1 #ifndef __PLAT_DMA_H 2 #define __PLAT_DMA_H 3 4 #define DMAC_REG(x) (*((volatile u32 *)(DMAC_REGS_VIRT + (x)))) 5 6 #define DCSR(n) DMAC_REG((n) << 2) 7 #define DALGN DMAC_REG(0x00a0) /* DMA Alignment Register */ 8 #define DINT DMAC_REG(0x00f0) /* DMA Interrupt Register */ 9 #define DDADR(n) DMAC_REG(0x0200 + ((n) << 4)) 10 #define DSADR(n) DMAC_REG(0x0204 + ((n) << 4)) 11 #define DTADR(n) DMAC_REG(0x0208 + ((n) << 4)) 12 #define DCMD(n) DMAC_REG(0x020c + ((n) << 4)) 13 #define DRCMR(n) DMAC_REG((((n) < 64) ? 0x0100 : 0x1100) + \ 14 (((n) & 0x3f) << 2)) 15 16 #define DCSR_RUN (1 << 31) /* Run Bit (read / write) */ 17 #define DCSR_NODESC (1 << 30) /* No-Descriptor Fetch (read / write) */ 18 #define DCSR_STOPIRQEN (1 << 29) /* Stop Interrupt Enable (read / write) */ 19 #define DCSR_REQPEND (1 << 8) /* Request Pending (read-only) */ 20 #define DCSR_STOPSTATE (1 << 3) /* Stop State (read-only) */ 21 #define DCSR_ENDINTR (1 << 2) /* End Interrupt (read / write) */ 22 #define DCSR_STARTINTR (1 << 1) /* Start Interrupt (read / write) */ 23 #define DCSR_BUSERR (1 << 0) /* Bus Error Interrupt (read / write) */ 24 25 #define DCSR_EORIRQEN (1 << 28) /* End of Receive Interrupt Enable (R/W) */ 26 #define DCSR_EORJMPEN (1 << 27) /* Jump to next descriptor on EOR */ 27 #define DCSR_EORSTOPEN (1 << 26) /* STOP on an EOR */ 28 #define DCSR_SETCMPST (1 << 25) /* Set Descriptor Compare Status */ 29 #define DCSR_CLRCMPST (1 << 24) /* Clear Descriptor Compare Status */ 30 #define DCSR_CMPST (1 << 10) /* The Descriptor Compare Status */ 31 #define DCSR_EORINTR (1 << 9) /* The end of Receive */ 32 33 #define DRCMR_MAPVLD (1 << 7) /* Map Valid (read / write) */ 34 #define DRCMR_CHLNUM 0x1f /* mask for Channel Number (read / write) */ 35 36 #define DDADR_DESCADDR 0xfffffff0 /* Address of next descriptor (mask) */ 37 #define DDADR_STOP (1 << 0) /* Stop (read / write) */ 38 39 #define DCMD_INCSRCADDR (1 << 31) /* Source Address Increment Setting. */ 40 #define DCMD_INCTRGADDR (1 << 30) /* Target Address Increment Setting. */ 41 #define DCMD_FLOWSRC (1 << 29) /* Flow Control by the source. */ 42 #define DCMD_FLOWTRG (1 << 28) /* Flow Control by the target. */ 43 #define DCMD_STARTIRQEN (1 << 22) /* Start Interrupt Enable */ 44 #define DCMD_ENDIRQEN (1 << 21) /* End Interrupt Enable */ 45 #define DCMD_ENDIAN (1 << 18) /* Device Endian-ness. */ 46 #define DCMD_BURST8 (1 << 16) /* 8 byte burst */ 47 #define DCMD_BURST16 (2 << 16) /* 16 byte burst */ 48 #define DCMD_BURST32 (3 << 16) /* 32 byte burst */ 49 #define DCMD_WIDTH1 (1 << 14) /* 1 byte width */ 50 #define DCMD_WIDTH2 (2 << 14) /* 2 byte width (HalfWord) */ 51 #define DCMD_WIDTH4 (3 << 14) /* 4 byte width (Word) */ 52 #define DCMD_LENGTH 0x01fff /* length mask (max = 8K - 1) */ 53 54 /* 55 * Descriptor structure for PXA's DMA engine 56 * Note: this structure must always be aligned to a 16-byte boundary. 57 */ 58 59 typedef struct pxa_dma_desc { 60 volatile u32 ddadr; /* Points to the next descriptor + flags */ 61 volatile u32 dsadr; /* DSADR value for the current transfer */ 62 volatile u32 dtadr; /* DTADR value for the current transfer */ 63 volatile u32 dcmd; /* DCMD value for the current transfer */ 64 } pxa_dma_desc; 65 66 typedef enum { 67 DMA_PRIO_HIGH = 0, 68 DMA_PRIO_MEDIUM = 1, 69 DMA_PRIO_LOW = 2 70 } pxa_dma_prio; 71 72 /* 73 * DMA registration 74 */ 75 76 int __init pxa_init_dma(int irq, int num_ch); 77 78 int pxa_request_dma (char *name, 79 pxa_dma_prio prio, 80 void (*irq_handler)(int, void *), 81 void *data); 82 83 void pxa_free_dma (int dma_ch); 84 85 #endif /* __PLAT_DMA_H */ 86