Lines Matching refs:an

60   A low-level-driver can register itself through an interface (which is
224                                           an incoming call happened (RING) and
289   When an incoming call is detected, the driver looks first for a network
290   interface and then for an opened tty which:
308   For an outgoing call, the inactive physical lines are searched.
315   If an incoming call matches one network interface, it gets connected to it.
352       an AT&W0 is performed on any ISDN-tty. If the file already exists,
356    d) For networking, continue: Create an interface:
394         isdn0". However, after an idle time of no traffic as configured for
413   Now you are ready! A ping to the set address should now result in an
419   don't give an interface name to addif, the  kernel will assign a name
429    Euro-ISDN does not transmit the leading '0' of the caller-id for an
449    Returns the EAZ of an interface.
459    Switches an interface to callback-mode. In this mode, an incoming call
467    Sets the delay (default 5 sec) between an incoming call and start of
471    This enables (default) or disables an active hangup (reject) when getting an
472    incoming call for an interface which is configured for callback.
476    only while an interface is down.
516    Shows all parameters of an interface and the charge-info.
520    Forces hangup of an interface.
540    isdn4linux rejects an incoming call, which belongs to another device on
554    This sets the minimum time an Interface has to be fully loaded, until
558    Forces an interface to start dialing even if no packets are to be
565    With this command, it's now possible to have an interface listening to
571    Here is an example: