| /linux-3.4.99/drivers/net/ethernet/smsc/ |
| D | smc9194.h | 80 #define RCR 4 macro
207 #define SMC_DELAY() { inw( ioaddr + RCR );\
208 inw( ioaddr + RCR );\
209 inw( ioaddr + RCR ); }
|
| D | smc9194.c | 339 outw( RCR_SOFTRESET, ioaddr + RCR ); in smc_reset()
346 outw( RCR_CLEAR, ioaddr + RCR ); in smc_reset()
379 outw( RCR_NORMAL, ioaddr + RCR ); in smc_enable()
408 outb( RCR_CLEAR, ioaddr + RCR ); in smc_shutdown()
1513 outw( inw(ioaddr + RCR ) | RCR_PROMISC, ioaddr + RCR ); in smc_set_multicast_list()
1525 outw( inw(ioaddr + RCR ) | RCR_ALMUL, ioaddr + RCR ); in smc_set_multicast_list()
1534 outw( inw( ioaddr + RCR ) & ~(RCR_PROMISC | RCR_ALMUL), in smc_set_multicast_list()
1535 ioaddr + RCR ); in smc_set_multicast_list()
1541 outw( inw( ioaddr + RCR ) & ~(RCR_PROMISC | RCR_ALMUL), in smc_set_multicast_list()
1542 ioaddr + RCR ); in smc_set_multicast_list()
|
| D | smc91c92_cs.c | 225 #define RCR 4 macro
1101 mask_bits(0xff00, ioaddr + RCR); in smc_close()
1580 outw(rx_cfg_setting, ioaddr + RCR); in set_rx_mode()
1652 outw(RCR_SOFTRESET, ioaddr + RCR); in smc_reset()
1656 outw(RCR_CLEAR, ioaddr + RCR); in smc_reset()
|
| /linux-3.4.99/drivers/staging/rtl8712/ |
| D | hal_init.c | 338 printk(KERN_INFO "r8712u: 1 RCR=0x%x\n", r8712_read32(padapter, RCR)); in rtl8712_hal_init()
339 val32 = r8712_read32(padapter, RCR); in rtl8712_hal_init()
340 r8712_write32(padapter, RCR, (val32 | BIT(26))); /* Enable RX TCP in rtl8712_hal_init()
342 printk(KERN_INFO "r8712u: 2 RCR=0x%x\n", r8712_read32(padapter, RCR)); in rtl8712_hal_init()
343 val32 = r8712_read32(padapter, RCR); in rtl8712_hal_init()
344 r8712_write32(padapter, RCR, (val32|BIT(25))); /* Append PHY status */ in rtl8712_hal_init()
|
| D | rtl8712_cmdctrl_regdef.h | 27 #define RCR (RTL8712_CMDCTRL_ + 0x0008) macro
|
| D | rtl871x_mp_ioctl.c | 298 r8712_write8(Adapter, RCR, 0); /* RCR : disable all pkt, 0x10250048 */ in oid_rt_pro_start_test_hdl()
300 r8712_write8(Adapter, RCR+2, 0x57); in oid_rt_pro_start_test_hdl()
1369 rcr_val32 = r8712_read32(Adapter, RCR);/*RCR = 0x10250048*/ in oid_rt_set_rx_packet_type_hdl()
1393 r8712_write32(Adapter, RCR, rcr_val32); in oid_rt_set_rx_packet_type_hdl()
|
| /linux-3.4.99/drivers/rtc/ |
| D | rtc-r9701.c | 41 #define RCR 0x0f /* RTC Control Register */ macro
|
| /linux-3.4.99/drivers/tty/ |
| D | synclink_gt.c | 399 #define RCR 0x86 /* rx control */ macro
2753 wr_reg16(info, RCR, rd_reg16(info, RCR) | BIT3); in rx_enable()
3974 val = rd_reg16(info, RCR) & ~BIT1; /* clear enable bit */ in rx_stop()
3975 wr_reg16(info, RCR, (unsigned short)(val | BIT2)); /* set reset bit */ in rx_stop()
3976 wr_reg16(info, RCR, val); /* clear reset bit */ in rx_stop()
3999 val = rd_reg16(info, RCR) & ~BIT1; /* clear enable bit */ in rx_start()
4000 wr_reg16(info, RCR, (unsigned short)(val | BIT2)); /* set reset bit */ in rx_start()
4001 wr_reg16(info, RCR, val); /* clear reset bit */ in rx_start()
