| /linux-6.1.9/drivers/tty/ |
| D | amiserial.c | 82 int IER; /* Interrupt Enable Register */ member
139 if (info->IER & UART_IER_THRI) { in rs_stop()
140 info->IER &= ~UART_IER_THRI; in rs_stop()
158 && !(info->IER & UART_IER_THRI)) { in rs_start()
159 info->IER |= UART_IER_THRI; in rs_start()
279 info->IER &= ~UART_IER_THRI; in transmit_chars()
301 info->IER &= ~UART_IER_THRI; in transmit_chars()
351 info->IER |= UART_IER_THRI; in check_modem_status()
366 info->IER &= ~UART_IER_THRI; in check_modem_status()
385 if(info->IER & UART_IER_MSI) in ser_vbl_int()
[all …]
|
| D | mxser.c | 268 u8 IER; /* Interrupt Enable Register */ member
441 outb(info->IER & ~UART_IER_THRI, info->ioaddr + UART_IER); in __mxser_start_tx()
442 info->IER |= UART_IER_THRI; in __mxser_start_tx()
443 outb(info->IER, info->ioaddr + UART_IER); in __mxser_start_tx()
457 info->IER &= ~UART_IER_THRI; in __mxser_stop_tx()
458 outb(info->IER, info->ioaddr + UART_IER); in __mxser_stop_tx()
626 info->IER &= ~UART_IER_MSI; in mxser_change_speed()
630 info->IER |= UART_IER_MSI; in mxser_change_speed()
641 info->IER |= UART_IER_MSI; in mxser_change_speed()
642 outb(info->IER, info->ioaddr + UART_IER); in mxser_change_speed()
[all …]
|
| /linux-6.1.9/drivers/staging/media/deprecated/saa7146/common/ |
| D | saa7146.h | 360 #define IER 0xDC /* Interrupt enable register */ macro
460 saa7146_write(x, IER, saa7146_read(x, IER) & ~y); in SAA7146_IER_DISABLE()
468 saa7146_write(x, IER, saa7146_read(x, IER) | y); in SAA7146_IER_ENABLE()
|
| /linux-6.1.9/arch/x86/boot/ |
| D | early_serial_console.c | 14 #define IER 1 /* Interrupt Enable */ macro
32 outb(0, port + IER); /* no interrupt */ in early_serial_init()
|
| /linux-6.1.9/sound/pci/aw2/ |
| D | aw2-saa7146.c | 42 WRITEREG(0, IER); in snd_aw2_saa7146_free()
84 WRITEREG(0, IER); in snd_aw2_saa7146_setup()
124 WRITEREG(A1_out | A2_out | A1_in | IIC_S | IIC_E, IER); in snd_aw2_saa7146_setup()
|
| D | saa7146.h | 27 #define IER 0xDC macro
|
| /linux-6.1.9/drivers/macintosh/ |
| D | via-cuda.c | 54 #define IER (14*RS) /* Interrupt enable register */ macro
278 out_8(&via[IER], IER_SET|SR_INT); /* enable interrupt from SR */ in find_via_cuda()
384 out_8(&via[IER], 0x7f); /* disable interrupts from VIA */ in cuda_init_via()
385 (void)in_8(&via[IER]); in cuda_init_via()
387 out_8(&via[IER], SR_INT); /* disable SR interrupt from VIA */ in cuda_init_via()
|
| D | via-pmu.c | 98 #define IER (14*RS) /* Interrupt enable register */ macro
359 out_8(&via1[IER], IER_CLR | 0x7f); /* disable all intrs */ in find_via_pmu()
470 out_8(&via1[IER], IER_SET | SR_INT | CB1_INT); in via_pmu_start()
1319 out_8(&via1[IER], CB1_INT | IER_CLR); in pmu_suspend()
1343 out_8(&via1[IER], CB1_INT | IER_SET); in pmu_resume()
1614 intr, in_8(&via1[IER]), pmu_state); in via_pmu_interrupt()
1855 out_8(&via1[IER], IER_CLR | 0x7f); /* disable all intrs */ in restore_via_state()
1857 out_8(&via1[IER], IER_SET | SR_INT | CB1_INT); in restore_via_state()
|
| /linux-6.1.9/drivers/gpu/drm/i915/ |
| D | i915_irq.h | 112 gen3_irq_reset((uncore), type##IMR, type##IIR, type##IER)
129 type##IER, ier_val, \
|
| /linux-6.1.9/drivers/irqchip/ |
| D | irq-xilinx-intc.c | 25 #define IER 0x08 /* Interrupt Enable Register */ macro
203 xintc_write(irqc, IER, 0); in xilinx_intc_of_init()
|
| /linux-6.1.9/drivers/net/hamradio/ |
| D | baycom_ser_fdx.c | 94 #define IER(iobase) (iobase+1) macro
408 outb(0, IER(dev->base_addr)); in ser12_open()
425 outb(0x0a, IER(dev->base_addr)); in ser12_open()
449 outb(0, IER(dev->base_addr)); in ser12_close()
|
