Home
last modified time | relevance | path

Searched refs:Add (Results 1 – 25 of 242) sorted by relevance

12345678910

/linux-6.1.9/Documentation/scsi/ !
DChangeLog.megaraid_sas12 4. Add missing initial call to megasas_get_ld_vf_affiliation().
25 4. Add Dell PowerEdge VRTX SR-IOV VF device support.
35 1. Add High Availability clustering support using shared Logical Disks.
50 6. Add support for MegaRAID Fury (device ID-0x005f) 12Gb/s controllers.
51 7. Add support to display Customer branding details in syslog.
54 9. Add support for Extended MSI-x vectors for Invader and Fury(12Gb/s
56 10.Add support for Uneven Span PRL11.
57 11.Add support to differentiate between iMR and MR Firmware.
65 1. Add 4k FastPath DIF support.
75 2. Add module param for configurable MSI-X vector count.
[all …]
DChangeLog.ips6 - Add Extended DCDB Commands for Tape Support in 5I
17 4.90.01 - Add ServeRAID Version Checking
52 - Add IPSSEND Flash Support
70 4.10.00 - Add support for ServeRAID 4M/4L
81 4.00.03 - Add alternative passthru interface
82 - Add ability to flash ServeRAID BIOS
86 4.00.01 - Add support for First Failure Data Capture
88 4.00.00 - Add support for ServeRAID 4
DChangeLog.sym53c8xx_213 * Add the target number to the display of transfer parameters.
23 - Add year 2001 to Copyright.
46 - Add a missing cpu_to_scr() (np->abort_tbl.addr)
51 - Add option SYM_OPT_ANNOUNCE_TRANSFER_RATE and move the
56 - Add optionnal code that handles IO timeouts from the driver.
76 - Add DT/ST (double/simple transition) in the transfer
94 - Add Tekram 390 U2B/U2W SCSI LED handling.
96 - Add call to scsi_set_pci_device() for kernels >= 2.4.4.
105 - Add infrastructure for the forthcoming 64 bit DMA addressing support.
111 - Add support for 64 bit DMA addressing using segment registers.
Ddpti.rst71 - Add 64 bit Scatter Gather when compiled on 64 bit architectures
72 - Add sparse lun scanning
73 - Add code that checks if a device that had been taken offline is
76 - Add proc read interface
79 - Add code to rescan routine that notifies scsi-core about new devices
80 - Add support for C-PCI (hotplug stuff)
81 - Add ioctl passthru error recovery
DChangeLog.ncr53c8xx65 - Add the file sym53c8xx_comm.h that collects code that should
75 - Add support for the new dynamic dma mapping kernel interface.
82 - Add the file sym53c8xx_comm.h that collects code that should
92 - Add support for the new dynamic dma mapping kernel interface.
116 - Add year 2000 copyright.
137 - Add support for the SYM53C1510D.
150 - Add support of some 'resource handling' for linux-2.3.13.
166 - Add 'hostid:#id' boot option. This option allows to change the
179 - Add 'excl' boot command option that allows to pass to the driver
181 - Add info() function called from the host template to print
[all …]
DChangeLog.sym53c8xx52 - Add field 'maxoffs_st' (max offset for ST data transfers).
60 - Add a missing endian-ization (abrt_tbl.addr).
67 - Add FE_DAC feature bit to distinguish between 64 bit PCI
73 - Add FE_VARCLK feature bit that indicates that SCSI clock
80 - Add support for the SYM53C875A (Pamela Delaney).
139 - Add support for the new dynamic dma mapping kernel interface.
167 - Add support for the new dynamic dma mapping kernel interface.
201 - Add year 2000 copyright.
215 - Add NVRAM support for Tekram boards that use 24C16 EEPROM.
221 - Add support for the SYM53C1510D (also for ncr53c8xx).
[all …]
/linux-6.1.9/drivers/staging/media/tegra-video/ !
DTODO2 * Add support for Ganged mode.
3 * Add RAW10 packed video format support to Tegra210 video formats.
4 * Add support for suspend and resume.
/linux-6.1.9/drivers/staging/fbtft/ !
DREADME16 Add to drivers/video/fbdev/Kconfig: source "drivers/video/fbdev/fbtft/Kconfig"
17 Add to drivers/video/fbdev/Makefile: obj-y += fbtft/
23 Add to drivers/video/Kconfig: source "drivers/video/fbtft/Kconfig"
24 Add to drivers/video/Makefile: obj-y += fbtft/
/linux-6.1.9/tools/testing/memblock/ !
DTODO4 1. Add tests trying to memblock_add() or memblock_reserve() 129th region.
11 2. Add test cases using this functions (implement them for both directions):
16 3. Add tests for memblock_alloc_node() to check if the correct NUMA node is set
/linux-6.1.9/arch/powerpc/boot/dts/ !
Dmpc5200b.dtsi65 #gpio-cells = <2>; // Add 'gpio-controller;' to enable gpio mode
73 #gpio-cells = <2>; // Add 'gpio-controller;' to enable gpio mode
80 #gpio-cells = <2>; // Add 'gpio-controller;' to enable gpio mode
87 #gpio-cells = <2>; // Add 'gpio-controller;' to enable gpio mode
94 #gpio-cells = <2>; // Add 'gpio-controller;' to enable gpio mode
101 #gpio-cells = <2>; // Add 'gpio-controller;' to enable gpio mode