4032 wr_reg16(info, RCR, (unsigned short)(rd_reg16(info, RCR) | BIT1)); in rx_start()
4209 wr_reg16(info, RCR, val); in async_mode()
[all …]
|
| /linux-3.4.99/drivers/spi/ |
| D | spi-atmel.c | 400 spi_writel(as, RCR, len); in atmel_spi_next_xfer()
621 spi_readl(as, TCR), spi_readl(as, RCR)); in atmel_spi_interrupt()
629 spi_writel(as, RCR, 0); in atmel_spi_interrupt()
|
| /linux-3.4.99/drivers/net/usb/ |
| D | rtl8150.c | 29 #define RCR 0x0130 macro
636 set_registers(dev, RCR, 1, &rcr); in enable_net_traffic()
677 async_set_registers(dev, RCR, 2); in rtl8150_set_multicast()
|
| /linux-3.4.99/drivers/net/wireless/rtlwifi/rtl8192se/ |
| D | fw.c | 329 tmpu4b = rtl_read_dword(rtlpriv, RCR); in _rtl92s_firmware_checkready()
330 rtl_write_dword(rtlpriv, RCR, (tmpu4b | RCR_APPFCS | in _rtl92s_firmware_checkready()
|
| D | reg.h | 62 #define RCR 0x0048 macro
|
| D | hw.c | 311 rtl_write_dword(rtlpriv, RCR, ((u32 *) (val))[0]); in rtl92se_set_hw_reg()
763 rtl_write_dword(rtlpriv, RCR, rtlpci->receive_config); in _rtl92se_macconfig_after_fwdownload()
|
| /linux-3.4.99/drivers/staging/rtl8192u/ |
| D | r8192U_hw.h | 130 RCR = 0x044, // Receive Configuration Register enumerator
|
| D | r8192U_core.c | 963 rxconf=read_nic_dword(dev,RCR); in rtl8192_set_rxconf()
1005 write_nic_dword(dev, RCR, rxconf); in rtl8192_set_rxconf()
1008 DMESG("rxconf: %x %x",rxconf ,read_nic_dword(dev,RCR)); in rtl8192_set_rxconf()
2334 reg = read_nic_dword(dev, RCR); in rtl8192_link_change()
2339 write_nic_dword(dev, RCR, reg); in rtl8192_link_change()
3355 write_nic_dword(dev, RCR, priv->ReceiveConfig); in rtl8192_adapter_start()
|
| /linux-3.4.99/drivers/staging/rtl8187se/ |
| D | r8180_hw.h | 191 #define RCR 0x0044 macro
|
| D | r8185b_init.c | 860 write_nic_dword(dev, RCR, priv->ReceiveConfig); in PhyConfig8185()
1743 write_nic_dword(dev, RCR, priv->ReceiveConfig); in rtl8185b_rx_enable()
|
| D | r8180_core.c | 2880 if (RCR_9356SEL & read_nic_dword(dev, RCR)) in rtl8180_init()
|
| /linux-3.4.99/drivers/net/wan/ |
| D | hd64572.h | 110 #define RCR 0x156 /* Rx DMA Critical Request Reg */ macro
|
| D | pc300_drv.c | 2463 cpc_readb(scabase + M_REG(RCR, ch)), in cpc_sca_status()
|
| /linux-3.4.99/drivers/staging/rtl8192e/rtl8192e/ |
| D | r8192E_dev.c | 145 RegRCR = read_nic_dword(dev, RCR); in rtl8192e_SetHwReg()
153 write_nic_dword(dev, RCR, RegRCR); in rtl8192e_SetHwReg()
777 write_nic_dword(dev, RCR, priv->ReceiveConfig); in rtl8192_adapter_start()
1005 reg = read_nic_dword(dev, RCR); in rtl8192_link_change()
1014 write_nic_dword(dev, RCR, reg); in rtl8192_link_change()
1029 write_nic_dword(dev, RCR, priv->ReceiveConfig); in rtl8192_AllowAllDestAddr()
|
| D | r8192E_hw.h | 143 RCR = 0x044, enumerator
|
| /linux-3.4.99/drivers/net/ethernet/via/ |
| D | via-velocity.h | 979 volatile u8 RCR; member
|
| D | via-velocity.c | 1158 BYTE_REG_BITS_ON(rx_mode, ®s->RCR); in velocity_set_multi()
|
| /linux-3.4.99/arch/x86/lib/ |
| D | x86-opcode-map.txt | 808 3: RCR
|