Lines Matching refs:boot
49 10.3 PCI configuration fix-up boot option
50 10.4 Serial NVRAM support boot option
51 10.5 SCSI BUS checking boot option
245 depths from the boot command-line. For example:
275 1st method: boot your system using 'sym53c8xx=verb:0' option.
277 corresponding to your controller after boot-up.
285 checking by entering appropriate options from the boot command line.
380 th driver verbose level after boot-up.
406 this feature after boot-up only for devices that support it safely.
416 This parameter can be specified from the boot command line.
424 will use at boot time for synchronous data transfer negotiations.
431 Setup commands can be passed to the driver either at boot time or as a
434 A boot setup command for this driver begins with the driver name "sym53c8xx=".
438 Example of boot setup command under lilo prompt:
574 0x08 ignore NVRAM "Scan at boot time" parameter for all devices
597 any value suggested as boot option. Otherwise, if a suggested value
602 10.3 PCI configuration fix-up boot option
624 10.4 Serial NVRAM support boot option
645 Verbose boot messages N Y
651 Scan at boot time N Y
653 In order to speed up the system boot, for each device configured without
654 the "scan at boot time" option, the driver forces an error on the
657 Some SDMS BIOS revisions seem to be unable to boot cleanly with very fast
661 The 'nvram' boot option can be entered in hexadecimal form in order
668 0x08 ignore NVRAM "Scan at boot time" parameter for all devices
675 10.5 SCSI BUS checking boot option.
807 The Symbios NVRAM also holds data on the boot order of host adaptors in a
814 NVRAM boot order settings can do this as well as change the order the same
904 boot configuration - 56 bytes (4x14 bytes)
934 0x00000100 verbose boot msgs
942 boot configuration
944 boot order set by order of the devices in this table
952 | | | | | --0x01 init/scan at boot time
996 0x00000010 - scan at boot time
1101 as BIOS dev 1 - boot device
1108 | | | --------- boot delay 0 - 3 sec