Lines Matching refs:parameter

95 The default value for each parameter is generally the recommended setting,
117 This parameter is a bit-mask that specifies the speed and duplex settings
118 advertised by the adapter.  When this parameter is used, the Speed and
122        information on the AutoNeg parameter.
143 This parameter controls the automatic generation(Tx) and response(Rx)
275 (This parameter is supported only on 82540, 82545 and later adapters.)
289 (This parameter is supported only on adapters with copper connections.)
294 (Mbps).  If this parameter is not specified or is set to 0 and the link
328 (This parameter is supported only on 82540, 82545 and later adapters.)
341 (This parameter is NOT supported on the 82542-based adapter.)
357 This parameter is different than other parameters, in that it is a
358 single (not 1,1,1 etc.) parameter applied to all driver instances and
382   negotiation is disabled, and the AutoNeg parameter is ignored.  Partner
385 The AutoNeg parameter is used when more control is required over the
390 The parameter may be specified as either a decimal or hexadecimal value as
411 Note that when this parameter is used, Speed and Duplex must not be specified.
414 parameter should not be used.  Instead, use the Speed and Duplex parameters