Home
last modified time | relevance | path

Searched refs:jumpers (Results 1 – 10 of 10) sorted by relevance

/linux-6.1.9/Documentation/ABI/testing/
Dsysfs-platform-ts550024 What: /sys/devices/platform/ts5500/jumpers
29 Bitfield showing the jumpers' state. If a jumper is present,
30 the corresponding bit is set. For instance, 0x0e means jumpers
/linux-6.1.9/arch/x86/platform/ts5500/
Dts5500.c81 u8 jumpers; member
143 sbc->jumpers = tmp & ~TS5500_LED; in ts5500_detect_config()
173 return sprintf(buf, "0x%.2x\n", sbc->jumpers >> 1); in jumpers_show()
175 static DEVICE_ATTR_RO(jumpers);
/linux-6.1.9/Documentation/networking/
Darcnet-hardware.rst362 jumpers have them in the same position. Chris Hindy <chrish@io.org>
407 Even if your ARCnet model isn't listed, but has the same jumpers as another
459 About the jumpers: On my PC130 there is one more jumper, located near the
482 to find jumpers/switches with the same number of settings - it's
726 The jumpers labeled EXT1 and EXT2 are used to determine the timeout
727 parameters. These two jumpers are normally left open.
729 To select a hardware interrupt level set one (only one!) of the jumpers
955 The two jumpers JP2 (1-4) are used to determine the timeout parameters.
956 These two jumpers are normally left open.
1014 The row of jumpers at JP1 actually consists of 8 jumpers, (sometimes
[all …]
/linux-6.1.9/drivers/net/can/sja1000/
DKconfig112 PLD IO base addresses are read from jumpers JP1 and JP2,
113 IRQ numbers are read from jumpers JP4 and JP5,
/linux-6.1.9/drivers/pnp/
DKconfig13 parameters. No jumpers on the cards are needed, instead the values
/linux-6.1.9/arch/arm/boot/dts/
Dlogicpd-torpedo-37xx-devkit.dts28 * MMC3 can be routed with jumpers to the second MMC slot on the devkit and
Daspeed-bmc-tyan-s8036.dts126 * on header; selectable via jumpers as alternative to uart2
Daspeed-bmc-tyan-s7106.dts126 * on header; selectable via jumpers as alternative to uart2
/linux-6.1.9/arch/m68k/q40/
DREADME68 Make sure to configure the parallel port as SPP and remove IRQ/DMA jumpers
/linux-6.1.9/arch/powerpc/boot/dts/
Dkatmai.dts305 * have to be enabled via jumpers (only INTA is