Lines Matching refs:MAC
364 the same MAC address at enslavement (the traditional
366 bond's MAC address in accordance with the selected policy.
374 the same MAC address at enslavement time. This is the
380 MAC address of the bond should always be the MAC
381 address of the currently active slave. The MAC
382 address of the slaves is not changed; instead, the MAC
386 alter their MAC address, or for devices that refuse
387 incoming broadcasts with their own source MAC (which
407 The "follow" fail_over_mac policy causes the MAC
409 the MAC address of the first slave added to the bond).
411 to this MAC address while they are in a backup role; a
412 slave is programmed with the bond's MAC address at
414 the newly active slave's MAC address).
418 when multiple ports are programmed with the same MAC
423 change its MAC address, in which case the active policy is
497 if, the active slave fails. The bond's MAC address is
518 MAC address XOR'd with destination MAC address) modulo
566 takes over the MAC address of the failed receiving
611 with the selected MAC address to each of the
739 Uses XOR of hardware MAC addresses to generate the
742 (source MAC XOR destination MAC) modulo slave count
754 Uses XOR of hardware MAC addresses and IP addresses to
758 ( source MAC XOR destination MAC ))
892 the device's permanent MAC address.
896 devices (the MAC addresses correspond to those of the slave devices).
1562 bond0 have the same MAC address (HWaddr) as bond0 for all modes except
1563 TLB and ALB that require a unique MAC address for each slave.
1613 policy to the bond. Typical choices include XOR of either the MAC or
2096 the bonded device will be to the same MAC level peer on the network
2100 will be addressed directly by their individual MAC addresses.
2104 available use the MAC addresses of the local network source and
2143 (instead choosing a port based upon IP or MAC level addresses);
2169 interface. Since the destination is determined by the MAC
2199 distributes traffic by peer (using an XOR of MAC addresses),
2211 Since the balancing is done according to MAC address, in a
2217 so that mathematically unlucky MAC addresses (i.e., ones that
2371 is a side effect of how many switches update their MAC forwarding
2372 tables. Initially, the switch does not associate the MAC address in
2374 traffic to all ports until its MAC forwarding table is updated. Since
2382 behavior, it can be induced by clearing the MAC forwarding table (on
2569 8. Where does a bonding device get its MAC address from?
2571 When using slave devices that have fixed MAC addresses, or when
2572 the fail_over_mac option is enabled, the bonding device's MAC address is
2573 the MAC address of the active slave.
2576 ifconfig or ip link), the MAC address of the bonding device is taken from
2577 its first slave device. This MAC address is then passed to all following
2581 If you wish to change the MAC address, you can set it with
2588 The MAC address can be also changed by bringing down/up the
2598 To restore your slaves' MAC addresses, you need to detach them
2600 then restore the MAC addresses that the slaves had before they were