1 /* SPDX-License-Identifier: GPL-2.0 */
2 #ifndef LINUX_B43_PHY_G_H_
3 #define LINUX_B43_PHY_G_H_
4
5 /* OFDM PHY registers are defined in the A-PHY header. */
6 #include "phy_a.h"
7
8 /* CCK (B) PHY Registers */
9 #define B43_PHY_VERSION_CCK B43_PHY_CCK(0x00) /* Versioning register for B-PHY */
10 #define B43_PHY_CCKBBANDCFG B43_PHY_CCK(0x01) /* Contains antenna 0/1 control bit */
11 #define B43_PHY_PGACTL B43_PHY_CCK(0x15) /* PGA control */
12 #define B43_PHY_PGACTL_LPF 0x1000 /* Low pass filter (?) */
13 #define B43_PHY_PGACTL_LOWBANDW 0x0040 /* Low bandwidth flag */
14 #define B43_PHY_PGACTL_UNKNOWN 0xEFA0
15 #define B43_PHY_FBCTL1 B43_PHY_CCK(0x18) /* Frequency bandwidth control 1 */
16 #define B43_PHY_ITSSI B43_PHY_CCK(0x29) /* Idle TSSI */
17 #define B43_PHY_LO_LEAKAGE B43_PHY_CCK(0x2D) /* Measured LO leakage */
18 #define B43_PHY_ENERGY B43_PHY_CCK(0x33) /* Energy */
19 #define B43_PHY_SYNCCTL B43_PHY_CCK(0x35)
20 #define B43_PHY_FBCTL2 B43_PHY_CCK(0x38) /* Frequency bandwidth control 2 */
21 #define B43_PHY_DACCTL B43_PHY_CCK(0x60) /* DAC control */
22 #define B43_PHY_RCCALOVER B43_PHY_CCK(0x78) /* RC calibration override */
23
24 /* Extended G-PHY Registers */
25 #define B43_PHY_CLASSCTL B43_PHY_EXTG(0x02) /* Classify control */
26 #define B43_PHY_GTABCTL B43_PHY_EXTG(0x03) /* G-PHY table control (see below) */
27 #define B43_PHY_GTABOFF 0x03FF /* G-PHY table offset (see below) */
28 #define B43_PHY_GTABNR 0xFC00 /* G-PHY table number (see below) */
29 #define B43_PHY_GTABNR_SHIFT 10
30 #define B43_PHY_GTABDATA B43_PHY_EXTG(0x04) /* G-PHY table data */
31 #define B43_PHY_LO_MASK B43_PHY_EXTG(0x0F) /* Local Oscillator control mask */
32 #define B43_PHY_LO_CTL B43_PHY_EXTG(0x10) /* Local Oscillator control */
33 #define B43_PHY_RFOVER B43_PHY_EXTG(0x11) /* RF override */
34 #define B43_PHY_RFOVERVAL B43_PHY_EXTG(0x12) /* RF override value */
35 #define B43_PHY_RFOVERVAL_EXTLNA 0x8000
36 #define B43_PHY_RFOVERVAL_LNA 0x7000
37 #define B43_PHY_RFOVERVAL_LNA_SHIFT 12
38 #define B43_PHY_RFOVERVAL_PGA 0x0F00
39 #define B43_PHY_RFOVERVAL_PGA_SHIFT 8
40 #define B43_PHY_RFOVERVAL_UNK 0x0010 /* Unknown, always set. */
41 #define B43_PHY_RFOVERVAL_TRSWRX 0x00E0
42 #define B43_PHY_RFOVERVAL_BW 0x0003 /* Bandwidth flags */
43 #define B43_PHY_RFOVERVAL_BW_LPF 0x0001 /* Low Pass Filter */
44 #define B43_PHY_RFOVERVAL_BW_LBW 0x0002 /* Low Bandwidth (when set), high when unset */
45 #define B43_PHY_ANALOGOVER B43_PHY_EXTG(0x14) /* Analog override */
46 #define B43_PHY_ANALOGOVERVAL B43_PHY_EXTG(0x15) /* Analog override value */
47
48
49 /*** G-PHY table numbers */
50 #define B43_GTAB(number, offset) (((number) << B43_PHY_GTABNR_SHIFT) | (offset))
51 #define B43_GTAB_NRSSI B43_GTAB(0x00, 0)
52 #define B43_GTAB_TRFEMW B43_GTAB(0x0C, 0x120)
53 #define B43_GTAB_ORIGTR B43_GTAB(0x2E, 0x298)
54
55 u16 b43_gtab_read(struct b43_wldev *dev, u16 table, u16 offset);
56 void b43_gtab_write(struct b43_wldev *dev, u16 table, u16 offset, u16 value);
57
58
59 /* Returns the boolean whether "TX Magnification" is enabled. */
60 #define has_tx_magnification(phy) \
61 (((phy)->rev >= 2) && \
62 ((phy)->radio_ver == 0x2050) && \
63 ((phy)->radio_rev == 8))
64 /* Card uses the loopback gain stuff */
65 #define has_loopback_gain(phy) \
66 (((phy)->rev > 1) || ((phy)->gmode))
67
68 /* Radio Attenuation (RF Attenuation) */
69 struct b43_rfatt {
70 u8 att; /* Attenuation value */
71 bool with_padmix; /* Flag, PAD Mixer enabled. */
72 };
73 struct b43_rfatt_list {
74 /* Attenuation values list */
75 const struct b43_rfatt *list;
76 u8 len;
77 /* Minimum/Maximum attenuation values */
78 u8 min_val;
79 u8 max_val;
80 };
81
82 /* Returns true, if the values are the same. */
b43_compare_rfatt(const struct b43_rfatt * a,const struct b43_rfatt * b)83 static inline bool b43_compare_rfatt(const struct b43_rfatt *a,
