| /linux-6.1.9/drivers/net/wireless/broadcom/b43/ |
| D | tables_nphy.c | 3509 b43err(dev->wl, "Unsupported antswlut: %d\n", antswlut); in b43_nphy_tables_init_rev7_volatile()
3666 b43err(dev->wl, in b43_nphy_get_ipa_gain_table()
3679 b43err(dev->wl, in b43_nphy_get_ipa_gain_table()
3710 b43err(dev->wl, in b43_nphy_get_tx_gain_table()
3725 b43err(dev->wl, in b43_nphy_get_tx_gain_table()
3748 b43err(dev->wl, in b43_ntab_get_rf_pwr_offset_table()
3759 b43err(dev->wl, in b43_ntab_get_rf_pwr_offset_table()
3855 b43err(dev->wl, "Invalid override value %d\n", override); in b43_nphy_get_rf_ctl_over_rev7()
|
| D | phy_ht.c | 98 b43err(dev->wl, "Radio 0x2059 rcal timeout\n"); in b43_radio_2059_rcal()
125 b43err(dev->wl, "Radio 0x2059 rccal timeout\n"); in b43_radio_2057_rccal()
191 b43err(dev->wl, "Forcing RF sequence timeout\n"); in b43_phy_ht_force_rf_sequence()
410 b43err(dev->wl, "run samples timeout\n"); in b43_phy_ht_run_samples()
439 b43err(dev->wl, "RSSI selection for core off not implemented yet\n"); in b43_phy_ht_rssi_select()
460 b43err(dev->wl, "RSSI selection for type %d not implemented yet\n", in b43_phy_ht_rssi_select()
877 b43err(dev->wl, "HT-PHY is supported only on BCMA bus!\n"); in b43_phy_ht_op_init()
1023 b43err(dev->wl, "MAC not suspended\n"); in b43_phy_ht_op_software_rfkill()
|
| D | dma.c | 470 b43err(dev->wl, "DMA RX reset timed out\n"); in b43_dmacontroller_rx_reset()
528 b43err(dev->wl, "DMA TX reset timed out\n"); in b43_dmacontroller_tx_reset()
619 b43err(ring->dev->wl, "RX DMA buffer allocation failed\n"); in setup_rx_descbuffer()
647 b43err(ring->dev->wl, in alloc_initial_descbuffers()
921 b43err(dev->wl, in b43_setup_dmaring()
1060 b43err(dev->wl, "The machine/kernel does not support " in b43_dma_init()
1368 b43err(dev->wl, "Packet after queue stopped\n"); in b43_dma_tx()
1376 b43err(dev->wl, "DMA queue overflow\n"); in b43_dma_tx()
1395 b43err(dev->wl, "DMA tx mapping failure\n"); in b43_dma_tx()
1641 b43err(ring->dev->wl, "DMA RX buffer too small " in dma_rx()
|
| D | main.c | 403 void b43err(struct b43_wl *wl, const char *fmt, ...) in b43err() function
1872 b43err(dev->wl, "Whoopsy, firmware panic! Reason: %u\n", reason); in b43_handle_firmware_panic()
1979 b43err(dev->wl, "MAC transmission error\n"); in b43_do_interrupt_thread()
1982 b43err(dev->wl, "PHY transmission error\n"); in b43_do_interrupt_thread()
1987 b43err(dev->wl, "Too many PHY TX errors, " in b43_do_interrupt_thread()
1994 b43err(dev->wl, in b43_do_interrupt_thread()
1999 b43err(dev->wl, "This device does not support DMA " in b43_do_interrupt_thread()
2174 b43err(wl, text); in b43_print_fw_helptext()
2517 b43err(dev->wl, "The driver does not know which firmware (ucode) " in b43_try_request_fw()
2523 b43err(dev->wl, "The driver does not know which firmware (PCM) " in b43_try_request_fw()
[all …]
|
| D | tables_phy_lcn.c | 696 b43err(dev->wl, in b43_phy_lcn_tables_init()
706 b43err(dev->wl, "SW ctl table is unknown for this card\n"); in b43_phy_lcn_tables_init()
|
| D | sysfs.c | 113 b43err(wldev->wl, "Interference Mitigation not " in b43_attr_interfmode_store()
|
| D | phy_common.c | 102 b43err(dev->wl, "PHY init failed\n"); in b43_phy_init()
109 b43err(dev->wl, "PHY init: Channel switch to default failed\n"); in b43_phy_init()
|
| D | phy_lcn.c | 555 b43err(dev->wl, "TX power control not supported for this HW\n"); in b43_phy_lcn_tx_pwr_ctl_init()
746 b43err(dev->wl, "MAC not suspended\n"); in b43_phy_lcn_op_software_rfkill()
|
| D | debugfs.c | 678 b43err(dev->wl, "debugfs: add device OOM\n"); in b43_debugfs_add_device()
686 b43err(dev->wl, "debugfs: add device txstatus OOM\n"); in b43_debugfs_add_device()
|
| D | phy_n.c | 137 b43err(dev->wl, "RF sequence status timeout\n"); in b43_nphy_force_rf_sequence()
174 b43err(dev->wl, "Invalid override value %d\n", override); in b43_nphy_rf_ctl_override_rev7()
254 b43err(dev->wl, in b43_nphy_rf_ctl_override()
289 b43err(dev->wl, in b43_nphy_rf_ctl_override()
430 b43err(dev->wl, in b43_nphy_rf_ctl_intc_override()
449 b43err(dev->wl, in b43_nphy_rf_ctl_intc_override()
884 b43err(dev->wl, "Radio 0x2057 rcal timeout\n"); in b43_radio_2057_rcal()
988 b43err(dev->wl, "Radio 0x2057 rcal timeout\n"); in b43_radio_2057_rccal()
1318 b43err(dev->wl, "Radio recalibration timeout\n"); in b43_radio_2056_rcal()
1462 b43err(dev->wl, "radio post init timeout\n"); in b43_radio_init2055_post()
[all …]
|
| D | b43.h | 1087 __printf(2, 3) void b43err(struct b43_wl *wl, const char *fmt, ...);
|
| D | pio.c | 547 b43err(dev->wl, "PIO transmission failure\n"); in b43_pio_tx()
|
| D | phy_g.c | 2363 b43err(dev->wl, "Could not allocate memory " in b43_generate_dyn_tssi2dbm_tab()
2370 b43err(dev->wl, "Could not generate " in b43_generate_dyn_tssi2dbm_tab()
|
| D | phy_lp.c | 1575 b43err(dev->wl, "PR41573 failed. Out of memory!\n"); in lpphy_pr41573_workaround()
2629 b43err(dev->wl, "LP-PHY is supported only on SSB!\n"); in b43_lpphy_op_init()
|