Searched refs:asserted (Results 1 – 25 of 28) sorted by relevance
12
| /linux-3.4.99/Documentation/video4linux/bttv/ |
| D | README.quirks | 54 rules are satisfied. Before GNT is asserted by the PCI arbiter, this
59 FRAME will be asserted (typically - each initiator will assert FRAME on
60 the cycle following GNT). When FRAME is asserted, it is the initiator s
63 not allow the other request to hold REQ asserted. The decision lock may
66 asynchronously until GNT is again asserted.
73 during the same cycle that GNT is de-asserted. This is non PCI 2.1
77 to the internal functions unless REQ is asserted. This prevents a bus
78 transaction from starting the same cycle as GNT is de-asserted. This
|
| /linux-3.4.99/Documentation/hwmon/ |
| D | adm9240 | 77 Temperature alarm is asserted once the temperature exceeds the high limit,
99 - low speed alarm will be asserted if fan speed is
110 - alarm will be asserted
139 An alarm is asserted for any voltage going below or above the set limits.
150 An alarm is asserted when the CI pin goes active high. The ADM9240
|
| D | lm93 | 92 signals. I.e. when #P1_PROCHOT is asserted, the LM93 will automatically
112 which 1 indicates #VRD_HOT is asserted and 0 indicates it is negated. These
233 If the #PROCHOT or #VRDHOT signals are asserted while bound to a PWM output
282 vrdhot<n> 0 means negated, 1 means asserted
292 pwm_auto_prochot_ramp ramp time per step when #PROCHOT asserted
294 pwm_auto_vrdhot_ramp ramp time per step when #VRDHOT asserted
|
| D | adm1026 | 46 be asserted. The current temperature and limits have a resolution of 1
|
| D | w83792d | 89 Tart will be asserted while target temperature cannot be achieved after 3 minutes
|
| D | lm85 | 227 Tmin control and THERM asserted counts. Automatic Tmin control acts to
|
| /linux-3.4.99/Documentation/blackfin/ |
| D | bfin-spi-notes.txt | 6 the Slave Select is always under software control and being asserted during
|
| /linux-3.4.99/drivers/net/ethernet/broadcom/bnx2x/ |
| D | bnx2x_main.c | 3347 static void bnx2x_attn_int_asserted(struct bnx2x *bp, u32 asserted) in bnx2x_attn_int_asserted() argument
3358 if (bp->attn_state & asserted) in bnx2x_attn_int_asserted()
3365 aeu_mask, asserted); in bnx2x_attn_int_asserted()
3366 aeu_mask &= ~(asserted & 0x3ff); in bnx2x_attn_int_asserted()
3373 bp->attn_state |= asserted; in bnx2x_attn_int_asserted()
3376 if (asserted & ATTN_HARD_WIRED_MASK) { in bnx2x_attn_int_asserted()
3377 if (asserted & ATTN_NIG_FOR_FUNC) { in bnx2x_attn_int_asserted()
3395 if (asserted & ATTN_SW_TIMER_4_FUNC) in bnx2x_attn_int_asserted()
3398 if (asserted & GPIO_2_FUNC) in bnx2x_attn_int_asserted()
3401 if (asserted & GPIO_3_FUNC) in bnx2x_attn_int_asserted()
[all …]
|
| /linux-3.4.99/Documentation/devicetree/bindings/powerpc/fsl/ |
| D | dcsr.txt | 76 match. Which counter asserted the interrupt is captured in an EPU
82 Which event source asserted the interrupt is captured in an EPU
|
| /linux-3.4.99/Documentation/ |
| D | memory-hotplug.txt | 196 memory class object of _HID "PNP0C80". When a notify is asserted to PNP0C80,
205 "PNP0A05", or "PNP0A06", notification is asserted to it, and ACPI handler
|
| /linux-3.4.99/Documentation/spi/ |
| D | pxa2xx | 140 asserted around the complete message. Use SSPFRM as a GPIO (through cs_control)
|
| /linux-3.4.99/Documentation/networking/caif/ |
| D | spi_porting.txt | 43 variable indicates whether the GPIO should be asserted (HIGH) or
|
| /linux-3.4.99/drivers/scsi/aic7xxx/ |
| D | aic79xx.seq | 359 * ATN can be asserted even if the current
804 * we have selected out with ATN asserted and the target
840 * asserted.
1395 * they were asserted within the bus settle delay window.
1399 * an async phase due to our asserted ACK. Each
2006 * will not be asserted if the NONPACKREQ is for us,
|
| D | aic7xxx.seq | 231 * If ATN isn't asserted, the target isn't interested
649 * asserted.
|
| /linux-3.4.99/tools/perf/ |
| D | design.txt | 120 cycles while bus lock signal asserted" events on Intel Core CPUs, pass
|
| /linux-3.4.99/Documentation/scsi/ |
| D | sym53c8xx_2.txt | 563 logic state, 100 micro-seconds after having asserted the SCSI RESET line.
566 RESET has been asserted, any signal to TRUE may indicate a SCSI BUS problem.
|
| D | ncr53c8xx.txt | 997 logic state, 100 micro-seconds after having asserted the SCSI RESET line.
1000 RESET has been asserted, any signal to TRUE may indicate a SCSI BUS problem.
|
| /linux-3.4.99/Documentation/networking/ |
| D | z8530drv.txt | 453 will just wait until the CTS signal is asserted. This
|
| /linux-3.4.99/tools/power/cpupower/po/ |
| D | de.po | 360 msgid " (asserted by call to hardware)"
|
| D | cs.po | 363 msgid " (asserted by call to hardware)"
|
| D | it.po | 358 msgid " (asserted by call to hardware)"
|
| D | pt.po | 357 msgid " (asserted by call to hardware)"
|
| D | fr.po | 358 msgid " (asserted by call to hardware)"
|
| /linux-3.4.99/drivers/scsi/aic7xxx_old/ |
| D | aic7xxx.reg | 127 * asserted.
|
| /linux-3.4.99/Documentation/PCI/ |
| D | pci.txt | 457 it was one of the remaining devices asserted the IRQ line. Since none
|
12