Searched refs:asserted (Results 1 – 21 of 21) sorted by relevance
| /linux-2.6.39/Documentation/video4linux/bttv/ |
| D | README.quirks | 54 rules are satisfied. Before GNT is asserted by the PCI arbiter, this
59 FRAME will be asserted (typically - each initiator will assert FRAME on
60 the cycle following GNT). When FRAME is asserted, it is the initiator s
63 not allow the other request to hold REQ asserted. The decision lock may
66 asynchronously until GNT is again asserted.
73 during the same cycle that GNT is de-asserted. This is non PCI 2.1
77 to the internal functions unless REQ is asserted. This prevents a bus
78 transaction from starting the same cycle as GNT is de-asserted. This
|
| /linux-2.6.39/Documentation/hwmon/ |
| D | adm9240 | 77 Temperature alarm is asserted once the temperature exceeds the high limit,
99 - low speed alarm will be asserted if fan speed is
110 - alarm will be asserted
139 An alarm is asserted for any voltage going below or above the set limits.
150 An alarm is asserted when the CI pin goes active high. The ADM9240
|
| D | lm93 | 92 signals. I.e. when #P1_PROCHOT is asserted, the LM93 will automatically
112 which 1 indicates #VRD_HOT is asserted and 0 indicates it is negated. These
233 If the #PROCHOT or #VRDHOT signals are asserted while bound to a PWM output
282 vrdhot<n> 0 means negated, 1 means asserted
292 pwm_auto_prochot_ramp ramp time per step when #PROCHOT asserted
294 pwm_auto_vrdhot_ramp ramp time per step when #VRDHOT asserted
|
| D | adm1026 | 46 be asserted. The current temperature and limits have a resolution of 1
|
| D | w83792d | 89 Tart will be asserted while target temperature cannot be achieved after 3 minutes
|
| D | lm85 | 227 Tmin control and THERM asserted counts. Automatic Tmin control acts to
|
| /linux-2.6.39/Documentation/blackfin/ |
| D | bfin-spi-notes.txt | 6 the Slave Select is always under software control and being asserted during
|
| /linux-2.6.39/drivers/net/bnx2x/ |
| D | bnx2x_main.c | 2865 static void bnx2x_attn_int_asserted(struct bnx2x *bp, u32 asserted) in bnx2x_attn_int_asserted() argument
2876 if (bp->attn_state & asserted) in bnx2x_attn_int_asserted()
2883 aeu_mask, asserted); in bnx2x_attn_int_asserted()
2884 aeu_mask &= ~(asserted & 0x3ff); in bnx2x_attn_int_asserted()
2891 bp->attn_state |= asserted; in bnx2x_attn_int_asserted()
2894 if (asserted & ATTN_HARD_WIRED_MASK) { in bnx2x_attn_int_asserted()
2895 if (asserted & ATTN_NIG_FOR_FUNC) { in bnx2x_attn_int_asserted()
2907 if (asserted & ATTN_SW_TIMER_4_FUNC) in bnx2x_attn_int_asserted()
2910 if (asserted & GPIO_2_FUNC) in bnx2x_attn_int_asserted()
2913 if (asserted & GPIO_3_FUNC) in bnx2x_attn_int_asserted()
[all …]
|
| /linux-2.6.39/Documentation/ |
| D | memory-hotplug.txt | 196 memory class object of _HID "PNP0C80". When a notify is asserted to PNP0C80,
205 "PNP0A05", or "PNP0A06", notification is asserted to it, and ACPI handler
|
| /linux-2.6.39/Documentation/spi/ |
| D | pxa2xx | 145 asserted around the complete message. Use SSPFRM as a GPIO (through cs_control)
|
| /linux-2.6.39/Documentation/networking/caif/ |
| D | spi_porting.txt | 43 variable indicates whether the GPIO should be asserted (HIGH) or
|
| /linux-2.6.39/drivers/scsi/aic7xxx/ |
| D | aic79xx.seq | 359 * ATN can be asserted even if the current
804 * we have selected out with ATN asserted and the target
840 * asserted.
1395 * they were asserted within the bus settle delay window.
1399 * an async phase due to our asserted ACK. Each
2006 * will not be asserted if the NONPACKREQ is for us,
|
| D | aic7xxx.seq | 231 * If ATN isn't asserted, the target isn't interested
649 * asserted.
|
| D | aic7xxx.reg | 147 * asserted.
|
| /linux-2.6.39/tools/perf/ |
| D | design.txt | 120 cycles while bus lock signal asserted" events on Intel Core CPUs, pass
|
| /linux-2.6.39/Documentation/scsi/ |
| D | sym53c8xx_2.txt | 563 logic state, 100 micro-seconds after having asserted the SCSI RESET line.
566 RESET has been asserted, any signal to TRUE may indicate a SCSI BUS problem.
|
| D | ncr53c8xx.txt | 997 logic state, 100 micro-seconds after having asserted the SCSI RESET line.
1000 RESET has been asserted, any signal to TRUE may indicate a SCSI BUS problem.
|
| /linux-2.6.39/Documentation/networking/ |
| D | z8530drv.txt | 453 will just wait until the CTS signal is asserted. This
|
| /linux-2.6.39/drivers/scsi/aic7xxx_old/ |
| D | aic7xxx.reg | 127 * asserted.
|
| D | aic7xxx.seq | 280 * into the message out phase since we have ATN asserted.
|
| /linux-2.6.39/Documentation/PCI/ |
| D | pci.txt | 457 it was one of the remaining devices asserted the IRQ line. Since none
|