| /linux-5.19.10/drivers/pinctrl/ |
| D | pinctrl-ocelot.c | 363 LUTON_P(14, SI, PHY_LED);
364 LUTON_P(15, SI, PHY_LED);
365 LUTON_P(16, SI, PHY_LED);
439 SERVAL_P(8, SI, NONE, NONE);
440 SERVAL_P(9, SI, MD, NONE);
441 SERVAL_P(10, SI, MD, NONE);
521 OCELOT_P(8, SI, TWI_SCL_M, IRQ0_OUT);
522 OCELOT_P(9, SI, TWI_SCL_M, IRQ1_OUT);
529 OCELOT_P(16, TWI, NONE, SI);
530 OCELOT_P(17, TWI, TWI_SCL_M, SI);
[all …]
|
| /linux-5.19.10/Documentation/spi/ |
| D | spi-lm70llp.rst | 46 D7 9 --> SI/O 5
48 Select 13 <-- SI/O 1
51 Note that since the LM70 uses a "3-wire" variant of SPI, the SI/SO pin
55 devices might share the same SI/SO pin.
64 shows that the SI/O line from the LM70 chip is connected to the base of a
68 Interpreting this circuit, when the LM70 SI/O line is High (or tristate
71 connector. When SI/O is Low (driven by the LM70 or the host) on the other
|
| /linux-5.19.10/drivers/gpu/drm/amd/amdgpu/ |
| D | Kconfig | 3 bool "Enable amdgpu support for SI parts"
7 for SI asics.
9 SI is already supported in radeon. Experimental support for SI
|
| /linux-5.19.10/drivers/ata/ |
| D | sata_sis.c | 54 { PCI_VDEVICE(SI, 0x0180), sis_180 }, /* SiS 964/180 */
55 { PCI_VDEVICE(SI, 0x0181), sis_180 }, /* SiS 964/180 */
56 { PCI_VDEVICE(SI, 0x0182), sis_180 }, /* SiS 965/965L */
57 { PCI_VDEVICE(SI, 0x0183), sis_180 }, /* SiS 965/965L */
58 { PCI_VDEVICE(SI, 0x1182), sis_180 }, /* SiS 966/680 */
59 { PCI_VDEVICE(SI, 0x1183), sis_180 }, /* SiS 966/966L/968/680 */
|
| D | pata_sis.c | 891 { PCI_VDEVICE(SI, 0x5513), }, /* SiS 5513 */
892 { PCI_VDEVICE(SI, 0x5518), }, /* SiS 5518 */
893 { PCI_VDEVICE(SI, 0x1180), }, /* SiS 1180 */
|
| /linux-5.19.10/tools/perf/arch/x86/tests/ |
| D | regs_load.S | 8 #define SI 4 * 8 macro
36 movq %rsi, SI(%rdi)
72 movl %esi, SI(%edi)
|
| /linux-5.19.10/arch/m68k/lib/ |
| D | ashldi3.c | 21 typedef int SItype __mode(SI);
22 typedef unsigned int USItype __mode(SI);
|
| D | lshrdi3.c | 21 typedef int SItype __mode(SI);
22 typedef unsigned int USItype __mode(SI);
|
| D | ashrdi3.c | 21 typedef int SItype __mode(SI);
22 typedef unsigned int USItype __mode(SI);
|
| D | muldi3.c | 68 typedef int SItype __mode(SI);
69 typedef unsigned int USItype __mode(SI);
|
| /linux-5.19.10/Documentation/devicetree/bindings/powerpc/nintendo/ |
| D | gamecube.txt | 88 1.f) The Serial Interface (SI) node
91 The SI is a proprietary serial interface used normally to control gamepads.
97 - reg : should contain the SI registers location and length
98 - interrupts : should contain the SI interrupt
|
| D | wii.txt | 67 1.d) The Serial Interface (SI) node
70 The SI is a proprietary serial interface used normally to control gamepads.
76 - reg : should contain the SI registers location and length
77 - interrupts : should contain the SI interrupt
|
| /linux-5.19.10/tools/perf/arch/x86/util/ |
| D | unwind-libdw.c | 27 dwarf_regs[6] = REG(SI); in libdw__arch_set_initial_registers()
36 dwarf_regs[4] = REG(SI); in libdw__arch_set_initial_registers()
|
| D | perf_regs.c | 20 SMPL_REG(SI, PERF_REG_X86_SI),
|
| /linux-5.19.10/Documentation/devicetree/bindings/soc/fsl/cpm_qe/ |
| D | qe.txt | 102 * Serial Interface Block (SI)
104 The SI manages the routing of eight TDM lines to the QE block serial drivers
110 - reg : Address range of SI register set.
121 store the routing entries of SI
126 - reg : Address range of SI RAM.
|
| /linux-5.19.10/include/math-emu/ |
| D | soft-fp.h | 193 typedef int SItype __attribute__((mode(SI)));
195 typedef unsigned int USItype __attribute__((mode(SI)));
|
| /linux-5.19.10/lib/ |
| D | locking-selftest-spin.h | 12 #define INIT SI
|
| /linux-5.19.10/Documentation/devicetree/bindings/net/ |
| D | ftgmac100.txt | 22 - use-ncsi: Use the NC-SI stack instead of an MDIO PHY. Currently assumes
23 rmii (100bT) but kept as a separate property in case NC-SI grows support
|
| /linux-5.19.10/lib/mpi/ |
| D | mpi-internal.h | 218 typedef int SItype __attribute__ ((mode(SI)));
219 typedef unsigned int USItype __attribute__ ((mode(SI)));
|
| /linux-5.19.10/arch/powerpc/xmon/ |
| D | ppc-opc.c | 644 #define SI SHO + 1 macro
649 #define SISIGNOPT SI + 1
3038 {"tdlgti", OPTO(2,TOLGT), OPTO_MASK, PPC64, PPCVLE, {RA, SI}},
3039 {"tdllti", OPTO(2,TOLLT), OPTO_MASK, PPC64, PPCVLE, {RA, SI}},
3040 {"tdeqi", OPTO(2,TOEQ), OPTO_MASK, PPC64, PPCVLE, {RA, SI}},
3041 {"tdlgei", OPTO(2,TOLGE), OPTO_MASK, PPC64, PPCVLE, {RA, SI}},
3042 {"tdlnli", OPTO(2,TOLNL), OPTO_MASK, PPC64, PPCVLE, {RA, SI}},
3043 {"tdllei", OPTO(2,TOLLE), OPTO_MASK, PPC64, PPCVLE, {RA, SI}},
3044 {"tdlngi", OPTO(2,TOLNG), OPTO_MASK, PPC64, PPCVLE, {RA, SI}},
3045 {"tdgti", OPTO(2,TOGT), OPTO_MASK, PPC64, PPCVLE, {RA, SI}},
[all …]
|
| /linux-5.19.10/drivers/gpu/drm/amd/display/ |
| D | Kconfig | 33 Choose this option to enable new AMD DC support for SI asics
|
| /linux-5.19.10/Documentation/devicetree/bindings/iio/afe/ |
| D | temperature-sense-rtd.yaml | 21 The general transfer function here is (using SI units)
|
| D | temperature-transducer.yaml | 24 The general transfer function here is (using SI units)
|
| /linux-5.19.10/arch/um/os-Linux/skas/ |
| D | process.c | 41 R(SI); in ptrace_reg_name()
65 R(SI); in ptrace_reg_name()
|
| /linux-5.19.10/arch/x86/um/ |
| D | signal.c | 176 GETREG(SI, si); in copy_sc_from_user()
255 PUTREG(SI, si); in copy_sc_to_user()
|