1 #ifndef LINUX_B43_PHY_G_H_
2 #define LINUX_B43_PHY_G_H_
3
4 /* OFDM PHY registers are defined in the A-PHY header. */
5 #include "phy_a.h"
6
7 /* CCK (B) PHY Registers */
8 #define B43_PHY_VERSION_CCK B43_PHY_CCK(0x00) /* Versioning register for B-PHY */
9 #define B43_PHY_CCKBBANDCFG B43_PHY_CCK(0x01) /* Contains antenna 0/1 control bit */
10 #define B43_PHY_PGACTL B43_PHY_CCK(0x15) /* PGA control */
11 #define B43_PHY_PGACTL_LPF 0x1000 /* Low pass filter (?) */
12 #define B43_PHY_PGACTL_LOWBANDW 0x0040 /* Low bandwidth flag */
13 #define B43_PHY_PGACTL_UNKNOWN 0xEFA0
14 #define B43_PHY_FBCTL1 B43_PHY_CCK(0x18) /* Frequency bandwidth control 1 */
15 #define B43_PHY_ITSSI B43_PHY_CCK(0x29) /* Idle TSSI */
16 #define B43_PHY_LO_LEAKAGE B43_PHY_CCK(0x2D) /* Measured LO leakage */
17 #define B43_PHY_ENERGY B43_PHY_CCK(0x33) /* Energy */
18 #define B43_PHY_SYNCCTL B43_PHY_CCK(0x35)
19 #define B43_PHY_FBCTL2 B43_PHY_CCK(0x38) /* Frequency bandwidth control 2 */
20 #define B43_PHY_DACCTL B43_PHY_CCK(0x60) /* DAC control */
21 #define B43_PHY_RCCALOVER B43_PHY_CCK(0x78) /* RC calibration override */
22
23 /* Extended G-PHY Registers */
24 #define B43_PHY_CLASSCTL B43_PHY_EXTG(0x02) /* Classify control */
25 #define B43_PHY_GTABCTL B43_PHY_EXTG(0x03) /* G-PHY table control (see below) */
26 #define B43_PHY_GTABOFF 0x03FF /* G-PHY table offset (see below) */
27 #define B43_PHY_GTABNR 0xFC00 /* G-PHY table number (see below) */
28 #define B43_PHY_GTABNR_SHIFT 10
29 #define B43_PHY_GTABDATA B43_PHY_EXTG(0x04) /* G-PHY table data */
30 #define B43_PHY_LO_MASK B43_PHY_EXTG(0x0F) /* Local Oscillator control mask */
31 #define B43_PHY_LO_CTL B43_PHY_EXTG(0x10) /* Local Oscillator control */
32 #define B43_PHY_RFOVER B43_PHY_EXTG(0x11) /* RF override */
33 #define B43_PHY_RFOVERVAL B43_PHY_EXTG(0x12) /* RF override value */
34 #define B43_PHY_RFOVERVAL_EXTLNA 0x8000
35 #define B43_PHY_RFOVERVAL_LNA 0x7000
36 #define B43_PHY_RFOVERVAL_LNA_SHIFT 12
37 #define B43_PHY_RFOVERVAL_PGA 0x0F00
38 #define B43_PHY_RFOVERVAL_PGA_SHIFT 8
39 #define B43_PHY_RFOVERVAL_UNK 0x0010 /* Unknown, always set. */
40 #define B43_PHY_RFOVERVAL_TRSWRX 0x00E0
41 #define B43_PHY_RFOVERVAL_BW 0x0003 /* Bandwidth flags */
42 #define B43_PHY_RFOVERVAL_BW_LPF 0x0001 /* Low Pass Filter */
43 #define B43_PHY_RFOVERVAL_BW_LBW 0x0002 /* Low Bandwidth (when set), high when unset */
44 #define B43_PHY_ANALOGOVER B43_PHY_EXTG(0x14) /* Analog override */
45 #define B43_PHY_ANALOGOVERVAL B43_PHY_EXTG(0x15) /* Analog override value */
46
47
48 /*** G-PHY table numbers */
49 #define B43_GTAB(number, offset) (((number) << B43_PHY_GTABNR_SHIFT) | (offset))
50 #define B43_GTAB_NRSSI B43_GTAB(0x00, 0)
51 #define B43_GTAB_TRFEMW B43_GTAB(0x0C, 0x120)
52 #define B43_GTAB_ORIGTR B43_GTAB(0x2E, 0x298)
53
54 u16 b43_gtab_read(struct b43_wldev *dev, u16 table, u16 offset);
55 void b43_gtab_write(struct b43_wldev *dev, u16 table, u16 offset, u16 value);
56
57
58 /* Returns the boolean whether "TX Magnification" is enabled. */
59 #define has_tx_magnification(phy) \
60 (((phy)->rev >= 2) && \
61 ((phy)->radio_ver == 0x2050) && \
62 ((phy)->radio_rev == 8))
63 /* Card uses the loopback gain stuff */
64 #define has_loopback_gain(phy) \
65 (((phy)->rev > 1) || ((phy)->gmode))
66
67 /* Radio Attenuation (RF Attenuation) */
68 struct b43_rfatt {
69 u8 att; /* Attenuation value */
70 bool with_padmix; /* Flag, PAD Mixer enabled. */
71 };
72 struct b43_rfatt_list {
73 /* Attenuation values list */
74 const struct b43_rfatt *list;
75 u8 len;
76 /* Minimum/Maximum attenuation values */
77 u8 min_val;
78 u8 max_val;
79 };
80
81 /* Returns true, if the values are the same. */
b43_compare_rfatt(const struct b43_rfatt * a,const struct b43_rfatt * b)82 static inline bool b43_compare_rfatt(const struct b43_rfatt *a,
83 const struct b43_rfatt *b)
84 {
