Searched refs:flashes (Results 1 – 16 of 16) sorted by relevance
32 bool "Disable SWP on any flashes (legacy behavior)"35 flashes at boot-up.44 bool "Disable SWP on flashes w/ volatile protection bits"46 Some SPI flashes have volatile block protection bits, ie. after a51 of flashes while keeping it enabled for any other SPI flashes64 SPI flashes will not be changed. If your flash is software write
25 The default value should be OK for SLC NAND flashes, NOR flashes and26 other flashes which have eraseblock life-cycle 100000 or more.27 However, in case of MLC NAND flashes which typically have eraseblock42 Valid Blocks) for the flashes' endurance lifetime. The maximum
30 An OTP memory region. Some flashes provide a one-time-programmable32 pre-programmed by the factory. Some flashes might provide both.
24 OOB layout remains the default kernel layout for these flashes.
10 non-JEDEC compliant flashes.
31 typically 100K-1G for SLC NAND and NOR flashes, and 1K-10K for MLC32 NAND flashes. Blocks do not have the wear-out property.33 5 Eraseblocks may become bad (only on NAND flashes) and software should
185 Is the flash ready to strobe? Xenon flashes require their capacitors186 charged before strobing. LED flashes often require a cooldown period
89 # LED "double" flashes at a load average based rate96 # LED flashes at a fixed, configurable rate
749 flashes[MMAL_PARAMETER_CAMERA_INFO_MAX_FLASHES]; member
42 * There should **not** be any underflow or screen flashes
91 * Both firmware flashes are 128MB on Wedge400 BMC.
243 * Both firmware flashes are 64MB on Minipack BMC.
79 The flash frequency and duty cycle varies from faint flashes to
127 Extend the physmap driver to allow flashes to be partially
384 OFF Short flashes Cabling problems (broken cable or not389 ON Long flashes Data transfer
945 which only flashes in response to FTP transfers, for example. Or