102 		hw_dbg(hw, "Device %x does not support flow control autoneg\n",  in ixgbe_device_supports_autoneg_fc()
126 		hw_dbg(hw, "ixgbe_fc_rx_pause not valid in strict IEEE mode\n");  in ixgbe_setup_fc_generic()
217 		hw_dbg(hw, "Flow control param set incorrectly\n");  in ixgbe_setup_fc_generic()
234 		hw_dbg(hw, "Set up FC; PCS1GLCTL = 0x%08X\n", reg);  in ixgbe_setup_fc_generic()
257 	hw_dbg(hw, "Set up FC; IXGBE_AUTOC = 0x%08X\n", reg);  in ixgbe_setup_fc_generic()
502 		hw_dbg(hw, "PBA string buffer was null\n");  in ixgbe_read_pba_string_generic()
508 		hw_dbg(hw, "NVM Read Error\n");  in ixgbe_read_pba_string_generic()
514 		hw_dbg(hw, "NVM Read Error\n");  in ixgbe_read_pba_string_generic()
524 		hw_dbg(hw, "NVM PBA number is not stored as string\n");  in ixgbe_read_pba_string_generic()
528 			hw_dbg(hw, "PBA string buffer too small\n");  in ixgbe_read_pba_string_generic()
560 		hw_dbg(hw, "NVM Read Error\n");  in ixgbe_read_pba_string_generic()
565 		hw_dbg(hw, "NVM PBA number section invalid length\n");  in ixgbe_read_pba_string_generic()
571 		hw_dbg(hw, "PBA string buffer too small\n");  in ixgbe_read_pba_string_generic()
582 			hw_dbg(hw, "NVM Read Error\n");  in ixgbe_read_pba_string_generic()
883 		hw_dbg(hw, "Eeprom params: type = %d, size = %d, address bits: %d\n",  in ixgbe_init_eeprom_params_generic()
1185 			hw_dbg(hw, "Eeprom read timed out\n");  in ixgbe_read_eerd_buffer_generic()
1229 	hw_dbg(hw, "Detected EEPROM page size = %d words.\n",  in ixgbe_detect_eeprom_page_size_generic()
1278 			hw_dbg(hw, "Eeprom write EEWR timed out\n");  in ixgbe_write_eewr_buffer_generic()
1286 			hw_dbg(hw, "Eeprom write EEWR timed out\n");  in ixgbe_write_eewr_buffer_generic()
1366 		hw_dbg(hw, "Could not acquire EEPROM grant\n");  in ixgbe_acquire_eeprom()
1406 		hw_dbg(hw, "Driver can't access the Eeprom - SMBI Semaphore not granted.\n");  in ixgbe_get_eeprom_semaphore()
1421 			hw_dbg(hw, "Software semaphore SMBI between device drivers not granted.\n");  in ixgbe_get_eeprom_semaphore()
1448 		hw_dbg(hw, "SWESMBI Software EEPROM semaphore not granted.\n");  in ixgbe_get_eeprom_semaphore()
1505 		hw_dbg(hw, "SPI EEPROM Status error\n");  in ixgbe_ready_eeprom()
1708 			hw_dbg(hw, "EEPROM read failed\n");  in ixgbe_calc_eeprom_checksum_generic()
1717 			hw_dbg(hw, "EEPROM read failed\n");  in ixgbe_calc_eeprom_checksum_generic()
1726 			hw_dbg(hw, "EEPROM read failed\n");  in ixgbe_calc_eeprom_checksum_generic()
1735 				hw_dbg(hw, "EEPROM read failed\n");  in ixgbe_calc_eeprom_checksum_generic()
1769 		hw_dbg(hw, "EEPROM read failed\n");  in ixgbe_validate_eeprom_checksum_generic()
1781 		hw_dbg(hw, "EEPROM read failed\n");  in ixgbe_validate_eeprom_checksum_generic()
1814 		hw_dbg(hw, "EEPROM read failed\n");  in ixgbe_update_eeprom_checksum_generic()
1847 		hw_dbg(hw, "RAR index %d is out of range.\n", index);  in ixgbe_set_rar_generic()
1899 		hw_dbg(hw, "RAR index %d is out of range.\n", index);  in ixgbe_clear_rar_generic()
1947 		hw_dbg(hw, " Keeping Current RAR0 Addr =%pM\n", hw->mac.addr);  in ixgbe_init_rx_addrs_generic()
1950 		hw_dbg(hw, "Overriding MAC Address in RAR[0]\n");  in ixgbe_init_rx_addrs_generic()
