Home
last modified time | relevance | path

Searched refs:wl1251_error (Results 1 – 12 of 12) sorted by relevance

/linux-3.4.99/drivers/net/wireless/wl1251/
Dcmd.c43 wl1251_error("command complete timeout"); in wl1251_cmd_send()
94 wl1251_error("TEST command answer error: %d", in wl1251_cmd_test()
123 wl1251_error("INTERROGATE command failed"); in wl1251_cmd_interrogate()
132 wl1251_error("INTERROGATE command error: %d", in wl1251_cmd_interrogate()
197 wl1251_error("VBM command failed"); in wl1251_cmd_vbm()
232 wl1251_error("rx %s cmd for channel %d failed", in wl1251_cmd_data_path()
242 wl1251_error("tx %s cmd for channel %d failed", in wl1251_cmd_data_path()
300 wl1251_error("failed to initiate cmd join"); in wl1251_cmd_join()
331 wl1251_error("cmd set_ps_mode failed"); in wl1251_cmd_ps_mode()
362 wl1251_error("read memory command failed: %d", ret); in wl1251_cmd_read_memory()
[all …]
Dspi.c60 wl1251_error("could not allocate cmd for spi reset"); in wl1251_spi_reset()
86 wl1251_error("could not allocate cmd for spi init"); in wl1251_spi_wake()
245 wl1251_error("no platform data"); in wl1251_spi_probe()
266 wl1251_error("spi_setup failed"); in wl1251_spi_probe()
272 wl1251_error("set power function missing in platform data"); in wl1251_spi_probe()
278 wl1251_error("irq missing in platform data"); in wl1251_spi_probe()
287 wl1251_error("request_irq() failed: %d", ret); in wl1251_spi_probe()
334 wl1251_error("failed to register spi driver: %d", ret); in wl1251_spi_init()
Dboot.c56 wl1251_error("soft reset timeout"); in wl1251_boot_soft_reset()
234 wl1251_error("chip id doesn't match after firmware boot"); in wl1251_boot_run_firmware()
245 wl1251_error("error reading hardware complete " in wl1251_boot_run_firmware()
258 wl1251_error("timeout waiting for the hardware to " in wl1251_boot_run_firmware()
306 wl1251_error("EVENT mask setting failed"); in wl1251_boot_run_firmware()
335 wl1251_error("firmware length not multiple of four"); in wl1251_boot_upload_firmware()
341 wl1251_error("allocation for firmware upload chunk failed"); in wl1251_boot_upload_firmware()
538 wl1251_error("boot failed, ECPU_CONTROL_HALT not set"); in wl1251_boot()
Dsdio.c79 wl1251_error("sdio read failed (%d)", ret); in wl1251_sdio_read()
92 wl1251_error("sdio write failed (%d)", ret); in wl1251_sdio_write()
113 wl1251_error("sdio_readb failed (%d)", ret); in wl1251_sdio_read_elp()
127 wl1251_error("sdio_writeb failed (%d)", ret); in wl1251_sdio_write_elp()
266 wl1251_error("request_irq() failed: %d", ret); in wl1251_sdio_probe()
360 wl1251_error("failed to register sdio driver: %d", err); in wl1251_sdio_init()
Dmain.c74 wl1251_error("could not get firmware: %d", ret); in wl1251_fetch_firmware()
79 wl1251_error("firmware size is not multiple of 32 bits: %zu", in wl1251_fetch_firmware()
89 wl1251_error("could not allocate memory for the firmware"); in wl1251_fetch_firmware()
113 wl1251_error("could not get nvs file: %d", ret); in wl1251_fetch_nvs()
118 wl1251_error("nvs size is not multiple of 32 bits: %zu", in wl1251_fetch_nvs()
128 wl1251_error("could not allocate memory for the nvs file"); in wl1251_fetch_nvs()
193 wl1251_error("unsupported chip id: 0x%x", wl->chip_id); in wl1251_chip_wakeup()
417 wl1251_error("cannot start because not in off state: %d", in wl1251_op_start()
768 wl1251_error("Unknown key cipher 0x%x", mac80211_key->cipher); in wl1251_set_key_type()
824 wl1251_error("Unsupported key cmd 0x%x", cmd); in wl1251_op_set_key()
[all …]
Dinit.c214 wl1251_error("couldn't allocate target memory map"); in wl1251_hw_init_mem_config()
222 wl1251_error("couldn't retrieve firmware memory map"); in wl1251_hw_init_mem_config()
263 wl1251_error("Invalid TX queue id: %d", qid); in wl1251_hw_init_txq_fill()
314 wl1251_error("Couldnt allocate data path parameters"); in wl1251_hw_init_data_path_config()
Dps.c92 wl1251_error("elp wakeup timeout"); in wl1251_ps_elp_wakeup()
Dio.c49 wl1251_error("address out of range (%d)", addr); in wl1251_translate_reg_addr()
Drx.c175 wl1251_error("Couldn't allocate RX frame"); in wl1251_rx_body()
Dtx.c221 wl1251_error("Can't allocate skb!"); in wl1251_tx_send_packet()
390 wl1251_error("SKB for packet %d is NULL", result->id); in wl1251_tx_packet_cb()
Dacx.c34 wl1251_error("Failed to set FW rates and modulation"); in wl1251_acx_frame_rates()
87 wl1251_error("Couldn't set default key"); in wl1251_acx_default_key()
232 wl1251_error("Couldn't set HW encryption"); in wl1251_acx_feature_cfg()
Dwl1251.h57 #define wl1251_error(fmt, arg...) \ macro