| D | baycom_ser_hdx.c | 80 #define IER(iobase) (iobase+1) macro
476 outb(0, IER(dev->base_addr)); in ser12_open()
485 outb(2, IER(dev->base_addr)); in ser12_open()
508 outb(0, IER(dev->base_addr)); in ser12_close()
|
| D | yam.c | 151 #define IER(iobase) (iobase+1) macro
293 outb(0, IER(iobase)); in fpga_reset()
465 outb(0, IER(dev->base_addr)); in yam_set_uart()
480 outb(ENABLE_RTXINT, IER(dev->base_addr)); in yam_set_uart()
864 outb(0, IER(dev->base_addr)); in yam_open()
907 outb(0, IER(dev->base_addr)); in yam_close()
|
| /linux-6.1.9/sound/pci/ |
| D | atiixp_modem.c | 530 atiixp_write(chip, IER, CODEC_CHECK_BITS); in snd_atiixp_codec_detect()
538 atiixp_write(chip, IER, 0); /* disable irqs */ in snd_atiixp_codec_detect()
565 atiixp_write(chip, IER, in snd_atiixp_chip_start()
581 atiixp_write(chip, IER, 0); in snd_atiixp_chip_stop()
650 atiixp_update(chip, IER, ATI_REG_IER_MODEM_SET_BUS_BUSY, bus_busy); in snd_atiixp_check_bus_busy()
1027 atiixp_update(chip, IER, detected, 0); /* disable the detected irqs */ in snd_atiixp_interrupt()
|
| D | atiixp.c | 576 atiixp_write(chip, IER, CODEC_CHECK_BITS); in snd_atiixp_codec_detect()
584 atiixp_write(chip, IER, 0); /* disable irqs */ in snd_atiixp_codec_detect()
614 atiixp_write(chip, IER, in snd_atiixp_chip_start()
632 atiixp_write(chip, IER, 0); in snd_atiixp_chip_stop()
700 atiixp_update(chip, IER, ATI_REG_IER_SET_BUS_BUSY, bus_busy); in snd_atiixp_check_bus_busy()
1362 atiixp_update(chip, IER, detected, 0); /* disable the detected irqs */ in snd_atiixp_interrupt()
|
| /linux-6.1.9/drivers/clocksource/ |
| D | timer-atmel-tcb.c | 101 writel(tcb_cache[i].imr, tcaddr + ATMEL_TC_REG(i, IER)); in tc_clksrc_resume()
186 writel(ATMEL_TC_CPCS, regs + ATMEL_TC_REG(2, IER)); in tc_set_oneshot()
211 writel(ATMEL_TC_CPCS, regs + ATMEL_TC_REG(2, IER)); in tc_set_periodic()
|
| /linux-6.1.9/arch/arm/mach-orion5x/ |
| D | tsx09-common.c | 36 writel(0x00, UART1_REG(IER)); in qnap_tsx09_power_off()
|
| /linux-6.1.9/arch/x86/kernel/ |
| D | early_printk.c | 87 #define IER 1 /* Interrupt Enable */ macro
135 serial_out(early_serial_base, IER, 0); /* no interrupt */ in early_serial_hw_init()
|
| /linux-6.1.9/drivers/usb/serial/ |
| D | io_16654.h | 32 #define IER 1 // ! Interrupt Enable Register macro
|
| /linux-6.1.9/drivers/power/reset/ |
| D | qnap-poweroff.c | 64 writel(0x00, UART1_REG(IER)); in qnap_power_off()
|
| /linux-6.1.9/drivers/video/fbdev/i810/ |
| D | i810_regs.h | 44 #define IER 0x020A0 macro
|
| /linux-6.1.9/sound/soc/dwc/ |
| D | local.h | 20 #define IER 0x000 macro
|
| /linux-6.1.9/drivers/spi/ |
| D | spi-at91-usart.c | 109 at91_usart_spi_writel(aus, IER, US_IR_RXRDY); in dma_callback()
265 at91_usart_spi_writel(aus, IER, US_IR_RXRDY); in at91_usart_spi_dma_transfer()
452 at91_usart_spi_writel(aus, IER, US_OVRE_RXRDY_IRQS); in at91_usart_spi_prepare_message()
|
| /linux-6.1.9/sound/soc/intel/keembay/ |
| D | kmb_platform.h | 19 #define IER 0x000 macro
|
| /linux-6.1.9/drivers/iio/adc/ |
| D | at91-sama5d2_adc.c | 109 u16 IER; member
263 .IER = 0x24,
298 .IER = 0x24,
837 at91_adc_writel(st, IER, BIT(channel)); in at91_adc_eoc_ena()
1009 at91_adc_writel(st, IER, AT91_SAMA5D2_IER_PEN); in at91_adc_configure_touch()
1256 at91_adc_writel(st, IER, AT91_SAMA5D2_IER_GOVRE); in at91_adc_dma_start()
1332 at91_adc_writel(st, IER, AT91_SAMA5D2_IER_DRDY); in at91_adc_buffer_prepare()
1650 at91_adc_writel(st, IER, AT91_SAMA5D2_IER_NOPEN | in at91_adc_pen_detect_interrupt()
1670 at91_adc_writel(st, IER, AT91_SAMA5D2_IER_PEN); in at91_adc_no_pen_detect_interrupt()
|