108 #gpio-cells = <2>; // Add 'gpio-controller;' to enable gpio mode
115 #gpio-cells = <2>; // Add 'gpio-controller;' to enable gpio mode
/linux-6.1.9/Documentation/networking/device_drivers/ethernet/ti/ !
Dam65_nuss_cpsw_switchdev.rst88 Add extra VLANs
95 bridge vlan add dev br0 vid 100 pvid untagged self <---- Add cpu port to VLAN100
101 bridge vlan add dev br0 vid 100 pvid tagged self <---- Add cpu port to VLAN100
111 bridge fdb add aa:bb:cc:dd:ee:fe dev sw0p2 master <---- Add on all VLANs
121 bridge mdb add dev br0 port sw0p1 grp 239.1.1.1 permanent <---- Add on all VLANs
Dcpsw_switchdev.rst138 Add extra VLANs
145 bridge vlan add dev br0 vid 100 pvid untagged self <---- Add cpu port to VLAN100
151 bridge vlan add dev br0 vid 100 pvid tagged self <---- Add cpu port to VLAN100
161 bridge fdb add aa:bb:cc:dd:ee:fe dev sw0p2 master <---- Add on all VLANs
171 bridge mdb add dev br0 port sw0p1 grp 239.1.1.1 permanent <---- Add on all VLANs
/linux-6.1.9/arch/mips/bcm47xx/ !
DKconfig19 Add support for old Broadcom BCM47xx boards with Sonics Silicon Backplane support.
36 Add support for new Broadcom BCM47xx boards with Broadcom specific Advanced Microcontroller Bus.
/linux-6.1.9/Documentation/admin-guide/cifs/ !
Dtodo.rst45 g) Add GUI tool to configure /proc/fs/cifs settings and for display of
51 i) Add support for tree connect contexts (see MS-SMB2) a new SMB3.1.1 protocol
58 k) Add tools to take advantage of more smb3 specific ioctls and features
61 directly from user space) Add tools to make setting various non-POSIX
72 n) Add support for claims based ACLs ("DAC")
95 w) Add support for additional strong encryption types, and additional spnego
/linux-6.1.9/drivers/iio/dummy/ !
DKconfig26 Add some dummy events to the simple dummy driver.
39 Add buffered data capture to the simple dummy driver.
/linux-6.1.9/Documentation/driver-api/media/drivers/ !
Ddavinci-vpbe-devel.rst31 - Add support for external encoders.
39 - Add support for fbdev drivers.- Ready and part of subsequent patches.
/linux-6.1.9/tools/power/cpupower/ !
DTODO8 - Add another c1e debug idle monitor
11 - Add cpu_start()/cpu_stop() callbacks for monitor
/linux-6.1.9/Documentation/devicetree/bindings/input/rmi4/ !
Drmi_2d_sensor.txt27 - syna,offset-x: Add an offset to X.
28 - syna,offset-y: Add an offset to Y.
/linux-6.1.9/drivers/powercap/ !
DKconfig55 bool "Add CPU power capping based on the energy model"
62 bool "Add device power capping based on the energy model"
/linux-6.1.9/rust/alloc/ !
Dborrow.rs11 use core::ops::{Add, AddAssign};
444 impl<'a> Add<&'a str> for Cow<'a, str> {
456 impl<'a> Add<Cow<'a, str>> for Cow<'a, str> { impl
/linux-6.1.9/Documentation/dev-tools/kunit/ !
Dstart.rst203 3. Add the following lines to ``drivers/misc/Kconfig``:
210 4. Add the following lines to ``drivers/misc/Makefile``:
218 1. Add the below test case in ``drivers/misc/example_test.c``:
253 2. Add the following lines to ``drivers/misc/Kconfig``:
262 3. Add the following lines to ``drivers/misc/Makefile``:
268 4. Add the following lines to ``.kunit/.kunitconfig``:
/linux-6.1.9/tools/perf/Documentation/ !
Dperf-probe.txt251 Add a probe on schedule() function 12th line with recording cpu local variable:
257 Add one or more probes which has the name start with "schedule".
263 Add probes on lines in schedule() function which calls update_rq_clock().
273 Add probes at zfree() function on /bin/zsh
277 Add probes at malloc() function on libc
281 Add a uprobe to a target process running in a different mount namespace
285 Add a USDT probe to a target process running in a different mount namespace
289 Add a probe on specific versioned symbol by backslash escape
293 Add a probe in a source file using special characters by backslash escape
/linux-6.1.9/Documentation/userspace-api/media/dvb/ !
Ddvbapi.rst89 Add more information about DVBv5 API, better describing the frontend
95 Add some frontend capabilities flags, present on kernel, but missing at
/linux-6.1.9/Documentation/admin-guide/device-mapper/ !
Ddm-raid.rst388 1.4.2 Add RAID10 "far" and "offset" algorithm support.
389 1.5.0 Add message interface to allow manipulation of the sync_action.
391 1.5.1 Add ability to restore transiently failed devices on resume.
393 1.6.0 Add discard support (and devices_handle_discard_safely module param).
394 1.7.0 Add support for MD RAID0 mappings.
399 1.9.0 Add support for RAID level takeover/reshape/region size
406 1.10.0 Add support for raid4/5/6 journal device
410 1.11.1 Add raid4/5/6 journal write-back support via journal_mode option
/linux-6.1.9/tools/testing/selftests/firmware/ !
Dsettings6 # of the 3 configs, so at least another 15 seconds are needed. Add another

12345678910