Searched refs:reconfigure (Results 1 – 25 of 58) sorted by relevance
123
| /linux-6.1.9/fs/autofs/ |
| D | Kconfig | 30 don't have a laptop which needs to dynamically reconfigure to the
|
| /linux-6.1.9/Documentation/devicetree/bindings/power/reset/ |
| D | gpio-poweroff.yaml | 31 Initially configure the GPIO line as an input. Only reconfigure
|
| /linux-6.1.9/include/linux/ |
| D | fs_context.h | 121 int (*reconfigure)(struct fs_context *fc); member
|
| /linux-6.1.9/drivers/dma/qcom/ |
| D | bam_dma.c | 368 unsigned int reconfigure; /* new slave config? */ member
631 bchan->reconfigure = 1; in bam_slave_config()
1008 bchan->reconfigure = 0; in bam_apply_new_config()
1046 if (bchan->reconfigure) in bam_start_dma()
|
| /linux-6.1.9/fs/proc/ |
| D | root.c | 241 .reconfigure = proc_reconfigure,
|
| /linux-6.1.9/arch/arm/boot/dts/ |
| D | intel-ixp42x-gateworks-gw2348.dts | 86 * The CF driver will dynamically reconfigure these timings
|
| D | intel-ixp43x-gateworks-gw2358.dts | 102 * The CF driver will dynamically reconfigure these timings
|
| /linux-6.1.9/fs/jffs2/ |
| D | super.c | 305 .reconfigure = jffs2_reconfigure,
|
| /linux-6.1.9/Documentation/fb/ |
| D | ep93xx-fb.rst | 139 In some cases it may be possible to reconfigure your SDRAM layout to
|
| /linux-6.1.9/drivers/net/ethernet/sfc/falcon/ |
| D | tenxpress.c | 481 .reconfigure = tenxpress_phy_reconfigure,
|
| D | qt202x_phy.c | 484 .reconfigure = qt202x_phy_reconfigure,
|
| D | txc43128_phy.c | 549 .reconfigure = txc43128_phy_reconfigure,
|
| D | efx.c | 1062 rc = efx->phy_op->reconfigure(efx); in ef4_init_port()
2386 rc = efx->phy_op->reconfigure(efx); in ef4_reset_up()
2611 .reconfigure = ef4_port_dummy_op_int,
2984 efx->phy_op->reconfigure(efx); in ef4_pm_thaw()
|
| /linux-6.1.9/Documentation/devicetree/bindings/mmc/ |
| D | ti-omap-hsmmc.txt | 104 The workaround is to reconfigure the dat1 line as a GPIO upon suspend. To make
|
| /linux-6.1.9/Documentation/userspace-api/media/mediactl/ |
| D | request-api.rst | 12 the same pipeline to reconfigure and collaborate closely on a per-frame basis.
21 on the media pipeline, reconfigure it for the next frame, queue the buffers to
|
| /linux-6.1.9/Documentation/driver-api/usb/ |
| D | typec_bus.rst | 52 in need to reconfigure the pins on the connector, the alternate mode driver
|
| /linux-6.1.9/fs/vboxsf/ |
| D | super.c | 431 .reconfigure = vboxsf_reconfigure,
|
| /linux-6.1.9/Documentation/devicetree/bindings/pinctrl/ |
| D | pinctrl-bindings.txt | 15 need to reconfigure pins at run-time, for example to tri-state pins when the
|
| /linux-6.1.9/Documentation/devicetree/bindings/pci/ |
| D | host-generic-pci.yaml | 72 is there any reason for the driver to reconfigure ATU windows for
|
| /linux-6.1.9/fs/squashfs/ |
| D | super.c | 425 .reconfigure = squashfs_reconfigure,
|
| /linux-6.1.9/fs/romfs/ |
| D | super.c | 569 .reconfigure = romfs_reconfigure,
|
| /linux-6.1.9/Documentation/networking/device_drivers/ethernet/cirrus/ |
| D | cs89x0.rst | 459 option to reconfigure the adapter by selecting a different value for the system
536 self-test. If so, reconfigure the adapter selecting another choice for the
541 the adapter and reconfigure it by installing it in another PC to run the
|
| /linux-6.1.9/Documentation/filesystems/ |
| D | mount_api.rst | 219 int (*reconfigure)(struct fs_context *fc);
293 int (*reconfigure)(struct fs_context *fc);
303 .. Note:: reconfigure is intended as a replacement for remount_fs.
|
| /linux-6.1.9/fs/ |
| D | fs_context.c | 643 .reconfigure = legacy_reconfigure,
|
| /linux-6.1.9/Documentation/admin-guide/gpio/ |
| D | sysfs.rst | 84 allow userspace to reconfigure this GPIO's direction.
|
123