| /linux-2.6.39/Documentation/video4linux/cx2341x/ |
| D | fw-decoder-regs.txt | 111 Normally = Reg 2854 >> 2
121 Normally = Reg 2854 >> 2
150 Normally = Reg 2854 >> 1
160 Normally = Reg 2854 >> 1
170 correctly set the divider in Reg 2874.
173 Reg 2854 = (source_width * 0x00200000) / destination_width
174 Reg 2874 = No divide
177 Reg 2854 = (source_width/2 * 0x00200000) / destination width
178 Reg 2874 = Divide by 2
181 Reg 2854 = (source_width/4 * 0x00200000) / destination width
[all …]
|
| /linux-2.6.39/drivers/staging/xgifb/ |
| D | vb_struct.h | 31 unsigned char Reg[8]; member
36 unsigned char Reg[7]; member
301 unsigned char Reg[16]; member
368 unsigned char Reg[64]; /* C0-FF */ member
|
| D | vb_setmode.c | 2585 pVBInfo->TimingH[0].data[i] = LCDPtr[0].Reg[i]; in XGI_ModCRT1Regs()
2629 pVBInfo->TimingV[0].data[i] = LCDPtr1[0].Reg[i]; in XGI_ModCRT1Regs()
5966 xgifb_reg_set(pVBInfo->Part2Port, i, Tap4TimingPtr->Reg[j]); in XGI_SetTap4Regs()
5971 xgifb_reg_set(pVBInfo->Part2Port, i, Tap4TimingPtr->Reg[j]); in XGI_SetTap4Regs()
|
| /linux-2.6.39/drivers/usb/serial/ |
| D | io_ionsp.h | 197 #define MAKE_CMD_WRITE_REG(ppBuf, pLen, Port, Reg, Val) \ argument
200 IOSP_WRITE_UART_REG(Reg)); \
|
| /linux-2.6.39/Documentation/hwmon/ |
| D | smsc47b397 | 75 Reg 0x28 = 0x9B
76 Reg 0x29 = 0x08
150 OUT DX,AL ;Point to LD# Config Reg
|
| /linux-2.6.39/arch/arm/mach-tegra/ |
| D | headsmp.S | 40 orr r5, r5, r6 @ Reg = (Temp<<WayShift)|(NumSets<<SetShift)
|
| /linux-2.6.39/arch/m32r/kernel/ |
| D | head.S | 148 st r5, @r4 ; Set MATM Reg(T bit ON)
210 st r5, @r4 ; Set MATM Reg(T bit OFF)
|
| /linux-2.6.39/arch/arm/boot/compressed/ |
| D | head-sharpsl.S | 102 .word 0x08010000 @ w100 Chip ID Reg Address
|
| /linux-2.6.39/drivers/scsi/aic94xx/ |
| D | aic94xx_reg_def.h | 520 #define CSEQm_CIO_REG(Mode, Reg) \ argument
522 ((u32) (Mode) * CSEQ_MODE_PAGE_SIZE) + (u32) (Reg))
856 #define LmSEQ_PHY_REG(Mode, LinkNum, Reg) \ argument
857 (LmSEQ_PHY_BASE(Mode, LinkNum) + (u32) (Reg))
|
| /linux-2.6.39/drivers/video/sis/ |
| D | vstruct.h | 103 unsigned char Reg[16]; member
|
| D | init301.c | 7891 SiS_SetCH700x(SiS_Pr,0x00,CHTVRegData[resindex].Reg[0]); /* Mode register */ in SiS_SetCHTVReg()
7892 SiS_SetCH700x(SiS_Pr,0x07,CHTVRegData[resindex].Reg[1]); /* Start active video register */ in SiS_SetCHTVReg()
7893 SiS_SetCH700x(SiS_Pr,0x08,CHTVRegData[resindex].Reg[2]); /* Position overflow register */ in SiS_SetCHTVReg()
7894 SiS_SetCH700x(SiS_Pr,0x0a,CHTVRegData[resindex].Reg[3]); /* Horiz Position register */ in SiS_SetCHTVReg()
7895 SiS_SetCH700x(SiS_Pr,0x0b,CHTVRegData[resindex].Reg[4]); /* Vertical Position register */ in SiS_SetCHTVReg()
7996 temp = CHTVRegData[resindex].Reg[0]; in SiS_SetCHTVReg()
8000 SiS_SetCH701x(SiS_Pr,0x01,CHTVRegData[resindex].Reg[1]); in SiS_SetCHTVReg()
8001 SiS_SetCH701x(SiS_Pr,0x02,CHTVRegData[resindex].Reg[2]); in SiS_SetCHTVReg()
8002 SiS_SetCH701x(SiS_Pr,0x04,CHTVRegData[resindex].Reg[3]); in SiS_SetCHTVReg()
8003 SiS_SetCH701x(SiS_Pr,0x03,CHTVRegData[resindex].Reg[4]); in SiS_SetCHTVReg()
[all …]
|
| /linux-2.6.39/Documentation/isdn/ |
| D | README | 136 Reg 14 (Layer-2 protocol):
141 Reg 18.2 = 1
142 Reg 19 (Additional Service Indicator):
147 Note on value in Reg 19:
|
| /linux-2.6.39/arch/m32r/mm/ |
| D | mmu.S | 326 st r1, @(MPSZ_offset,r0) ; Set MPSZ Reg(Page size 4KB:0 16KB:1 64KB:2)
|
| /linux-2.6.39/arch/m68k/fpsp040/ |
| D | util.S | 636 | | 0 | Size | Dest Reg # |
|