Searched refs:rear (Results 1 – 7 of 7) sorted by relevance
| /linux-2.4.37.9/drivers/sound/dmasound/ |
| D | dmasound_core.c | 524 sq->rear = -1; in sq_setup()
529 sq->rear = 0; in sq_setup()
606 dest = write_sq.buffers[write_sq.rear]; in sq_write()
635 dest = write_sq.buffers[(write_sq.rear+1) % write_sq.max_count]; in sq_write()
646 write_sq.rear = (write_sq.rear+1) % write_sq.max_count; in sq_write()
744 while (read_sq.front == read_sq.rear) { in sq_read()
944 write_sq.rear = -1 ; /* same as for set-up */ in sq_reset_output()
975 read_sq.rear = 0 ; in sq_reset_input()
1506 write_sq.max_active, write_sq.front, write_sq.rear, in state_open()
1513 read_sq.max_active, read_sq.front, read_sq.rear, in state_open()
|
| D | dmasound_awacs.c | 1032 while ((stat=awacs_rx_cmds[read_sq.rear].xfer_status)) { in pmac_awacs_rx_intr()
1047 awacs_rx_cmds[read_sq.rear].xfer_status = 0; in pmac_awacs_rx_intr()
1048 awacs_rx_cmds[read_sq.rear].res_count = 0; in pmac_awacs_rx_intr()
1053 virt_to_bus(&awacs_rx_cmds[read_sq.rear])); in pmac_awacs_rx_intr()
1063 awacs_rx_cmds[read_sq.rear].xfer_status = 0; in pmac_awacs_rx_intr()
1064 read_sq.rear++; in pmac_awacs_rx_intr()
1068 if (read_sq.rear >= read_sq.max_active) in pmac_awacs_rx_intr()
1069 read_sq.rear = 0; in pmac_awacs_rx_intr()
1077 if (read_sq.rear == read_sq.front) { in pmac_awacs_rx_intr()
|
| D | dmasound.h | 235 int front, rear, count; member
|
| /linux-2.4.37.9/Documentation/sound/ |
| D | CMI8338 | 80 rear-out.
|
| /linux-2.4.37.9/Documentation/input/ |
| D | joystick.txt | 260 rear side of the joystick. However, moving it, you'll reset the joystick,
|
| /linux-2.4.37.9/Documentation/networking/ |
| D | arcnet-hardware.txt | 715 Two diagnostic LEDs are visible on the rear bracket of the board.
942 Two diagnostic LEDs are visible on the rear bracket of the board.
|
| /linux-2.4.37.9/Documentation/ |
| D | Configure.help | 22031 Say Y here to enable using line-in jack as an output jack for a rear
|