Lines Matching refs:controllers
6 SCSI controllers and chipsets. Major portions of the driver and driver
22 chipsets. In general, this means *all* of the Adaptec SCSI controllers
48 AHA-39xx - PCI controllers with multiple separate SCSI channels on-board.
70 a totally separate beast from the bare SCSI controllers and this driver
142 based controllers. On these controllers, 0 is for Edge triggered
171 based 2842 controllers and any EISA based controllers. This is
215 termination on your SCSI controllers to a particular setting. This
225 controllers. Futhermore, due to the current Ultra2 controller
229 an artifact of the BIOS definition on Ultra2 controllers. For other
230 controllers, the only important bits are the two lowest bits. Setting
231 the higher bits on non-Ultra2 controllers has no effect. A few
283 initial DEVCONFIG values for each of your aic7xxx controllers as
285 the proper termination on your controllers. NOTE: the order in
287 to be the same order as the SCSI controllers are registered. The
289 controllers as they are registered, so make sure you match the right
290 DEVCONFIG values with the right controllers if you have more than
295 termination on each of the controllers *should* be. Hopefully, that
298 If all the controllers have the correct termination settings, then
300 Next, on any controllers that go into an infinite reset loop when
305 controllers that didn't have an infinite reset problem, then reverse