Lines Matching refs:use

40 should use the latest version.
58 All ISA, EISA and MCA boards that you want to use need to be configured into
61 configuration structure. Note that kernel PCI support is required to use PCI
67 the driver source to add configuration lines for each board in use.
71 pre-built driver modules in /lib/modules/X.Y.Z/misc for the kernel in use.
77 The simplest configuration for modules is to use the module load arguments
82 boards then use the "stallion" driver module, Otherwise if you are using
84 Brumby or original Stallion board then use the "istallion" driver module.
86 Typically to load up the smart board driver use:
97 To load the intelligent board driver use:
161 To set up the driver(s) for the boards that you want to use you need to
228 ISA and the Stallion boards can be programmed to use memory addresses up to
301 access the serial ports. The simplest method is to use the stallion utility
311 be able to use Stallion board ports and COM ports interchangeably without
330 If you are unfamiliar with how to use serial ports, then get the Serial-HOWTO
337 You can use both drivers at once if you have a mix of board types installed
339 used by one of the drivers. Currently both drivers use major numbers 24, 25
340 and 28 for their devices. Change one driver to use some other major numbers,
342 major numbers. For example, you could change the istallion.c driver to use
361 Both the ONboard and old Stallion boards can use higher memory addresses as
362 well, but you must have less than 16Mb of RAM to be able to use them. Usual
373 them can be used then the high memory support to use the really high address
379 ports you should only use the cueX devices.
392 Pty. Ltd. for its use, nor any infringements of patents or other rights
393 of third parties resulting from its use. Stallion Technologies reserves