Lines Matching refs:incoming

88                ATA      Answer incoming call.
224                                           an incoming call happened (RING) and
254                                   bit. In this case, on incoming calls
267                             Set on incoming call (during RING) to
271                             Set on incoming call (during RING) to
287   All inactive physical lines are listening to all EAZs for incoming
289   When an incoming call is detected, the driver looks first for a network
315   If an incoming call matches one network interface, it gets connected to it.
316   If another incoming call for the same EAZ arrives, which does not match
369       and the number(s) for incoming calls:
383         (neither incoming or outgoing connections are possible). Use
409       Then all incoming calls are logged, even if they are not addressed
426    Only incoming calls, for which the caller-id is listed in the access
430    incoming call, therefore you should configure it accordingly.
446    Switch the hang-up-timer for incoming calls on or off.
459    Switches an interface to callback-mode. In this mode, an incoming call
467    Sets the delay (default 5 sec) between an incoming call and start of
472    incoming call for an interface which is configured for callback.
535    If switched on, isdn4linux replies a REJECT to incoming calls, it
540    isdn4linux rejects an incoming call, which belongs to another device on