Lines Matching refs:joystick

5 	$Id: joystick-parport.txt,v 1.5 2001/05/15 06:41:00 vojtech Exp $
12 happen include burning your parallel port, and/or the sticks and joystick
17   The joystick parport drivers are used for joysticks and gamepads not
48 for your pads, use either keyboard or joystick port, and make a pass-through
140 for joystick ports. They were all digital, and all used D-Cannon 9 pin
141 connectors (db9). Because of that, a single joystick could be used without
224 was written. It allows only one joystick / gamepad per parallel port, but
227   For the basic 1-button Multisystem joystick you connect its wires to the
239   However, if the joystick is switch based (eg. clicks when you move it),
258 the digital joystick driver 0.8.0.2, this is also supported by the db9.c
263   For some people just one joystick per parallel port is not enough, and/or
271 joystick can do more (eg. turbofire) you'll need to disable it totally first
289   And finally, you connect the Ground wire of the joystick, like done in
292 for each joystick. The power source is shared.
307 Steffen's version, there is support for up to 5 buttons per joystick.  However,
309 supports only one button per joystick. For more information on how to build the
342 Multisystem joystick. However, since they don't use switches and use TTL
451 	  4  | Multisystem 1-button joystick
452 	  5  | Multisystem 2-button joystick
476   'Type' is the type of joystick or pad attached:
481 	  1  | Multisystem 1-button joystick
482 	  2  | Multisystem 2-button joystick
487 	  8  | Multisystem 1-button joystick (v0.8.0.2 pin-out)
504 interface ports 1-7 have. For a standard multisystem joystick, this is 1.