1 /* SPDX-License-Identifier: GPL-2.0 */
2 /*
3  * This file holds the definitions of quirks found in USB devices.
4  * Only quirks that affect the whole device, not an interface,
5  * belong here.
6  */
7 
8 #ifndef __LINUX_USB_QUIRKS_H
9 #define __LINUX_USB_QUIRKS_H
10 
11 /* string descriptors must not be fetched using a 255-byte read */
12 #define USB_QUIRK_STRING_FETCH_255		BIT(0)
13 
14 /* device can't resume correctly so reset it instead */
15 #define USB_QUIRK_RESET_RESUME			BIT(1)
16 
17 /* device can't handle Set-Interface requests */
18 #define USB_QUIRK_NO_SET_INTF			BIT(2)
19 
20 /* device can't handle its Configuration or Interface strings */
21 #define USB_QUIRK_CONFIG_INTF_STRINGS		BIT(3)
22 
23 /* device can't be reset(e.g morph devices), don't use reset */
24 #define USB_QUIRK_RESET				BIT(4)
25 
26 /* device has more interface descriptions than the bNumInterfaces count,
27    and can't handle talking to these interfaces */
28 #define USB_QUIRK_HONOR_BNUMINTERFACES		BIT(5)
29 
30 /* device needs a pause during initialization, after we read the device
31    descriptor */
32 #define USB_QUIRK_DELAY_INIT			BIT(6)
33 
34 /*
35  * For high speed and super speed interrupt endpoints, the USB 2.0 and
36  * USB 3.0 spec require the interval in microframes
37  * (1 microframe = 125 microseconds) to be calculated as
38  * interval = 2 ^ (bInterval-1).
39  *
40  * Devices with this quirk report their bInterval as the result of this
41  * calculation instead of the exponent variable used in the calculation.
42  */
43 #define USB_QUIRK_LINEAR_UFRAME_INTR_BINTERVAL	BIT(7)
44 
45 /* device can't handle device_qualifier descriptor requests */
46 #define USB_QUIRK_DEVICE_QUALIFIER		BIT(8)
47 
48 /* device generates spurious wakeup, ignore remote wakeup capability */
49 #define USB_QUIRK_IGNORE_REMOTE_WAKEUP		BIT(9)
50 
51 /* device can't handle Link Power Management */
52 #define USB_QUIRK_NO_LPM			BIT(10)
53 
54 /*
55  * Device reports its bInterval as linear frames instead of the
56  * USB 2.0 calculation.
57  */
58 #define USB_QUIRK_LINEAR_FRAME_INTR_BINTERVAL	BIT(11)
59 
60 /*
61  * Device needs to be disconnected before suspend to prevent spurious
62  * wakeup.
63  */
64 #define USB_QUIRK_DISCONNECT_SUSPEND		BIT(12)
65 
66 /* Device needs a pause after every control message. */
67 #define USB_QUIRK_DELAY_CTRL_MSG		BIT(13)
68 
69 /* Hub needs extra delay after resetting its port. */
70 #define USB_QUIRK_HUB_SLOW_RESET		BIT(14)
71 
72 /* device has endpoints that should be ignored */
73 #define USB_QUIRK_ENDPOINT_IGNORE		BIT(15)
74 
75 #endif /* __LINUX_USB_QUIRKS_H */
76