85 return ((a->att == b->att) &&
86 (a->with_padmix == b->with_padmix));
87 }
88
89 /* Baseband Attenuation */
90 struct b43_bbatt {
91 u8 att; /* Attenuation value */
92 };
93 struct b43_bbatt_list {
94 /* Attenuation values list */
95 const struct b43_bbatt *list;
96 u8 len;
97 /* Minimum/Maximum attenuation values */
98 u8 min_val;
99 u8 max_val;
100 };
101
102 /* Returns true, if the values are the same. */
b43_compare_bbatt(const struct b43_bbatt * a,const struct b43_bbatt * b)103 static inline bool b43_compare_bbatt(const struct b43_bbatt *a,
104 const struct b43_bbatt *b)
105 {
106 return (a->att == b->att);
107 }
108
109 /* tx_control bits. */
110 #define B43_TXCTL_PA3DB 0x40 /* PA Gain 3dB */
111 #define B43_TXCTL_PA2DB 0x20 /* PA Gain 2dB */
112 #define B43_TXCTL_TXMIX 0x10 /* TX Mixer Gain */
113
114 struct b43_txpower_lo_control;
115
116 struct b43_phy_g {
117 /* ACI (adjacent channel interference) flags. */
118 bool aci_enable;
119 bool aci_wlan_automatic;
120 bool aci_hw_rssi;
121
122 /* Radio switched on/off */
123 bool radio_on;
124 struct {
125 /* Values saved when turning the radio off.
126 * They are needed when turning it on again. */
127 bool valid;
128 u16 rfover;
129 u16 rfoverval;
130 } radio_off_context;
131
132 u16 minlowsig[2];
133 u16 minlowsigpos[2];
134
135 /* Pointer to the table used to convert a
136 * TSSI value to dBm-Q5.2 */
137 const s8 *tssi2dbm;
138 /* tssi2dbm is kmalloc()ed. Only used for free()ing. */
139 bool dyn_tssi_tbl;
140 /* Target idle TSSI */
141 int tgt_idle_tssi;
142 /* Current idle TSSI */
143 int cur_idle_tssi;
144 /* The current average TSSI. */
145 u8 average_tssi;
146 /* Current TX power level attenuation control values */
147 struct b43_bbatt bbatt;
148 struct b43_rfatt rfatt;
149 u8 tx_control; /* B43_TXCTL_XXX */
150 /* The calculated attenuation deltas that are used later
151 * when adjusting the actual power output. */
152 int bbatt_delta;
153 int rfatt_delta;
154
155 /* LocalOscillator control values. */
156 struct b43_txpower_lo_control *lo_control;
157 /* Values from b43_calc_loopback_gain() */
158 s16 max_lb_gain; /* Maximum Loopback gain in hdB */
159 s16 trsw_rx_gain; /* TRSW RX gain in hdB */
160 s16 lna_lod_gain; /* LNA lod */
161 s16 lna_gain; /* LNA */
162 s16 pga_gain; /* PGA */
163
164 /* Current Interference Mitigation mode */
165 int interfmode;
166 /* Stack of saved values from the Interference Mitigation code.
167 * Each value in the stack is laid out as follows:
168 * bit 0-11: offset
169 * bit 12-15: register ID
170 * bit 16-32: value
171 * register ID is: 0x1 PHY, 0x2 Radio, 0x3 ILT
172 */
173 #define B43_INTERFSTACK_SIZE 26
174 u32 interfstack[B43_INTERFSTACK_SIZE]; //FIXME: use a data structure
175
176 /* Saved values from the NRSSI Slope calculation */
177 s16 nrssi[2];
178 s32 nrssislope;
179 /* In memory nrssi lookup table. */
180 s8 nrssi_lt[64];
181
182 u16 lofcal;
183
184 u16 initval; //FIXME rename?
185
186 /* The device does address auto increment for the OFDM tables.
187 * We cache the previously used address here and omit the address
188 * write on the next table access, if possible. */
189 u16 ofdmtab_addr; /* The address currently set in hardware. */
190 enum { /* The last data flow direction. */
191 B43_OFDMTAB_DIRECTION_UNKNOWN = 0,
192 B43_OFDMTAB_DIRECTION_READ,
193 B43_OFDMTAB_DIRECTION_WRITE,
194 } ofdmtab_addr_direction;
195 };
196
197 void b43_gphy_set_baseband_attenuation(struct b43_wldev *dev,
198 u16 baseband_attenuation);
199 void b43_gphy_channel_switch(struct b43_wldev *dev,
200 unsigned int channel,
201 bool synthetic_pu_workaround);
202 u8 * b43_generate_dyn_tssi2dbm_tab(struct b43_wldev *dev,
203 s16 pab0, s16 pab1, s16 pab2);
204
205 struct b43_phy_operations;
206 extern const struct b43_phy_operations b43_phyops_g;
207
208 #endif /* LINUX_B43_PHY_G_H_ */
209