Home
last modified time | relevance | path

Searched refs:rdl (Results 1 – 4 of 4) sorted by relevance

/linux-6.1.9/drivers/usb/host/ !
Dehci-orion.c25 #define rdl(off) readl_relaxed(hcd->regs + (off)) macro
85 wrl(USB_CMD, rdl(USB_CMD) | USB_CMD_RESET); in orion_usb_phy_v1_setup()
86 while (rdl(USB_CMD) & USB_CMD_RESET); in orion_usb_phy_v1_setup()
92 wrl(USB_IPG, (rdl(USB_IPG) & ~0x7f00) | 0xc00); in orion_usb_phy_v1_setup()
98 wrl(USB_PHY_PWR_CTRL, (rdl(USB_PHY_PWR_CTRL) & ~0xc0)| 0x40); in orion_usb_phy_v1_setup()
104 wrl(USB_PHY_TX_CTRL, (rdl(USB_PHY_TX_CTRL) & ~0x78) | 0x202040); in orion_usb_phy_v1_setup()
111 wrl(USB_PHY_RX_CTRL, (rdl(USB_PHY_RX_CTRL) & ~0xc2003f0) | 0xc0000010); in orion_usb_phy_v1_setup()
117 wrl(USB_PHY_IVREF_CTRL, (rdl(USB_PHY_IVREF_CTRL) & ~0x80003 ) | 0x32); in orion_usb_phy_v1_setup()
123 wrl(USB_PHY_TST_GRP_CTRL, rdl(USB_PHY_TST_GRP_CTRL) & ~0x8000); in orion_usb_phy_v1_setup()
128 wrl(USB_CMD, rdl(USB_CMD) & ~USB_CMD_RUN); in orion_usb_phy_v1_setup()
[all …]
/linux-6.1.9/drivers/net/ethernet/marvell/ !
Dpxa168_eth.c273 static inline u32 rdl(struct pxa168_eth_private *pep, int offset) in rdl() function
293 while ((rdl(pep, SDMA_CMD) & (SDMA_CMD_AR | SDMA_CMD_AT)) in abort_dma()
567 val = rdl(pep, PORT_CONFIG); in pxa168_eth_set_rx_mode()
589 unsigned int mac_h = rdl(pep, MAC_ADDR_HIGH); in pxa168_eth_get_mac_address()
590 unsigned int mac_l = rdl(pep, MAC_ADDR_LOW); in pxa168_eth_get_mac_address()
654 val = rdl(pep, PORT_CONFIG); in eth_port_start()
659 val = rdl(pep, SDMA_CMD); in eth_port_start()
676 val = rdl(pep, SDMA_CMD); in eth_port_reset()
685 val = rdl(pep, PORT_CONFIG); in eth_port_reset()
846 icr = rdl(pep, INT_CAUSE); in pxa168_eth_collect_events()
[all …]
Dmv643xx_eth.c418 static inline u32 rdl(struct mv643xx_eth_private *mp, int offset) in rdl() function
1277 return rdl(mp, MIB_COUNTERS(mp->port_num) + offset); in mib_read()
2916 data = rdl(mp, PHY_ADDR); in phy_addr_set()
2926 data = rdl(mp, PHY_ADDR); in phy_addr_get()
/linux-6.1.9/drivers/net/ethernet/cirrus/ !
Dep93xx_eth.c179 #define rdl(ep, off) __raw_readl((ep)->base_addr + (off)) macro
193 if ((rdl(ep, REG_MIISTS) & REG_MIISTS_BUSY) == 0) in ep93xx_mdio_read()
202 data = rdl(ep, REG_MIIDATA); in ep93xx_mdio_read()
217 if ((rdl(ep, REG_MIISTS) & REG_MIISTS_BUSY) == 0) in ep93xx_mdio_write()
425 status = rdl(ep, REG_INTSTSC); in ep93xx_irq()
539 if ((rdl(ep, REG_SELFCTL) & REG_SELFCTL_RESET) == 0) in ep93xx_start_hw()
584 if ((rdl(ep, REG_BMSTS) & REG_BMSTS_RX_ACTIVE) != 0) in ep93xx_start_hw()
620 if ((rdl(ep, REG_SELFCTL) & REG_SELFCTL_RESET) == 0) in ep93xx_stop_hw()