Searched refs:SYSCON (Results 1 – 15 of 15) sorted by relevance
42 - description: Phandle to the SYSCON entry43 - description: pcie_device_id register offset within SYSCON44 description: Phandle to the SYSCON entry required for getting PCIe device/vendor ID50 - description: Phandle to the SYSCON entry51 - description: pcie_ctrl register offset within SYSCON52 description: Phandle to the SYSCON entry required for configuring PCIe in RC or EP mode.
38 - description: Phandle to the SYSCON entry39 - description: pcie_ctrl register offset within SYSCON40 description: Phandle to the SYSCON entry required for configuring PCIe in RC or EP mode.
43 - description: Phandle to the SYSCON entry44 - description: pcie_ctrl register offset within SYSCON
7 title: Generic SYSCON reboot mode driver14 and stores it in a SYSCON mapped register. Then the bootloader16 value stored. The SYSCON mapped register is retrieved from the17 parental dt-node plus the offset. So the SYSCON reboot-mode node
7 title: Generic SYSCON mapped register reset driver15 defined by the SYSCON register map base plus the offset with the value and17 access only. The SYSCON registers map is normally retrieved from the18 parental dt-node. So the SYSCON reboot node should be represented as a
7 title: Generic SYSCON mapped register poweroff driver
245 bool "Generic SYSCON regmap reset driver"250 Reboot support for generic SYSCON mapped register reset.253 bool "Generic SYSCON regmap poweroff driver"258 Poweroff support for generic SYSCON mapped register poweroff.271 tristate "Generic SYSCON regmap reboot mode driver"277 get reboot mode arguments and store it in SYSCON mapped
46 - description: Phandle to the SYSCON entry47 - description: USB phy control register offset within SYSCON
49 description: Phandle to the SYSCON entry required for configuring SERDES clock selection.57 description: Phandle to the SYSCON entry required for configuring SERDES lane function.
8 - syscon: Phandle to SYSCON node, which contain UART control bits.
119 SYSCON enumerator896 drvdata->type = SYSCON; in armada_thermal_probe()
250 tristate "TI SYSCON Reset Driver"
618 tristate "GPIO based on SYSCON"621 Say yes here to support GPIO functionality though SYSCON driver.
19452 SYSTEM CONFIGURATION (SYSCON)