROM drives
103 the IDE/ATAPI drives and, of course, the SCSI drives, but as prices
106 that these drives behave in the same way. In December 1994, one of the
107 cheapest CD-ROM drives was a Philips cm206, a double-speed proprietary
109 proprietary drives became obsolete and IDE/ATAPI drives became the
[all …]
|
| /linux-6.6.21/Documentation/devicetree/bindings/timer/ |
| D | altr,timer-1.0.txt | 8 - clock-frequency : The frequency of the clock that drives the counter, in Hz.
|
| D | brcm,bcm2835-system-timer.txt | 13 - clock-frequency : The frequency of the clock that drives the counter, in Hz.
|
| /linux-6.6.21/drivers/cdx/controller/ |
| D | Kconfig | 15 CDX controller drives the CDX bus. It interacts with
|
| /linux-6.6.21/Documentation/devicetree/bindings/input/ |
| D | gpio-beeper.yaml | 19 GPIO that drives the beeper.
|
| /linux-6.6.21/Documentation/devicetree/bindings/hwmon/ |
| D | sensirion,sht15.yaml | 23 description: regulator that drives the VCC pin
|
| /linux-6.6.21/Documentation/devicetree/bindings/nvmem/ |
| D | microchip,lan9662-otpc.yaml | 13 OTP controller drives a NVMEM memory where system specific data
|
| D | microchip,sama7g5-otpc.yaml | 13 OTP controller drives a NVMEM memory where system specific data
|
| /linux-6.6.21/Documentation/ABI/testing/ |
| D | sysfs-class-scsi_tape | 44 This value is presented in bytes because tape drives support
75 This value is presented in bytes because tape drives support
|
| /linux-6.6.21/Documentation/devicetree/bindings/clock/ |
| D | qcom,msm8996-cbf.yaml | 13 The clock controller for the Qualcomm MSM8996 CBF clock, which drives the
|
123456