84 const struct b43_rfatt *b)
85 {
86 return ((a->att == b->att) &&
87 (a->with_padmix == b->with_padmix));
88 }
89
90 /* Baseband Attenuation */
91 struct b43_bbatt {
92 u8 att; /* Attenuation value */
93 };
94 struct b43_bbatt_list {
95 /* Attenuation values list */
96 const struct b43_bbatt *list;
97 u8 len;
98 /* Minimum/Maximum attenuation values */
99 u8 min_val;
100 u8 max_val;
101 };
102
103 /* Returns true, if the values are the same. */
b43_compare_bbatt(const struct b43_bbatt * a,const struct b43_bbatt * b)104 static inline bool b43_compare_bbatt(const struct b43_bbatt *a,
105 const struct b43_bbatt *b)
106 {
107 return (a->att == b->att);
108 }
109
110 /* tx_control bits. */
111 #define B43_TXCTL_PA3DB 0x40 /* PA Gain 3dB */
112 #define B43_TXCTL_PA2DB 0x20 /* PA Gain 2dB */
113 #define B43_TXCTL_TXMIX 0x10 /* TX Mixer Gain */
114
115 struct b43_txpower_lo_control;
116
117 struct b43_phy_g {
118 /* ACI (adjacent channel interference) flags. */
119 bool aci_enable;
120 bool aci_wlan_automatic;
121 bool aci_hw_rssi;
122
123 /* Radio switched on/off */
124 bool radio_on;
125 struct {
126 /* Values saved when turning the radio off.
127 * They are needed when turning it on again. */
128 bool valid;
129 u16 rfover;
130 u16 rfoverval;
131 } radio_off_context;
132
133 u16 minlowsig[2];
134 u16 minlowsigpos[2];
135
136 /* Pointer to the table used to convert a
137 * TSSI value to dBm-Q5.2 */
138 const s8 *tssi2dbm;
139 /* tssi2dbm is kmalloc()ed. Only used for free()ing. */
140 bool dyn_tssi_tbl;
141 /* Target idle TSSI */
142 int tgt_idle_tssi;
143 /* Current idle TSSI */
144 int cur_idle_tssi;
145 /* The current average TSSI. */
146 u8 average_tssi;
147 /* Current TX power level attenuation control values */
148 struct b43_bbatt bbatt;
149 struct b43_rfatt rfatt;
150 u8 tx_control; /* B43_TXCTL_XXX */
151 /* The calculated attenuation deltas that are used later
152 * when adjusting the actual power output. */
153 int bbatt_delta;
154 int rfatt_delta;
155
156 /* LocalOscillator control values. */
157 struct b43_txpower_lo_control *lo_control;
158 /* Values from b43_calc_loopback_gain() */
159 s16 max_lb_gain; /* Maximum Loopback gain in hdB */
160 s16 trsw_rx_gain; /* TRSW RX gain in hdB */
161 s16 lna_lod_gain; /* LNA lod */
162 s16 lna_gain; /* LNA */
163 s16 pga_gain; /* PGA */
164
165 /* Current Interference Mitigation mode */
166 int interfmode;
167 /* Stack of saved values from the Interference Mitigation code.
168 * Each value in the stack is laid out as follows:
169 * bit 0-11: offset
170 * bit 12-15: register ID
171 * bit 16-32: value
172 * register ID is: 0x1 PHY, 0x2 Radio, 0x3 ILT
173 */
174 #define B43_INTERFSTACK_SIZE 26
175 u32 interfstack[B43_INTERFSTACK_SIZE]; //FIXME: use a data structure
176
177 /* Saved values from the NRSSI Slope calculation */
178 s16 nrssi[2];
179 s32 nrssislope;
180 /* In memory nrssi lookup table. */
181 s8 nrssi_lt[64];
182
183 u16 lofcal;
184
185 u16 initval; //FIXME rename?
186
187 /* The device does address auto increment for the OFDM tables.
188 * We cache the previously used address here and omit the address
189 * write on the next table access, if possible. */
190 u16 ofdmtab_addr; /* The address currently set in hardware. */
191 enum { /* The last data flow direction. */
192 B43_OFDMTAB_DIRECTION_UNKNOWN = 0,
193 B43_OFDMTAB_DIRECTION_READ,
194 B43_OFDMTAB_DIRECTION_WRITE,
195 } ofdmtab_addr_direction;
196 };
197
198 void b43_gphy_set_baseband_attenuation(struct b43_wldev *dev,
199 u16 baseband_attenuation);
200 void b43_gphy_channel_switch(struct b43_wldev *dev,
201 unsigned int channel,
202 bool synthetic_pu_workaround);
203 u8 * b43_generate_dyn_tssi2dbm_tab(struct b43_wldev *dev,
204 s16 pab0, s16 pab1, s16 pab2);
205
206 struct b43_phy_operations;
207 extern const struct b43_phy_operations b43_phyops_g;
208
209 #endif /* LINUX_B43_PHY_G_H_ */
210