Searched refs:PSI (Results 1 – 16 of 16) sorted by relevance
17 PKTDMA only includes Split channels to service PSI-L based peripherals.19 The peripherals can be PSI-L native or legacy, non PSI-L native peripherals20 with PDMAs. PDMA is tasked to act as a bridge between the PSI-L fabric and the37 The first cell is the PSI-L thread ID of the remote (to PKTDMA) end.42 Please refer to the device documentation for the PSI-L thread map and also43 the PSI-L peripheral chapter for the correct thread ID.
23 Split channels can be used to service PSI-L based peripherals.24 The peripherals can be PSI-L native or legacy, non PSI-L native peripherals25 with PDMAs. PDMA is tasked to act as a bridge between the PSI-L fabric and the50 PSI-L thread ID of the remote (to BCDMA) end.55 Please refer to the device documentation for the PSI-L thread map and56 also the PSI-L peripheral chapter for the correct thread ID.
29 on the Rx PSI-L interface.35 All transfers within NAVSS is done between PSI-L source and destination37 The peripherals serviced by UDMA can be PSI-L native (sa2ul, cpsw, etc) or38 legacy, non PSI-L native peripherals. In the later case a special, small PDMA39 is tasked to act as a bridge between the PSI-L fabric and the legacy53 The cell is the PSI-L thread ID of the remote (to UDMAP) end.58 Please refer to the device documentation for the PSI-L thread map and also59 the PSI-L peripheral chapter for the correct thread ID.
49 * - ``PSI RAM``56 PSI RAM and EBL are the RAM images which are injected to the device when the70 1) When modem is in Boot ROM stage, user can use below command to inject PSI RAM80 3) Inject EBL after the modem is in PSI stage.
144 This is the PSI generator. PSI packets contain general information145 about a MPEG Transport Stream. A PSI generator is needed so152 Currently vidtv supports working with 5 PSI tables: PAT, PMT,161 debugging PSI tables. Vidtv currently tries to replicate the PSI222 #. Inserting PSI and/or PCR packets, if needed.349 In order to tune into a channel and read the PSI tables, we can use dvb-scan.
10 PSI——压力阻塞信息
352 __SMU_DUMMY_MAP(PSI), \
370 PSI = 0x10, enumerator
4 PSI - Pressure Stall Information
86 /* PSI and DMA */
126 FEA_MAP(PSI),
117 FEA_MAP(PSI),
983 Writing "0" to the file will disable the cgroup PSI accounting.984 Writing "1" to the file will re-enable the cgroup PSI accounting.986 This control attribute is not hierarchical, so disable or enable PSI987 accounting in a cgroup does not affect PSI accounting in descendants990 The reason this control attribute exists is that PSI accounts stalls for994 be used to disable PSI accounting in the non-leaf cgroups.
168 FEA_MAP(PSI),
628 config PSI config650 depends on PSI
16582 PRESSURE STALL INFORMATION (PSI)