Lines Matching refs:controllers
6 SCSI controllers and chipsets. Major portions of the driver and driver
80 AHA-394x - PCI controllers with two separate SCSI controllers on-board.
81 AHA-398x - PCI RAID controllers with three separate SCSI controllers
104 a totally separate beast from the bare SCSI controllers and this driver
176 based controllers. On these controllers, 0 is for Edge triggered
205 based 2842 controllers and any EISA based controllers. This is
249 termination on your SCSI controllers to a particular setting. This
259 controllers. Futhermore, due to the current Ultra2 controller
263 an artifact of the BIOS definition on Ultra2 controllers. For other
264 controllers, the only important bits are the two lowest bits. Setting
265 the higher bits on non-Ultra2 controllers has no effect. A few
317 initial DEVCONFIG values for each of your aic7xxx controllers as
319 the proper termination on your controllers. NOTE: the order in
321 to be the same order as the SCSI controllers are registered. The
323 controllers as they are registered, so make sure you match the right
324 DEVCONFIG values with the right controllers if you have more than
329 termination on each of the controllers *should* be. Hopefully, that
332 If all the controllers have the correct termination settings, then
334 Next, on any controllers that go into an infinite reset loop when
339 controllers that didn't have an infinite reset problem, then reverse