1951 		hw_dbg(hw, " New MAC Addr =%pM\n", hw->mac.addr);  in ixgbe_init_rx_addrs_generic()
1964 	hw_dbg(hw, "Clearing RAR[1-%d]\n", rar_entries - 1);  in ixgbe_init_rx_addrs_generic()
1974 	hw_dbg(hw, " Clearing MTA\n");  in ixgbe_init_rx_addrs_generic()
2014 		hw_dbg(hw, "MC filter type param set incorrectly\n");  in ixgbe_mta_vector()
2039 	hw_dbg(hw, " bit-vector = 0x%03X\n", vector);  in ixgbe_set_mta()
2079 	hw_dbg(hw, " Clearing MTA\n");  in ixgbe_update_mc_addr_list_generic()
2084 		hw_dbg(hw, " Adding the multicast addresses:\n");  in ixgbe_update_mc_addr_list_generic()
2097 	hw_dbg(hw, "ixgbe_update_mc_addr_list_generic Complete\n");  in ixgbe_update_mc_addr_list_generic()
2157 				hw_dbg(hw, "Invalid water mark configuration\n");  in ixgbe_fc_enable_generic()
2214 		hw_dbg(hw, "Flow control param set incorrectly\n");  in ixgbe_fc_enable_generic()
2284 			hw_dbg(hw, "Flow Control = FULL.\n");  in ixgbe_negotiate_fc()
2287 			hw_dbg(hw, "Flow Control=RX PAUSE frames only\n");  in ixgbe_negotiate_fc()
2292 		hw_dbg(hw, "Flow Control = TX PAUSE frames only.\n");  in ixgbe_negotiate_fc()
2296 		hw_dbg(hw, "Flow Control = RX PAUSE frames only.\n");  in ixgbe_negotiate_fc()
2299 		hw_dbg(hw, "Flow Control = NONE.\n");  in ixgbe_negotiate_fc()
2532 		hw_dbg(hw, "GIO disable did not set - requesting resets\n");  in ixgbe_disable_pcie_primary()
2556 	hw_dbg(hw, "GIO Primary Disable bit didn't clear - requesting resets\n");  in ixgbe_disable_pcie_primary()
2577 	hw_dbg(hw, "PCIe transaction pending bit also did not clear.\n");  in ixgbe_disable_pcie_primary()
2704 		hw_dbg(hw, "Rx unit being enabled before security path fully disabled. Continuing with init.\n");  in ixgbe_disable_rx_buff_generic()
2965 		hw_dbg(hw, "RAR index %d is out of range.\n", rar);  in ixgbe_clear_vmdq_generic()
3016 		hw_dbg(hw, "RAR index %d is out of range.\n", rar);  in ixgbe_set_vmdq_generic()
3116 		hw_dbg(hw, "No space in VLVF.\n");  in ixgbe_find_vlvf_slot()
3333 		hw_dbg(hw, "LINKS changed from %08X to %08X\n",  in ixgbe_check_mac_link_generic()
3611 		hw_dbg(hw, "Buffer length failure buffersize-%d.\n", length);  in ixgbe_hic_unlocked()
3622 		hw_dbg(hw, "IXGBE_HOST_EN bit disabled.\n");  in ixgbe_hic_unlocked()
3628 		hw_dbg(hw, "Buffer length failure, not aligned to dword");  in ixgbe_hic_unlocked()
3688 		hw_dbg(hw, "Buffer length failure buffersize-%d.\n", length);  in ixgbe_host_interface_command()
3718 		hw_dbg(hw, "Buffer not large enough for reply message.\n");  in ixgbe_host_interface_command()
4228 			hw_dbg(hw, "Unexpected media type\n");  in ixgbe_setup_mac_link_multispeed_fiber()
4279 			hw_dbg(hw, "Unexpected media type\n");  in ixgbe_setup_mac_link_multispeed_fiber()
4353 		hw_dbg(hw, "Invalid fixed module speed\n");  in ixgbe_set_soft_rate_select_speed()
4362 		hw_dbg(hw, "Failed to read Rx Rate Select RS0\n");  in ixgbe_set_soft_rate_select_speed()
4372 		hw_dbg(hw, "Failed to write Rx Rate Select RS0\n");  in ixgbe_set_soft_rate_select_speed()
4381 		hw_dbg(hw, "Failed to read Rx Rate Select RS1\n");  in ixgbe_set_soft_rate_select_speed()
4391 		hw_dbg(hw, "Failed to write Rx Rate Select RS1\n");  in ixgbe_set_soft_rate_select_speed()